SPL REPAIR OF BOUNDARY WALL WITH 01 X IRON MAIN ENTRANCE GATE OF PAO (ORS) GRC AND 01 X CLOSED SHED FOR STORAGE OF OIL, LUBRICANTS AND GREASES AT FOL GROUP OF 54 ASC (SUPPLY) TYPE C IN THE AREA OF AGE B/R-II UNDER GE (WEST) JABALPUR

Amount

Demolition of reinforced concrete of any description and in any position not otherwise specifically provided for including reinforcement cut as required to facilliate demolition complete all as specified and directed.

M& L for dismantling of Brickwork in cement mortar, laid dry complete all as specified and as directed.

Excavating over areas for foundation etc. or for shafts, wells, cesspits, manholes, pier holes etc. exc 10 sqm on plan area and not exc 1.5m in depth and getting out in any type of soil complete all as specified and as directed.

Excavating over areas exc 1.5m but not exc 3M in depth; for foundation etc. or for shafts, wells, cesspits, manholes, pier holes etc. exc 10 sqm on plan and getting out in any type of soil complete all as specified and as directed.

Returning filling in, including spreading, levelling, watering and well ramming in layers n. exc. 25 cm in hard and dence soil complete all as specified and as directed.

Removing excavated material depositing where directed at a level exc. 1.50 km but n exc. 5 km above the starting point complete all as specified and as directed.

M & L Moorum / red bajari filling in floor or pavings, laid in layers n. exc 15 cm thick, spread, levelled and rammed including watering as required complete all as specified and as directed.

M&L for Hardcore of guage n exc 63 mm, deposited, spread and levelled n. exc. 15 cm thick, watered and rammed to true surface with broken stone or boulder complete all as specified and as directed.

M & L for 40mm thick Damp proof course In PCC 1:2:4 type B-0 (using 12.5mm graded aggregate) to horizontal or vertical surface complete all as specified and as directed.

M&L for cement concrete 1:4:8 Type D-2 using 40 mm graded stone aggregate in foundation filling and mass concrete complete all as specified and as directed.

Supply only liquid water proofing compound , ISI marked complete all as specified and as directed.

M&L for RCC M-25(design mix) using 20 mm graded stone aggregate in foundation, including rafts, footings, beams, plinth beams; bases for columns; etc; basement slabs, under-remed piles and mass concrete complete all as specified and as directed.

M&L for RCC M-25(design mix) using 20 mm graded stone aggregate as in cloumns, pillars, piers, posts and struts complete all as specified and as directed.

M & L for RCC M-25(design mix) using 20mm graded aggregate as in beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and as directed.

M & L for RCC M-25(design mix) using 20mm graded aggregate in slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and as directed.

M&L for providing Reinforced cement concrete of M-25 (Design Mix) (using 20mm graded stone agg) for landings, chajjas, and similar articles with plain faces etc. with plain fair faces, including chamfers, weatherings, throating etc. and setting in mortar complete with joints to match the shade set in CM 1:4 including necessary form work complete all as specified and as directed.

M&L for brick work with fly ash modular bricks, straight or curved on plan exc 6m mean radius, built in CM 1:6 complete all as specified and as directed.

M&L for form work to sides of concrete foundations, footings, bases of columns, raft and raft beams sides and soffits (if any) of foundation and plinth beams and similar works; vertical or to batter complete all as specified and as directed.

M&L for form work to sides of pillats, posts, struts, piers, columns and stanchions complete all as specified and as directed.

M & L for Formwork to sides and soffits of floor or roof beams, beam haunchings,girders, bressummers,lintels, cantilevers, shelves including sup- ports, overhangs,etc. also splays between floors and beams, etc complete all as specified and as directed.

M & L for formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping), work in rough finished flat surfaces of concrete for flat rough surface of finish complete all as specified and as directed.

M & L for mild steel TMT bars of 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to Gd I, IS-432 Part I complete all as specified and as directed.

S&F TMT bars 5mm and over upto and including 10mm dia in stirrups, spacers and binders bent to shape required,including binding with mild steel wire (annealed) not less than .9mm dia complete all as specified and as directed.

S&F framed work such as grills, gratings etc with ends of bars shouldered and or reiverted or forged into spikes, framed guard bars and similar work conferming to Fe 410-0 or Fe 310- complete all as specified and as directed.

S&F Mild steel posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe 410-0 or Fe 310-0 complete all as specified and directed.

S&F, Galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) complete all as specified and directed.

M&L for Framed work as in doors or gates of angle or other section ornamental type with gusset plates, rails, braces etc completed drilled for fixing of steel sheet or other covering doors etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheet) and also hold fasts, fastening and fixing complete all as specified and directed.

M&L for bands, straps, supports or stays for rainwater, ventilating pipes, including bolts, if required: hooks (stay), heavy, for large gates; hook and pintle hinges: large hasps and staples; chains; hand made sliding bolts; clamps; hold fasts; wall ties; hooks for hanging fans; plain angle cleats for securing purlins to wood trusses or rafters; knee piece inserts; two way and three way straps, plate washers and similar small articles conforming to Fe-290 Gde-E-16 complete all as specified and directed.

S&F Anodised aluminium window and ventilator shutters, fixed typewithout sash bar, aluminium sectionweighing 0.55 kg/m includingnecessary joining cleats, glazingclips, rubber packing, anodisedaluminium snap beading, screwsetc. complete all as specified and as directed.

S&F gear operated steel rolling shutters,laths thickness 1mm with out ball bearing, as specified including top cover, anchoring rod, hasp and staple and one shop coat of primer; erected in position as indicated, complete: push pull or manual type complete all as specified and as directed.

M&L Water proofing treatment on roof surface (Horizontal & Vertical surfaces) in following sequence through manufacturer / authorized applicator of the manufacturer including taking down of existing roof treatment, properly cleaning & drying the concrete surfaces complete all as specified and as directed.

(a) M&L 10 mm thick rendering on roof surfaces/concrete surface in CM 1:3 complete all as specified and as directed.

(b) Applying evenly a tack coat of industrial bitumen 85/25 grade @ 1.2 kg/ Sqm incl cleaning surfaces complete all as specified and as directed.

(c) Laying unrolled over the bitumen coated surface,3 mm thick polymeric water proofing membrane Hyperplas standard wt not less than 3kg /Sqm with 100 mm over laps shall be sealed by flame as per manufacturers instruction complete all as specified and as directed.

(d) Applying two coats of bituminous base aluminium paint on old Surfaces including preparation complete all as specified and as directed.

M&L for 100 mm thick PCC 1:2:4 type B-2using 40 mm graded aggregate as in flooring with finishes cement concrete surface even & smooth without using extra cement complete all as specified and as directed.

M & L for 75mm th PCC 1:3:6 type C-1 using 20mm graded stone aggregate as in plinth protection finished even and smooth without using extra cement complete all as specified and as directed.

M & L rendering 15mm thick on brick wall or concrete surface in cement mortar 1:6 finished even and smooth without using extra cement complete all as specified and as directed.

M & L rendering 15mm thick on brick wall or concrete in cement mortar 1:4 mixed with water proofing compound, finished even and smooth without using extra cement complete all as specified and as directed. (Note:- Water proofing compound shall be measured and paid saperately.)

M & L rendering 5mm thick on ceiling in cement mortar 1:3 finished fair and even smooth without using extra cement complete all as specified and as directed.

M & L applying two coats of cement based paint on newly plastered or unplastered wall surface including preparation of surfaces over a coat of alkali resistant primer , complete all as specified and as directed.

S&F for 5.5 mm thick sheet glass, ordinary quality and glazing with rubber gasket in square exceeding 0.5 Sqm in each pane, complete all as specified and directed.

M&L two coat of synthetic enamel paint on new steel surface of any description over 10cm in width or grith not otherwise described over a coat red oxzide primer incl preparation of surfaces complete all as specified and directed.

M&L for applying three coats of white wash on newly plastered wall surfaces including preparation complete all as specified and as directed.

M&L applying three coats of white wash on newly plastered or unplastered ceiling surfaces including preperation complete all as specified and as directed.

M&L for 25mm thick Sand filling under floors or in foundations including watering and consolidation complete all as specified and as directed.

upadhyay Builders (BID ID -3103831)

MAA SHARDA CONSTRUCTION (BID ID -3104454)

M/S Modern builders (BID ID -3098950)

chandra builders (BID ID -3100798)

C L BHATIA (BID ID -3118429)

RAGHAVAY CORPORATION (BID ID -3104438)

SHRI KRISHNA CONSTRUCTIONS (BID ID -3100111)