PROVISION OF CEILING FANS AND COOLER STANDS IN BUILDING NO P-264 AND P-34 AT AF STN MANAURI

Amount

S&F steel work rolled sections confirming to Fe 410 -W (Gde-E- 250) quality-A /med. grade structural steel tubes as in main and cross beams, hip and jack rafters, purlins where connected to common rafters and running rails and guides for sliding doors, fixed with angle cleats or other connecting plates including for cutting to dead length where required, notching, fitting, riveting and/or welding or connecting with plates etc. complete all as specified & directed.

S&F 10mm dia and 100mm long pin type Anchor fasner, nut & bolt set type, thread size 10mm on uper portion easy set zinc coated pin drive expansion bolts hammer strike pin type anchor bolts (weight not less than 55gram of each fasner with including bolt and pin) complete with rod and bolts including to make suitable size hole with drill machine for fixing fasner in RCC beam and making good complete all as specified & directed.

Cutting holes of superficial area n.exc. 100sqcm into or through reinforced cement concrete beam, slabs, chajjas, etc. reinforced or otherwise and making good dismantled portion in including cement mortar 1:3 or cement concrete 1:2:4 type B-1 as required including for provoding, fixing & removing shoring or other temporary supports complete all as specified & directed.

Demolition of brickwork or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified & directed.

Taking down cement plaster or cement lime plaster on brick or stone walls etc.Including raking out joints, hacking for key, scrubbing down with water etc complete all as specified & directed.

M&L rendering 15 mm thick in cement plaster 1:4 with WPC (@ 3% by weight of cement) on fair faces of brick work or concrete surface finishing the surface even and smooth without using extra cement complete all as specified & directed. Note:- WPC shall be measured & paid seprately.

Supply only Integral waterproofing compound complete all as specified & directed.

M&L for preparing new surface and applying two coats of cement based paint over a coat of primer complete all as specified & directed.

S&F mild steel rolled sections as in framing for cladding, glazing and the like fixed with angle cleats and connecting plates, etc.of rolled mild steel Fe 410-W (Gde-E- 250) quality-A including for cutting to dead length where required, notching, drilling, fitting,riveting and/or welding or connecting with bolts and nuts complete all as specified & directed. (including rivets or bolts and nuts), providing and fitting angle cleats, fish plates, gusset plates etc.complete all as specified & directed.

Cutting holes exc. half brick but not exc. one brick in brick walls built in cement mortar for inserting mild steel sections/ holdfasts and making good dismantled portion in including cement mortar 1:3 or cement concrete 1:2:4 type B-1 as required complete all as specified & directed.

M&L for applying two coats of synthetic enamal ordinary tint paint inclduing red oxide primer and prepartion extra complete on new steel or iron surfaces of any description, over 10cm in width or grith not otherwise described complete all as specified & directed.

M&L for point wiring including concealed/ fixed on surface of structure/ truss etc rigid non-metallic PVC conduit pipe medium grade, ISI marked heavy duty in size 20 MM dia with 1.5 Sqmm FRLS confirimg to IS 694 insulated unsheathed, multi stranded copper conductor cable, single core 1100 volt grade with flush cast iron/ pressed steel/ PVC modular terminal boxes (as per site) of suitable size for fixing of modular accessories such as switches, sockets and fan regulators etc including modular cover plate in required modules and colour and including FRLS insulated & unsheathed 1100 volts grade cable with multi stranded copper conductor of size 1.5 Sqmm as continous earth wire complete including making good the disturbed surfaces for the followiing:- Note:- (i) Quoted rate shall be included cost of modular terminal box, cheasesing, cutting, plastering, colouring etc to surface of wall / beam / roof etc matching with existed surface including required modular blank plate to be cover/ fill up the extra blank gap / space of modular cover plate / mounting board in required module / make / model etc. (2) The cost of modular cover plate in S&F shall be paid against respective items of this schedule.

One light point controlled by one way indepdent switch complete all as specified & directed.

S&F modular switch, one way 6 Amps 1 module complete all as specified & directed. Note:- The colour of modular accessories shall be approved by this office before placing the order.

S&F modular fan regulator step type 120W 2 module complete all as specified & directed.

S&F white cover plate with frame 3 module complete all as specified & directed.

S&F as new ceiling fan in size 1200 MM sweep white colour BEE 5 star rated copper wound energy saving with set of sweep/ extension rod / "U" clamp and other accessories single phase 50 Hzs Min air delivery 210 CFM with service value 6.00 BEE and Brush less direct current motor (BLDC) including making electric connection using three core copper cable drawn through in PVC flexible conduit pipe complete all as specified & directed. Make: Usha model EX 3, 1200 MM (white colour) / Havells model Efficiencia Neo BLDC, 1200mm (white colour) / Orient model I - FALCON, 1200mm (white colour). Note: Quoted rated shall be included the cost of GI clamp made out strip in size 32 x6 MM with nut bolts washer etc all.

Note :- (i) Credit shown in credit schedule of tender document shall be considered by the tenderer while quoting the rates of various items. The same shall be recovered from various payment to contractor before handing over old material. The contract amount shall be arrived at after deduction of Schedule of Credit from the total quoted amount in BOQ. (ii) Make of material shall be as per mentioned in Particular specifications or Appendix 'B' to Particular specifications as approved by AGE (I) AF manauri

Bharat Trading Company

RK Enterprises

Mohit Enterprises