Loading
Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹16.9 LAccepted-AOC | ₹16.9 L | L1 | Accepted-AOC due to lowest firm. |
| 2 | L2₹18.1 L+₹1.1 L (6.60%)Rejected-Finance H NO 2228 3 SECTOR 45 C CHANDIGARH | CHANDIGARH | CHANDIGARH | CHANDIGARH | ₹18.1 L+₹1.1 L (6.60%) | L2 | Rejected-Finance due to higher rate. |
Tender Value
₹17.2 L
EMD Value
₹34,410
Closing Date
15 Jul 2026, 5:00 pmClosed
Executive Engineer
Executive Engineer Project Public Health Division No.1 Chandigarh
Providing Installing Testing Commissioning and Handing Over of AHU/ FCU and other allied works for Female Surgical Ward, Area-33 of Level-III, Block A, GMCH, Sector - 32 Chandigarh.
2026_CHD_93940_1
PH1/2026/426
Open Tender
Public Health Products
Percentage
90 days
Chandigarh
Scanned copy of Online UTR No.and Transaction Slip Receipt for Rs.34410Works completed during last 7Yrs, Performance Certificates, Annual Financial Turn Over for the last 3yrs, Affidavit reg.non blacklisted as mentioned in the tender documents.
2 documents required · 2 mandatory
₹0
₹34,410
2 Sept 2026
10 Jul 2026
16 Jul 2026
10 Jul 2026
15 Jul 2026
10 Jul 2026
This is a percentage-rate BOQ. The schedule below shows estimated quantities and rates. Bidders quote a single percentage above or below the total estimated cost.
| Sl No | Description | Qty | Unit | Est. Rate | Est. Amount |
|---|---|---|---|---|---|
| 1Supplying, Installing, Testing and Commissioning of Factory Built Floor Mounted Chilled Water Double Skin Type Air Handling Units made of 40 mm thick panels consisting of G.I. Casing of thickness 0.6mm outside layer, 0.6mm thickness inside layer with polyurethene foam (PUF) insulation of density not less than 38 Kg/Cum factory injected between them by injection moulding machine, complete with blower section with blower suitable for static pressure as detailed below. Cooling Coil section with aluminium finned copper tubes (Tube thickness not less than 0.5mm) cooling coil, filter section with 50mm thick metal, washable synthetic Type Pre Filter, Fine Filter, belt drive package with TEFC Drive Motor suitable for 415+ 10% Volts, 50 Hz, 3 Phase, A.C. Supply, complete drain connections, stainless steel drain pan complete in all respect to the entire satisfaction of EIC. | |||||
| 1.01 | The drain pan shall be of 18 Guage stainless steel with necessary slope to facilitate fast removal of condensate water. The water header shall be of copper with water in and out connections, vent plug on top and drain at bottom. | - | - | - | - |
| 1.02 | Make: Edgetech/ Systemair/Zeco/ Waves
Make of Blower : Kruger/Nicotra/Comefree
Make of motor: Havells/Crompton/Siemens/ABB
Make of filter: Thermadyne/ Camfil/ Enfilco | - | - | - | - |
| 1.03 | AHU/ 11000 CFM/ 120mm Static/ 6 Row Coil/ 27.5TR | 1 | Nos | 5,98,320 | ₹5,98,320 |
| 2Supply, installation, testing and commissioning of Fan Coil Unit, each complete with 3 rows deep chilled water coil, centrifugal fans, cleanable fabric filters, main condensate drain pans, auxiliary drain pan, complete with insulation of required thinkness, as described in specifications, casing, coil piping connections, wiring, control wiring in conduit upto themostat boxes. All fan coil units shall be suitable for 220 + 6% volts, 50 cycles, single phase power supply. including cost of motor opening in wall & make good same in original condition Fan Coil Units shall be of following refrigeration capactites as listed.Make : Edgetech/ System Air/ Zeco | |||||
| 2.1 | 2.0 TR Nominal Capacity | 1 | Nos | 29,270 | ₹29,270 |
| 3Supply, installation, testing and commissioning of controls for fan coil units consisting of 2-way motorized spring return valves, Snap acting type heating/cooling thermostat with fan speed switch, wiring etc. inculding cost of removing old one, from site, cleaning of area, fixing of new one inculding cost of all T&P and other arrangement /Material requied for fixing of 2-way valve , insulation of valve & pipe where required, with approved make insulation material,PVC conduet pipe, wires, shocket etc. complete job as per satisfactions of EIC. Make Honeyweel/ Siemens/ Belimo/ Danfoss | |||||
| 3.1 | 25 mm dia valve | 1 | Nos | 11,150 | ₹11,150 |
| 4SITC of Ball valves set with and without Y-Strainer duly insulated as per specifications. Make: Sant/ Emerald/ Leader/ Rapid cool | |||||
| 4.1 | 25 mm dia Valves | 1 | Nos | 3,200 | ₹3,200 |
stage.html
html • 0.04 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 28.83 MB
BOQ_115124.xls
BOQ • 0.38 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .