PROVN OF APFC PANEL UNDER AGE (I) POKARAN

Amount

Supply and install Automtic power factor Correction (APFC) Panel for 3 Phas, 415 V & 50 Hz system of capacity 50 KVAR Complete all as specified.

Supply and install Automtic power factor Correction (APFC) Panel for 3 Phas, 415 V & 50 Hz system of capacity 60 KVAR Complete all as specified.

Supply and install Automtic power factor Correction (APFC) Panel for 3 Phas, 415 V & 50 Hz system of capacity 70 KVAR Complete all as specified.

Supply and install Automtic power factor Correction (APFC) Panel for 3 Phas, 415 V & 50 Hz system of capacity 90 KVAR Complete all as specified.

Supply and lay XLPE insulated screened PVC bedded, galvanised steel strip or wire armoured electric power cable (heavy duty) 1100 Volt grade with stranded aluminium conductor of size 150 sq mm 3 1/2 core.

M&L for Laying of XLPE insulate, armoured, heavy duty electric cable, aluminium conductor, 1100 volts grade of size 70 sqmm x 3.5 core

M&L for Earthing complete with galvanized steel earth plate electrode 60 cm x 60 cm x 6 mm thick buried directly in ground (earth pit not less than 2.25 metre deep below ground level) with top edge of plate not less than 1.5 metre below normal ground level connected to galvanized earth strip of size 32x 6mm by means of bolts, nuts, check nuts and washers of galvanized iron or steel all as shown in electrical Plate No 3 of MES SSR Part-I connected to main switch board or main control board all as specified and testing on completion including provision of earth strip protected by galvanized iron 40 mm dia light grade pipe and watering pipe shall be 20 mm bore light grade including all excavation and earth work in any type of strata, PCC pit with pre-cast RCC cover, charcoal/salt, funnel etc complete all as directed by Engineer -in-charge.

Excavation in trenches in hard/ dense soil not exceeding 1.5 mtr deep and not exceeding 1.5 mtr wide for laying of cables, RCC poles/stays and struts etc and getting out including trimming sides and forming bottom surface all as specified and directed at site.

Removing excavated material any type n exc 50m and depositing at a level n.exc 1.5M above ground.

Returning/filling in layers, spreading leveling, watering and well ramming in layers n.exc 25m in sof/loose soil.

M&L for sand cushioning to PVC cable with tibba sand and punning to provide required cover all as directed.

Supply and laying Jodhpur stone patti for cable protection of lenth between 55 to 60 cm but width between 25 to 30 cm thicknes not less than 5 cm complete as per site requirement incl removing old unsv patti and direction of engineer in charge.

S.D. And Company

HUMERS INFRATECH