REPAIR AND MAINTENANCE OF LT CONDUCTORS WITH CONNECTED WKS PERTAINING TO PRE AND POST MONSOON AT AREA-I AND II UNDER GE SAUGOR

S&F cross arms, bracing, supports, clamps and back plate fabricated from structural steel sections including nuts, bolts, washers, welding, bending cold or hot, drilling holes for bolts in any shape or size as indicated or directed inclusive of one primer coat, one under coat and one finishing coat of paint. complete all as specified and directed.

M&L for replacement of CPRI approved factory fabricated LT distribution panel board outdoor type with canopy, both side operable including looking arrangement with sliding door bolt , cubical type standing/ floor mounting, dust and vermin proof, IP 54 protection, fabricated from 3.15 mm thick CRCA MS sheet with anticorrosive coating and finally epoxy polyester powder coating of flint grey shade fully compartmentalised as per existing design including refaxing all penal accessories in its original position making all electrical connections with glands, internal wiring etc, installation, connections , commissioning and testing in location (site) complete all as specified and directed. Note : The panel size shall not be more than 1 Sqm front area and 400mm in depth.

S&F in repair 65x90 mm size stay assembly suitable for 1.1 KV, having 16mm dia clearance hole including 16mm dia stay rod with loop insulator, MS stay plate size 230 x 230 x 6mm, stay clamps and all other accessories shown in electrical plate No 1 complete all as specified and directed.

S&F in repair galvanised stay strand 7/3.15 mm or 7/4.00 mm size with minimum tensile strength of 700 N/ Sqmm and conforming to IS : 2141-1979 complete all as specified and directed.

S&F in repair aluminium conductors steel reinforced (ACSR conforming to IS : 398) Part-II)-1976 for HT/LT over head lines on PCC/ steel/rail poles including Aluminium binding wire complete all as specified of existing size complete all as specified and directed.

S&F in repair GI wire 4mm dia (8 SWG) stretching and fixing on pole for continuous earth conductor, Guard wire 3.2 mm (10 SWG) for cradle (Hexagonal/rectangular) including binding wire all as specified and directed.

S&F in repair pin type polymer / porcelain, vitreous, white, brown or green insulator including Galvanised Mild Steel spindle, two Galvanised iron washers and one GI nut 100 mm height , 65 mm dia suitable for 1100 Volt working pressure grade (LT) complete all as specified and directed.

S&F in repair shackle type polymer / porcelain, vitreous, white, brown or green insulator including Galvanised Mild Steel straps, washers, suitable bolts, washers and nuts of size 100 mm height, 115 mm dia for 1100 volts working pressure grade complete all as specified and directed.

S&F in repair outdoor type heat shrinkable End termination cable joint suitable for 11KV 3 core 50 to 95 Sqmm XLPE cable including all material & accessories required as per manufacturer’s recommendations, making joint and testing complete all as specified and directed.

S&F in repair outdoor type heat shrinkable End termination cable joint suitable for 11KV 3 core 120 to 185 Sqmm XLPE cable including all material & accessories required as per manufacturer’s recommendations, making joint and testing complete all as specified and directed.