NIT 1208 Construction of CC Road Under MMGGPY PKG NO MMGGPY-BBB-109(01 work) District-Balodabazar

BILL OF QUANTITY

Gauravpath Gram- Kanji C.C. sadak sah nali nirman (Mukhya Marg school se Ramayan chaonk ki Ore)

Block - Balodabazar

Name of District - Balodabazar - Bhatapara

Package No. MMGGPY-BBB- 109

S. No. Department SOR Year BOQ Item ID Particulars Per Unit Rate C.C. sadak sah nali nirman (Mukhya Marg school se Ramayan chaonk ki Ore) Remark

Length - 200 mt.

Quantity Amount

1 PARD PMGSY 2025 3.5 (i) Excavation in Cutting in Soil Excavation for roadway in soil for carrying of cut earth to embankment site with a lift up to 1.5 m and lead up to 50 m as per Technical Specification Clause 302.3 Cum 65.00 480.00 31200.00

2 PARD PMGSY 2025 3.2 Compacting original ground / Existing Embankement (i)Compacting original ground supporting embankement/subgrade Loosing , levelling and compacting original ground supporting embankement / subgrade to facilitate placement of first layer of embankement , scarified to a depth of 150 mm mixed with water at OMC and then compacted by compacted by rolling to achieve minimum dry density as given in table 300.1 and 300.2 for embankement construction as per Technical Specification Clause 301.4.1 Cum 25.00 180.00 4500.00

3 PARD PMGSY 2025 4.1 (d) Granular Sub-base with Well Graded Material (CBR 20 or more) (Table 400.1) (d) Crushed stone materials (CBR 35 or more), This item is to be used only, where local GSB material or GSB material with blending with other material is not available. Cum 1772.00 100.00 177200.00

4 PARD PMGSY 2025 7.18(I) Providing concrete for plain/reinforced concrete in substructure complete as per drawings and technical specification Clause 802,804,805,806,807,1202 & 1204 For height up to 5m P.C.C. grade M 15 Cum 4839.00 35.00 169365.00

5 PARD PMGSY 2025 6.5 Construction of Plain Cement Concrete Drain with P.C.C. grade M-15 including all shuttering/form work etc. complete as per drawings/technical specification and direction of engineer in charge. Cum 4970.00 42.00 208740.00

6 PARD PMGSY 2025 6.1 (ii) Construction of un-reinforced, jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including eveling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying , primer, sealant, , using curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501. Cum 5889.00 160.00 942240.00

7 PARD PMGSY 2025 7.6 (D) Providing & Laying Cement Concrete Pipe NP3 on first class bedding of granular material including fixing collar with cement sand mortar 1:2 but excluding excavation, protection works, backfilling, concrete and masonary work in head wall and parapets as per clause 1106 .(D) 300 mm Dia. RM 1129.00 35.00 39515.00

8 PARD PMGSY 2025 9.14 (B) (B) Providing and fixing of typical PMGSY informatory sign board with Logo as per MORD specifications and drawing. Three MS Plates of 1.6 mm thick, top and middle plate duly welded with MS flat iron 25mm x 5m size on back on edges. The lower plate will be welded with MS angle iron frame of 25mm x 25mm x 5mm. The angle iron frame of the lower most plate and flat iron frame of middle plate will be welded to 2 nos. 75mm x 75 mm of 12 SWG sheet tubes posts duly embedded in cement concrete M-15 grade blocks of 450mm x 450mm x 600mm, 600mm below ground level. The top most diamond plate will be welded to middle plate by 47mm x 47mm of 12 SWG steel plate tube. All M.S. will be stove enameled on both sides. Lettering and printing arrows, border etc. will be painted with ready mixed synthetic enamel paint of superior quality in required shade and colour. All sections of framed posts and steel tube will be painted with primer and two coats of epoxy paint as per drawing Clause 1701 and Annexure 1700.1(MMGGP & NABARD BOARDS) each 18610.00 1.00 18610.00

9 PARD PMGSY 2025 9.2 (B) Semi- Reflective Traffic signs more than 0.90 sqm sign board Providing and erecting direction and place identification of semi reflective sign boards as per IRC- 67 made of 2 mm thick M.S. Sheet dul stove enameled paint white colour in front and grey colour on back with reflective border of 70 mm width reflective tape of engineering grade as per MORD specification of required shade and colour. Supported and welded on two nos. 47 mm of 12 SWG squre tube os 3050 mm height duly strengthened by 25 mm x 5 mn MS flat iron on edges on back foundations with M-15 grade cement concrete 450 mm x 450 mm x 600 mm, 600 mm below ground level as per approved drawing and Technical Specification Clause 1701. ( Nabard Board) sqm 5756.00 2.16 12432.96

Total 1603802.96

Add 18% GST Charge 288684.53

Total Amount 1892487.49