32/2025-26

Dismantling all types of masonry (except PCC/RCC), stacking serviceable materials and removing rubbish within 75 m lead. (B) With N.B. Variety stone metal. (a) 1:3:6 proportion

Cement concrete with graded stone ballast (40 mm size excluding (B) With N.B. Variety stone metal. (a) 1:3:6 proportion

Hire and labour charges for shuttering with centering and necessary staging upto 4 m using approved stout props and thick hard wood planks of approved thickness etc-------------etc. after completion of works.25 mm to 30mm thick wooden shuttering upto P.L GROUND FLOOR (a) 25 mm to 30 mm thick wooden shuttering as per decision & direction of

(f) 25 mm to 30 mm shuttering without staging in foundation

Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes.

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if bending to correct shape, placing in proper position and binding with 16necessary), cutting to requisite length, hooking and gauge black annealed wire at every intersection, complete as per drawing. (a) For works in foundation and upto roof of ground floor/upto 4 m

125 mm. thick brick work with 1st class bricks in cement mortar (1:4) in GL

Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface] (ii) With 1:4 cement mortar (a) 20 mm thick plaster (inner wall)

(b) 15 mm thick plaster (outer wall)

Steel Rolling Shutter (Supply, fitting & fixing) Item description (typical SOR wording): Supplying, fitting and fixing steel rolling shutter with M.S. laths, guide channels, pipe shaft, springs, locking arrangement, hood cover etc., complete. Steel Rolling Shutter (Supply, fitting & fixing) Item description (typical SOR wording): Supplying, fitting and fixing steel rolling shutter with M.S. laths, guide channels, pipe shaft, springs, locking arrangement, hood cover etc., complete.

Collapsible gate with 40 mm × 40 mm × 6 mm Tee as top and bottom guide rail, 20 mm × 10 mm × 2 mm vertical channels at 100 mm spacing in fully stretched position, 20 mm × 5 mm MS flats as collapsible bracings, properly riveted and washered, including 38 mm steel rollers, locking arrangement, fitted and fixed in position with lugs set in cement concrete including cutting holes, chasing and making good damages complete.

Display board