RESTORATION AFTER STORM DRAINAGE TO RETAINING WALL DRAIN ADJACENT BUILDING EXTERNAL ELECTRIC SUPPLY LT CABLES FLOOD LIGHTS UNDER VARIOUS LOCATIONS SOLAR WATER HEATER AND DG CONTROL PANEL AND ITS CONNECTED ITEMS UNDER GE WELLINGTON

Amount

Excavation over areas, not exceeding 1.5m deep and getting out in any type of soil complete all as specified and directed.

Rough excavation not exceeding 1.5m deep and getting out in any type of soil complete all as specified and directed.

Demolition of brickwork or stone/ boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified and directed.

Demolition of cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed.

M&L for PCC 1:4:8 type D2 using 40mm graded stone aggregate as in foundations filling and mass concrete complete all as specified and directed.

M&L for Stone walling of random rubble, uncoursed, well bonded, bedded and solidly hearted, built in cement mortar 1:4 and pointing the dressed surface with same mortar as the work proceeds complete all as specified and directed.

All as per Item No 6 here-in-before but except stone. Note : The stone obtained from demolition shall be reused as directed by the Engr-in-charge.

M&L for broken stone / boulders loose filling with aggregates of gauge 40 to 80 mm in back of walls complete all as specified and directed.

M&L for PVC (SWR) 110mm dia bore soil, waste and vent pipes single socketed in any length with rubber ring joints laid in trenches or in floors including dismantling old drain pipe complete all as specified and as directed.

Extra over stone walling for Granite or Trap stone for hammer dressing to face stones and dressing of face beds and joints, as specified, of random rubble walling, uncoursed or brought up to courses with maximum depression on face from straight edge held against the dressed surface not exceeding 40mm all as specified and directed.

M&L for 100mm thick PCC (1:4:8) type D2 using 40mm graded stone aggregate as in sub base floor finished even and fair including necessary formwork if required complete all as specified and directed.

M&L for machine pressed precast concrete interlocking paver block rubberised any shape and size conforming to IS- 15658 - 2006 of 60 mm thickness M-35 grade with grey cement and pigment including 50mm thick sand bed cushioning complete all as specified and directed.

M&L for pre-cast cement concrete block masnory with solid block using type C1, 1:3:6 using 20mm graded stone aggregate exceeding 10cm in width and setting in mortar 1:6 complete all as specified and directed

M&L for rendering 15mm thick in cement mortar 1:4 on fair faces of brick work/PCC block or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed.

M&L for keyed pointing to random or polygonal rubble masonry uncoursed or brought upto courses in cement mortar (1:4) complete all as specified and as directed.

M&L for PCC type C1, 1:3:6 using 20mm graded stone aggregate as in coping and the like including necessary form work complete all as specified and directed.

Returning filling in including spreading, levelling watering and well ramming in layers till consolidation not exceeding 25 cm thick complete all as specified and directed.

Material and labour for removal of excavated surplus soil not exceeding 50m and depositing where directed at a level not exceeding 1.5m above the starting point all as specified and directed.

Dismantling of structural steel works including doors, gates but excluding framed truss etc complete all as specified and directed.

M&L for mild steel posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc.,and similar work conforming to Fe 290 Gde E - 165 complete all as specified and directed.

Supply only Chain link MS galvanised fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc, including provision of binding wire complete all as specified and directed.

Fixing only chain link fencing including line wire, any mesh, any size and type of strandard rails, straining bolts etc including provision of binding wire complete, all as specified and directed.

M&L for preparation of new or previously untreated steel surfaces of any description not otherwise described over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and directed.

M&L for LED flood light fitting 200 Watt, 230 Volt AC outdoor type with high pressure die cast aluminium hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal mamagement in multiple optics with IP 65/66 protection complete all as specified and as directed. Make : Luker Product Code - LFL200LN5Y or equivalent to techno commercial make.

M&L for LED street light fitting 80 Watt, 230 Volt AC outdoor type with high pressure die cast aluminium hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal mamagement in multiple optics with IP 65/66 protection complete all as specified and as directed. Make : Luker Product Code - LSTE-80 or equivalent to techno commercial make.

M&L for LED street light fitting 30 Watt, 230 Volt AC outdoor type with high pressure die cast aluminium hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal mamagement in multiple optics with IP 65/66 protection complete all as specified and as directed. Make : Luker Product Code - LSTE-30 or equivalent to techno commercial make.

Supply and replacement of 16 Sqmm 4 core of 1100 volts grade LT UG cable XLPE insulated, screened, PVC bedded, galvanised steel strip or wire armoured, electric power cable (heavy duty) with multistranded aluminium conductor laid in trenches/ducts, fixed in walls/inside panel, drawn through pipe including taking out the old unserviceable LT cable complete all as specified and directed. Note : Rate quoted to be inclusive of connecting up with control gear including cable glands and cable lugs complete.

All as per Item No 27 here-in-before but size of cable 50 Sqmm 3.5 core complete all as specified and as directed.

All as per Item No 27 here-in-before but size of cable 70 Sqmm 3.5 core complete all as specified and as directed.

Excavating in trenches, not exceeding 1.5 m wide and not exceeding 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. not exceeding 10 Sq m on plan and getting out in soft/loose soil complete all as specified and directed.

Supply and spreading clean dry riddled excavated sand free from stone in trenches for cushioning all as specified for cable protection in trenches/ducts complete all as specified and directed. Note : Punned thickness shall be measured for payment purpose.)

Supply and laying reinforced precast concrete cable cover, class LV, Type - I flat of size 250mm x 150mm x 40mm complete all as specified and as directed.

M&L for cutting of PCC road 200mm thick for laying cable including making good with PCC 1:3:6 type C2 using 40mm graded stone aggregate and removing the surplus soil from the site premises completeall as directed.

S&F GI pipe light grade 80mm dia dia for cable protection in trenches/at PCC pole for loopin/loop out of cable and cable entry at bldg/block end including taking down complete all as specified and directed.

S&F toughened glass suitable for existing solar water heater fixing on wall/board including bolts and nuts, pipe connections incoming and outgoing complete all as specified and as directed.

M&L for 20mm bore steel tubes medium grade galvanized with all fittings and fixed complete to walls and ceilings or laid in floors of any length complete all as specified and directed.

S&F enclosed automatic transter switch frame 2, 125 amps rating, fixing on wall/board including bolts and nuts, cable connections incoming and outgoing complete all as specified and as directed by the Engr-in-charge. Make : L&T cat part No - CK90161BSOO or techno commercial equivalent make.

S&F enclosed automatic transter switch frame 3, 315 amps rating, fixing on wall/board including bolts and nuts, cable connections incoming and outgoing complete all as specified and as directed by the Engr-in-charge. Make : L&T cat part No - CK90165BSOO or techno commercial equivalent make.

GUNASEKARAN AND CO