Enit-05 0f 2020 (03)

Amount

Earth work in excavation in foundation of trenches/bulk Excavation in all kinds of soil with required depth including removal of excavated soil/slush etc. ,dressing of bed and sides ,dewatering (if any) of trenches till construction upto ground level is achieved and disposal of excavated soil as directed by the Engineer in charge including all leads, lifts and Carriage by mechanical means as required complete.

Providing & laying in position cement concrete of specified grade excluding the cost of centering and shuttering all works upto plinth level.

(a)1:4:8( 1 cement: 4 coarse sand: 8 graded stone agg/ 40mm nominal size) crushed aggregate)

(b)1:2:4 ( 1 cement: 2 coarse sand: 4 graded stone agg/ 20mm nominal size) crushed aggregate) for mass concrete works

Providing and laying in position specified grades of plain cement concrete M-20 grade (1Cement : 1.5 Coarse sand : 3 Graded stone aggereate 20 mm N/S) in walls(any thickness) including attached pilasters, buttresses, plinth and string courses, filets, floors etc and struts etc. using 20mm thick crushed stone agg. excluding the cost of centering, shuttering, finishing. All works upto roof level.

Providing form work including Centering, shuttering, strutting, propping etc., using ply wood sheeting with water proofing ply board (12 mm min.thickness) and removal of the same for( All work at all levels complete.).-

Filling with G.S.B in in plinth ,trenches, plinth, sides of foundation,floors etc. Layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering lead upto 50m and lift upto 1.5m.

Providing and fixing of Grating made of M.S sections like angles, flats etc. complete as per the directions of engineer Incharge.

Structural steel work in welded in built up sections trusses and framed work, including cutting, hoisting, fixing in position and applying of priming coat of approved steel primer complete in all respects..(All work at all levels complete.)

Providing corrugated G.S. sheet roofing fixed with polymer coated Jor L hooks,bolts and nuts 8mm diameter with bitumen and G.I limpet washers filled with white lead and including a coat of approved steel primer and two coats of approved paint on over lapping of sheets complete(upto a pitch of 60 degree) excluding the cost of purlins,rafters and trusses complete.(0.63mm thick with zinc coating not less than 275gm/sm

Providing and fixing Welded steel M.S Mesh wire fabric of 25 mm x25 mm aperature of required width including painted with two or more coats of enamel paint of approved shade over a coat of primer complete as per the directions of site Engineer.

Supplying and fixing rolling shutters of approved make made of M.S Laths interlocked together through their entire length and jointed together at the end by end locks mounted on speicially designed pipe shaft with brackets ,side guides and arrangements for inside and outside locking with push and pull operation complete including the cost of providing and fixing necessary 27.5 cms long wire springs grade No.2 and M.S Top cover of required thickness for rolling shutters complete as per specifications 80x 1.20 mm M.S laths with 1.20 mm thick top cover and ball bearings Complete in all respects.

Painting with synthetic enamel paint two or more coats with red oxide steel primer of approved brand and manufacture on steel and steel based surfaces complete.

Note:-The rates quoted are inclusive of all carriages of materials (Mechanical/Manual) from source to site work and all extra charges including dewatering if any during the execution of work complete in all respects.

M/S IRFAN MAJEED BHAT

MUDASIR MAQBOOL HAJI

MASOOD HUSSAIN SHAH

RIYAZ AHMAD MAGRAY