Providing and Installing New Deep Borewell in Mohalla Nathalian Ward No 2 of Village Birkuli Block Dhar Kalan Distt Pathankot Under Head 15th Finance Commission GP Funds

Amount

Drilling Bore well of 152mm dia by using ODEX (Tubex) method as per site conditions, complete in all respect 0 mtr. to 90 mtr.

Supplying and lowering of 125mm i/d MS pipe 5.0mm thick

Providing of fixing suitable casing shoe and bit tube as per requirement

Development of bore hole and yield testing with air compressor and subsequently with submersible pumping set etc.

Supplying and erection of submersible pumping set of KSB/ Johnston Kirloskar make confirming to relevant I.S. Specifications coupled directly to water proof single phase Squirrel cage induction motor of suitable capacity conforming to relevant I.S. specification capable of delivering 1 to 2.5 LPS discharge at 35 to 110 mtr. head including cost of accessories such as control panel. Volt meter, Amperemeter, MCB, starter and Submersible Cable etc.

Rate of Motor with Pump

Panel Board

Submersible cable Size 2.50mm2

Column Pipe (G.I) 50 mm i/d

Construction of water storage tank of 5000 ltr. Capacity 10 ft height upto sill level cum pump chamber (6ft dia)

Earth work in excavation foundation, trenches, etc. in all kinds of soil where pick-jumper work is not involved and not exceeding 2.0 meters depth including dressing of bottom and sides of trenches, staking the excavated soil clear form the edge of excavation and subsequent filling around masonry in 15 cm. layers with compaction including disposal of all surplus soil as directed with in lead of 30 meter.

Cement concrete 1: 4: 8 with bricks ballast 40mm gauge

First class burnt brick work laid in cement sand mortar 1:4 in foundation and plinth

Damp proof course 4 cm thick of cement concrete 1:2:4 with two coats of bitumen 20/30 penetration 1.65 Kg per sqm laid hot and sanded

B.B. laid in Cement Sand Motor in super structure in 1:4

115mm thick brick wall laid in cement mortar 1:4 without reinforcement in super structure

Reinforced cement concrete M-20 mechanically batch mixed using batch type concrete mixer as per IS:1791 and vibrated by needle vibrator but excluding steel reinforcement centring and shuttering in superstructure

Mild steel reinforcement for RCC work where not including in the complete rate for R.C.C. including bending binding and placing in position complete Up to 20 mm dia bar.

12.5mm thick cement plaster 1:4

12.5mm thick cement plaster 1:4 under side of ceiling

Painting two coats (including priming coats) of doors and ventilators 16.325 sft.

Distempering with Acrylic washable oil bound distemper (of Approved Manufacture) two coat over priming coat on new work.

Finishing Walls with cement water soluble exterior paints such as snowcem robbiacem etc. on new work to coats to give as even shade.

Provision for electric fitting LS

Providing and fixing 14 gauge M.S. Sheet garage doors with 40mm x 40mm x 6mm angle iron frame with diagonal braces 3.15 mm gusset plates including locking arrangement with handles etc. complete in all respect.

Steel Work, Fixed independently without connecting plates, Including cutting, hoisting and fixed in position. Tees, Angles and channels (for ventilations)

Providing and fixing inlet, outlet, scour pipe and over flow pipe including all accessories.

Providing and Fixing 560mm, 500 mm and 450mm internal dia meter circular or 450mm x 600mm clear inside opening rectangular RCC manhole cover and frame ISI marked as IS:12592-2002 including carriage from the stores of the engineer incharge to the site of work. Loading, unloading including stacking and setting the same to the correct lines over manholes including cement concrete copping (M-20) around the frame etc. dia of steel for lifting hook is 15 mm (for EHD and HD) extra heavy duty.

Providing, Fixing and jointing ISI GM Peat Valve (heavy pattern) as per IS 778 with hand wheel on G.I. Pipe line laid in the ground or inside the building including all carriage complete.

Providing and laying, jointing, fixing, testing ISI marked G.I Pipe (as per IS 1239) B-Class Premium make such as (Jindal, Hissar) including cost of specials such as tees, bends, sockets elbow etc cutting, threading in trenches in the ground complete.

50mm i/d (with excavation)

40mm i/d (with excavation)

25mm i/d (without excavation)

20mm i/d (without excavation)

Providing, fixing and jointing ISI Marked Gun-Metal Peet Valves (Heavy Pattern) as IS 778 with hand wheels, on G.I. Pipe lines laid in the ground including all carriages complete.

Providing and fixing Volt Stablizer (LS)

Dismantling and restoration of Cement Concrete Road complete in all respect

Dismantling & Restoration of Mettaled Road complete in all respect

DisinfectionUnit: Providing Installing testing and commissioning and one no. electronically actuated, diaphragm operated, metering system, chemical dosing chlorinator, suitable for delivering 0.5 to 6 leter of bleaching powder solution/ sodium hypo solution per hrs under maximum deliver pressure upto 7kg/cm2 and suction left not less than 1.5 meter. (Milton roy or Equivalent make)

Providing Proposed water connection to house hold up to wall with providing laying, jointing, testing G.I. pipe lines 15mm i/d =2.5 mtr B class as per CSR 28.36(A) (Above G.L.) Providing and fixing MDPE pipe 15mm i/d with specials 2.00 mtr (Below GL) including cost of specials such as tees, bends, sockets, elbow etc cutting, threading and testing trenchs in the ground and ISI 15mm i/d GM ferrule s per IS 2692 and 3" i/d clamp with C.I. bib cock 15 mm i/d as per IS 210 with stainless steel spindle of approved make as per CSR 30.65(b)