Repair and Maintenance work Zonal Office - 1 , 2 , 3 , 4 in Kancheepuram Corporation.

Wiring with 2 x 1.5 sqmm PVC unsheathed SC alu. Cable of 1100 V Grade in suitable PVC rigid pipe in wall and ceiling with PVC accessaries and T.W. Switch box with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC Light/fan point.S.D 22

Wiring with 2x1.5 sq mm (22/03mm) P.V.C. unsheathed copper Cable of 1100V grade suitable heavy gauge pvc pipe on wall with NS accessories with 150mm x 100mm x 75mm MS switch box 5A 3pin non inter locking system including CS Plug pin T.W. Box with painting of suitable colour with continuous earth wire connection by 14 SWG TC wire for plug point with painting. etc., Complete as per Standard Specification (SD 37)

Supply and Fixing of Single Box type 4 Feet 40W Tube Light Fitting complete with Copper Choke and Condenser with Teak Wood round blocks on wall of ceiling with tubes with PVC unsheathed lead from terminal to the fitting. etc complete.(SD88)

Supply and fixing of 1200mm (48") AC Ceilling fan complete with stepped eletronic 300W regulater with 1 meter dwon dwon rod on the existing clamb (SD.107)

Providing of 35mm thick factory made pre-laminated ABS (Acrolynitrile Butadiene Styrene) Door Shutter moulded in different designs, consisting of all round frame made out of water proof solid foam PVC bar of size 20 x 32mm, reinforced by 32 x 32mm - 2 Nos., for vertical made out of LVL (Laminated Veneer Lumber), core material of 32mm thick high density craft paper honey comb board, sandwiched on both sides with pre-laminated ABS sheet thickness of 1.5mm. PVC edge banding of size 0.45mm on the vertical sides. Hardware made out of steel coated butterfly hinges - 3 Nos., for each shutter and ISI make SS round lock complete for finished item of work, complete complying with the standard specification. The door shutter and frame should be got approved from the Executive Engineer before use on work. (Plain Pre-laminated Door) PWD SOR Sl. No. 268-a

Supplying and fixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962.