Conversion of LPG to PNG of Billet Cutting Machine (BCMC) and Axle End cutting Machine (ACMC) in Old Axle Forge Line (OAFL) on turnkey basis as per the Technical Specification and Scope of work.

The tenderer shall have the following minimum eligibility criteria and submit adequate proof for the same along with the tender. The tenderers are required to satisfy the following Eligibility Criteria for participating in the tender. Financial Eligibility Criteria: The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less, Where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB of GCC April 2022 read in conjunction with Advance Correction Slip No. 1 dated 14.07.2022 (please refer to Annexure - P of this Tender Document), along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.

The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: a) Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or b) Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or c) One similar work costing not less than the amount equal to 60% of advertised value of the tender. (Format for submitting the technical eligibility criteria are as per Annexure Q of this tender document)

Similar Nature of work: Similar Nature of work for evaluating Technical Eligibility Criteria is defined as below: The tenderers should have executed the following similar nature of work: "Supply and commissioning of air supply line/gas pipe line with control manifold"

Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

As per Part I Offer Letter, Part II General Instructions to tenderer and Tender Conditions & Annexures-Attached