Tender for Provision of Shed (G.I Profile Sheet) at Mess Kitchen and Fencing for Water Cooler at B.H.-3, IIIT-A

Surface Dressing : Surface dressing of the ground including removing vegetation and inequalities not exceeding 15 cm deep, and disposal of rubbish with lead up to 50 m and lift up to 1.5 m.

Earth work in excavation by mechanical means (Hydraulic Excavator) / manual means over areas (exceeding 30 cm in depth, 1.5 m in width, and 10 sqm on plan) including getting out and disposal of excavated earth with lead up to 50 m and lift up to 1.5 m, as directed by the Engineer-in-Charge

Providing and laying in position Plain Cement Concrete (PCC) of specified grade, excluding the cost of centering and shuttering, all work up to plinth levelPCC 1:5:10(1 Cement : 5 course sand(zone-3) derived from natural sources : 10 graded stone aggregate 40mm nominal size derived from natural sources.)

Providing and laying cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate), finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps, complete

Structural steel work in built-up sections, trusses and framed work, riveted, bolted or welded, including cutting, hoisting, fixing in position and applying one coat of approved steel primer, complete Steel structure.

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by the Engineer-in-Charge) of 0.50 mm total coated thickness (base metal minimum 0.45 mm + coating 0.05 mm), with 120 gsm zinc coating as per IS 277, in 240 MPa steel grade, with 5–7 micron epoxy primer on both sides and 15–18 micron sheet should be supplied in single length upto 12m. or as desired by engineer-in-charge. The sheet shall be fixed with 5.5 × 55 mm self-drilling/self-tapping screws with EPDM seals, complete upto any pitch in horizontal/ vertical or curved surfaces excluding the cast of purlines, rafter and trusses and including cutting to size and shape whatever required.

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade.

Brick work with common burnt clay F.P.S. (non-modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level, in all shapes and sizes, in: Sub-item: 6.4.1 – Cement mortar 1:4 (1 cement : 4 coarse sand)

CEMENT PLASTER (IN Coarse sand) 1:4(1Cement :4 coarse sand)