REPAIR / REPLACEMENT OF CHAIN LINK FENCE AT GUEST HOUSE AND TECHNICAL AREA AT FIELD STAITION PITTHAORGARH

Amount

Contract Details

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion in natural ground and making good disturbed ground all as specified and directed.

Demolition of Concrete in ground floors and pavings exc 15 cm thickness (below or above ground level) all as specified and directed.

Excavating in post holes in hard/ dense soil (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, all as specified and directed.

M&L for Cement concrete (1:3:6) type C-2 as in in foundations, filling and mass concrete in post holes for holding of post/ poles all as specified and directed.

M&L for Providing reinforced cement concrete type B-l, 1:2:4 (20 mm graded ggregate) in precast posts, fencing posts, straining or terminal posts, struts etc. for fencing, average sectional area exc 100 and n exc 250 sqcm, with or without chamfered angles and flat, splayed, rounded or mitred tops as directed and fixed all as specified and directed by Engr-in-Charge. (Note : Cost for TMT bars, stirrups and form work are deemed to be inclusive in unit rate quoted by contractor).

S&F Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc.FI wind ties for roof or for holding fence with post including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 all as specified and directed.

M&L for Mild steel round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips all as specified and directed by Engr-in-Charge.

S&F Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) all a specified and directed by Engr-in-Charge.

Restraining resecuring including making good staples etc Galvanised. 2 strand, steel barbed wire of any type all as specified and directed by Engr-in-Charge.

S&F 4mm dia galvanised steel wire, 150x100mm mesh, made up into mattresses or cages, lapped, wired and laid in position, including closing after filling all as specified and directed by Engr-in-Charge.

Restraining resecuring and tightening opening flat iron nut & bolt including making good mashes etc Galvanised.wire mesh of any type or size all as specified and directed by Engr-in-Charge. (Note : Necessary unserviceable nut bolt will be replaces with new, and cost of the same is deemed to be inclusive in unit rates.)

S&F in repairs punched tape Concertina coil fence of 450mm dia electroplated coil jointed with Galvanized clips at two places at each turn all as specified and directed by Engr-in-Charge.

. - do- all as items No13 above but 600mm dia all as specified.

M&L for preparing new steel surfaces and applying two coats of SE Paint over a coat of Red oxide over 10cm width or girth all as specified and directed by Engr-in-Charge.

S&F in repairs framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work conforming to Fe.290.Gde-E-165 all as specified and directed by Engr-in-Charge.

M&L for preparing old steel painted surface exc 10cm width or girth and applying a coat of SE Paint all as specified and directed by Engr-in-Charge.

Note :-Tenderers may be noted that amount of credit will be deducted from the total amount arrived, at the time of Acceptance of contract.

M/s D K Sharma (BID ID -3219049)

M/S BHATT ENTERPRISES (BID ID -3220374)

AJA BUILDERS (BID ID -3222733)