PROVN OF LAWN TENNIS COURT WITH COVERED SHED AT CGRA KUNJATHBAIL MANGALORE UNDER GE(I)(CG) GOA

Amount

SCH A PART-I [ B/R ITEMS] Excavating in post holes (or similar holes) each n exc 0.5 cum, in soft/disintegrated rock, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, complete all as specified and directed.

M & L Plain Cement Concrete Type B2 1:2:4 (using 40mm graded stone aggregate) in post holes, including use and waste of form work complete all as specified and directed.

M & L Pre-cast cement concrete block masonry with solid blocks Type C1 1:3:6 (using 20mm graded stone aggregate) exc. 10 cm in width and setting in cement mortar 1:4, complete all as specified and directed.

M & L Rendering 15mm thick in Cement mortar 1:6 on fair faces of internal brickwork or concrete surface and finished even and smooth without using extra cement, with and including 3mm thick wall care putty complete all as specified and directed.

M & L Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gms/litre, of approved manufacturer, of required shade and colour complete, as per manufacturer's specification. Two or more coats on new work on internal wall and ceiling surfaces, complete all as specified and directed.

Dismantling fencing wire mesh, any type complete all as specified and directed.

Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed.

Demolition of cement concrete (unreinforced) in ground floors and pavings n exc 15 cm thickness (below or above ground level) complete all as specified and directed.

M & L Plain Cement Concrete (1:2:4) type B-1 (using 20mm graded stone aggregates) as in padding concrete, complete all as specified and directed.

S & F Fe 410W (Gde E-250) quality A for Roof truses (framed), trussed, purlins, crane grantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc complete all as specified and directed.

S & F Steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S.11611979 grade St.-240 complete all as specified and directed.

S & F Mild Steel bolts. purpose made, diameter of neck not exc 12mm with hexagonal or square head one end and screwed the other, or screwed both ends; each screwed end to be fitted with washers and one hexagonal or square nut. exc 30cm long complete all as specified and directed.

M & L Two coats of Synthetic enamel paint over a coat of red oxide primer on new steel surfaces of any description, not otherwise described over 10cm width or grith after preparation complete all as specified and directed.

S & F Pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and directed.

S & F Pre-painted galvalume aluminum zinc coating GI based plain steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and directed.

Expanded metal, exc 4 kg per sqm, cut to length, bent to shape required and tying with and including annealed mild steel wire not less than 0.9mm dia or fixing with galvanised steel staples supplied and fixed to wood or steel members complete all as specified and directed.

M & L Mild steel, plain, black sheet 1.60 mm thick, in hearths; covering to door shutters; covering to door chowkats (frames); chullah hoods; water tanks; water troughs; ducts; urinal troughs and funnels, etc. cut to size edges beaded if directed, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel members, etc., with plain 40mm lap joints or welded/ riveted seams including bending, turning up, mitred angles, stopped ends, outlets, etc. as required complete all as specified and directed.

S & F bands, straps, supports or stays for rainwater, ventilating pipes, including bolts, if required: hooks (stay), heavy, for large gates; hook and pintle hinges: large hasps and staples; chains; hand made sliding bolts; clamps; hold fasts; wall ties; hooks for hanging fans; plain angle cleats for securing purlins to wood trusses or rafters; knee piece inserts; two way and three way straps, plate washers and similar small articles conforming to Fe-290 Gde-E-165 complete all as specified and directed.

SCH A PART-II [ SYNTHETIC TENNIS COURT] Providing and Laying of ITF certified 9 layers Acrylic Synthetic Tennis Court of size (25m x 14m) as per standards system with thickness up to 2.5mm in following stages:- 9- LAYERS TENNIS COURT SYSTEM: 1.ACRYPATCH - 100% ACRYFLEX (APEX) based emulsion to repair cracks of concrete and asphalt pavement. 2. PRIMER: 100% ACRYFLEX (APEX) based emulsion to improve the bond of acrylic court system to the concrete or asphalt surfaces. 3.RESURFACER: Acryflex Resurface 367-30 for filling and smoothing asphalt or concrete surfaces in preparation for APEX ITF Approved tennis court system. Fill the surface chips, voids and conceals repairs while providing a smooth surface for color coating. 4.CUSHION COAT: 2-Layers of APEX floor (APEX) cushion for asphalt or concrete surfaces in preparation for KDF ITF approved system ULTRA CUSHION COAT: 2-layer APEX floor (APEX) cushion for asphalt or concrete surfaces in preparation for KDF ITF approved system 5.PRECOAT: APEX FLOOR (APEX) based textured tennis topcoat. Ideal for color coating tennis and basketball courts and other sport pavement surfaces.

M & L for game line marking for Tennis Court as per International Standards complete all as specified and directed.

SCH A PART- III [ E/M ITEMS] S & F LED flood light 120 watt 230 V AC outdoor type with thermal management in multiple optics and equipped with IP-66 protection, with impact and corrosion resistant complete with driver and lamp complete all as specified and directed.

Supply, lay, testing and commissioning UG cable XLPE insulated 16 Sqmm 2 Core, armored heavy duty electric cable, 1100 volts grade with stranded aluminium conductor in trenches or on wall including suitable size of double grip cable gland and joiinting etc complete all as specified and directed.

Supply and lay GI pipe medium grade 40mm dia as cable protection laid on trench/floor, fixed on pole/wall etc of following sizes complete all as specified and directed.

M & L laying 3 core 4.00 Sqmm PVC insulated and PVC Round Sheathed, Copper Conductor (flexible) industrial cable, 1100 Volts, including passing through PVC Conduit of suitable size complete all as specified and directed.

M & L MCB Distribution board double door type SPN 8 way, sheet steel, powder painted, with 200 Amps rated bus bar etc. and fixing MCBs of various rating capacity including taking down old unserviceable MCB DBs complete all as specified and directed.

M & L MCB SPN 40-60 Amps, 230 volts, 50 Hz suitable for fixing in MCB DB 'C' series incl taking down old unserviceable MCB complete all as specified and directed.

M & L MCB SP 6-32 Amps, 230 volts, 50 Hz suitable for fixing in MCB DB 'C' series incl taking down old unserviceable MCB complete all as specified and directed.

S & F Thermoplastic Polycarbonate Lighting DB, IP-65, weatherproof, Corrosion free, Shock proof and High impact strength complete all as specified and directed Incoming = 25 Amps MCB -01 No and Outcoming = 6 Amps MCB - 6 Nos.

S & F in repairs Double wall corrugated High Density Polymer Ethyl (HDPE) pipe of size 40mm outer dia for laying of electric cable in trenches, wall, floor including bens sockets and other connected accessories complete all as specified and directed.

S & F Industrial turbo ventilator fan/ roof extractor exhaust fan for roof ventilators, 24 inch stainless steel, weather and rain proof complete all as specified and directed.

Excavation in trenches not exc 1.5m in wide and not exc 1.5 m in depth and getting out in hard/dense soil for laying of cables complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25cm in soft / disintegrated rock complete all as specified and directed.

Removing excavated material n exc. 50m and depositing where directed at a level n exc. 1.5m above the starting point complete all as specified and directed.

Supply and lay riddled earth in trenches for cable protection, spreading, levelling, Punning and consolidating complete all as specified and directed.

Supply and lay old bricks sub class A for cable protection laid trenches complete all as specified and directed.

Gates Infra Construction Co (BID ID -3075377)

KDR CONSTRUCTION (BID ID -3079816)