Loading…
Loading…
| # | Company | Status |
|---|---|---|
| 1 | Admitted-Finance | Admitted-Finance |
| 2 | Admitted-Finance | Admitted-Finance |
| 3 | Admitted-Finance | Admitted-Finance |
| 4 | Admitted-Finance | Admitted-Finance |
Tender Value
₹5.0 L
EMD Value
₹5,000
Closing Date
21 Oct 2021, 2:00 pmClosed
Superintending Engineer, EUCC-V , Cis-gomti
LESA Bhawan, Near Residency, Kaiserbagh, Lucknow
SHIFTING OF 11 KV AND LT-LINES WHICH IS IN ROUTE OF UNDER CONSTRUCTED OVER-BRIDGE AT BANGLA BAZAR-BIJNOUR ROAD RAILWAY CROSSING NO-5C/2E-DOH (TOWARDS CROSSING TO BIJNOUR ROAD) UNDER DEPOSIT HEAD
2021_MVVNL_628587_1
23/EUCC(V)/LESA/2021-22
Open Tender
Electrical Works
60 days
BANGLA BAZAR-BIJNOUR ROAD RAILWAY CROSSING
As per tender document
2 documents required · 2 mandatory
₹1,180
A/c.No. 10101985364, IFSC CODE No. SBIN0003347,SBI
₹5,000
29 Oct 2021
7 Oct 2021
21 Oct 2021
7 Oct 2021
21 Oct 2021
7 Oct 2021
Amount
Safe Dragging, loading, carriage and unloading of following store materials with proper stacking from ESC Daliganj to JE dump store and JE dump store to work site within municipal areas.
11 KV 3X185 SQ MM XLPE CABLE
11 KV ST/TH/CJ KIT 3X185 SQ MM
11 KV END TERMINATION O/DOOR 3X185 SQ MM
ST-POLE 09 MTR LONG
LT-ABC 3x120+1x95+1x16 SQ MM
LT-DISTRIBUTION BOX 03 PHASE
MS- EARTHING ROD 20X2500 MM
STAY SET COMPLETE 16X1800 MM
STAY WIRE 7/10 SWG
ST POLE 11 MTR LONG
M.S.CHANNEL 100x50 SQMM
M.S. ANGLE IRON 65x65x6 MM
11 KV DISC INSULATOR T&C 45 KN
DISC FITTING T&C TYPE 45 KN
Digging of pit in Kachcha/Pakka land in depth upto 1/6 length of pole and Dragging of pole from nearby place/dump site to Pit, Erection of single pole along with proper in alignment for 11 KV and LT- Line on 09/11 mtr long ST pole and refilling with ramming of earth
Grouting of pole in depth of 01 mtr below ground level in ratio 1:4:8 in cement, sand and brick ballast as per RESPO norms.
Construction of pole plinth 300 mm x 450 mm above ground level in 1:2:4 in cement, coarse sand and stone gritt as per RESPO norms.
Painting of new erected 09/11 mtr ST pole with two coat of Red oxide paint, PO red paint at top of pole 2 mtr and balance by two coats of best quality aluminium paint of ISI mark as per norms.
Fabrication & erection of End type double pole for 11 KV line on 11 mtr. long ST-Pole with fixing of necessary clamps & other accesories like 02 No. Top channel 100x50 mm (1600mm each), 02 No. Bracing angle 65x65x6x4300 mm, Cable dropper, Disc Insulator with fitting, Danger board, Number plates and Barbed wire etc. (All material will be provided by contractor except ST- pole, Top channel, Bracing angle, cable dropper, Disc Insulator & Disc fitting).
Erection of stay set 16x1800 mm by digging of pit of size 0.4x0.6x1.6 mtr including grouting, binding, nuzzling and fixing of stay insulator with stay wire of size 7/10 SWG (All material will be provided by contractor except Stay rod (complete set) and stay wire).
Laying of 11 KV XLPE cable 3x185 sq mm D/C by digging of trench 800 mm deep & 750 mm wide its boxing with bricks & sand, laying of cable & separation of cables by brick wall, filling of sand upto top cover of the trench properly levelling & ramming & covering with stone slab after laying of cable. The ferruling of cable is also included in this work (All material will be provided by contractor except 11 KV cable)
Laying of 11 KV XLPE cable 3x185 sq mm S/C in MS- Pipe 125 mm dia by digging of trench in Kachcha/Pakka of suitable size as per site condition (All material will be provided by contractor except 11 KV cable)
Laying of single 11 KV 3x185 Sqmm XLPE Cable by drill method.
Hoisting of 11 KV 3x185 Sqmm XLPE cable on D/P through GI- pipe of size 4" dia 3 mtr long including its jumpering complete with holding clamps, PG clamps, Nut & bolts (All material will be provided by contractor)
Making of Heat & shrinkables joints of following sizes and types in 11 KV XLPE cable (Jointing kit will be provided by deptt.)
Outdoor end termination kit for 11 KV 3x185 sqmm XLPE cable
Straight through jointing kit for 11 KV 3x185 sqmm
Earthing of poles with MS- Earthing rod 20x2500 mm, earth wire with nut and bolts as per norms (All material will be provided by contractor except MS-Earthing rods).
High Pressure Testing.
Straightening of tilted poles.
Cutting/trimming of tree branches which are touching in 11 KV and LT lines.
Supply and fixing of cable route marker of 11 KV line
Fabrication & erection of Single Pole support for LT ABC line on 09 mtr. Long ST-Pole with fixing of necessary clamps and other accessories like I/J Hook & suspension clamp etc. (All material will be provided by contractor except ST-Pole).
Stringing and sagging of LT line on ABC 3x120+1x95+1x16 Sqmm including jumpering with clamps as per norms.
Erection and commissioning of LT distribution box 03 phase on LT- poles with connection from lines by Pearcing/PG clamps and fixing of other required clamps (All materials will be provided by contractor except LT-Distribution box).
Disconnection of existing service cable of consumers and reconnection of service cable from LT- DB after commissioning of LT- Distribution Box.
Supply and fixing of required nut and bolts of different sizes
Removing of old conductor of LT-line, rolling back and carriage upto dump store.
Dismantling of old pole (STP/PCC) of existing 11 KV & LT line.
Safe Dragging, loading, carriage and unloading of balanced materials/dismentalled materials with proper stacking from site to JE dump store/Lesa store after completion of work.
ARIHANT ELECTRIC COMPANY
Sidhi Enterprises
CHAUHAN ELECTRICALS
stage.html
html • 0.03 MB
tech_bid_open.pdf
tech_eval.pdf
boq_comp_chart.xlsx
xlsx
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Download all tender documents and submit your bid