Repair and Maintenance of PHC Nanwana

Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 (fifty) metres lead as per the direction of the Engineer-in- Charge nominal concrete 1:3:6 (one Cement : three coarse sand : six graded stone aggregate 20 mm (twenty millimetre nominal size) or richer mix (i/c equivalent design mix) including entire carriage of materials within all leads and lifts and other incidentals . The rates are inclusive octroi , royality , Malkana, toll tax, GST or other taxes imposed by the Government.

Repairs to plaster cement mortar 1:4 (one cement four sand) of thickness 12mm to 20 mm (Twelver milimetre to Twenty milimetre) in patches of area 2.5 sqm (Two point five Square metre) and under including cutting the patch in proper shape, raking out joints and preparing and plastring the surface of the walls complete, including disposel of rubbish to the dumping ground all complete as per direction of Engineer-in charge. including entire carriage of material with in all leads and lifts and other incidentals .The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Making plinth protection 50mm (fifty millimetre) thick of cement concrete 1:3:6 (one cement : Three coarse sand (zone - III) : Six graded stone aggregate 20 mm (twenty millimetre) nominal size) over 75mm ( Seventy five milimetre) thick bed of dry brick ballast 40 mm (fourty millimetre) nominal size, well rammed and consolidated and grouted with fine sand, including necessary excavation, levelling & dressing & finishing the top smooth. as per direction of Engineer-in charge. including entire carriage of material with in all leads and lifts and other incidentals .The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing 35mm (thirty five millimeter) thick ISI(Indian Standards Institute) (indian standared institute) marked factory made flush doors shutters conforming to IS : 2202 (Part I) (Indian standard : two thousand two hundred two part one) decorative type, commercial board phenol bonded termite resitant and water proof core of block board construction with full frame of 1st class hard wood well matched commerical 3( Three) ply venrring with vertical grains or cross bands and face venrres on both face of shutter 35mm (Thirty five millimeter) thick i.e. ISI(indian standard institute)marked stainless steel but hinges with necessary screws complete all floor level including entire carriage of materials in all leads and lifts and as per drawings and technical specifications as per the direction of Engineer-in-Charge including all incidentals.The rates are inclusive of octroi, royality, malkana, toll tax, GST or other taxes imposed by the Government.

Providing and fixing PVC rigid foam sheet 1 mm (one millimetre) thick on existing door shutters (bathroom and W.C. doors) using synthetic rubber based adhesive as per the direction of Engineer-in Charge including entire carriage of material in all leads and lifts . The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and laying Duro stone vitrified tiles (300x300mmx10mm) (three hundred into three hundred millimeter into ten millimeter) Kajaria , NITCO in grey/coloured of required shade in flooring treads of steps and landing laid on a bed of 12mm (twelve millimetre )thick cement mortar 1:3 (one cement : three sand) laid over and jointed with neat cement slurry finished with flush pointing in white cement mixed with pigment of required shade to match the shade of tiles complete as per the direction of Engineer-in-Charge including entire carriage of material in all leads and lifts and other incidentals. The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and laying kajaria/ Nitco make white glazed tiles 6 mm (six millimeter) thick size 30x45cm (thirty into fourty centimetre) in flooring, treads of steps and landing laid on a bed of 12 mm(twelve millimeter ) thick cement mortar 1:3 (one cement : three sand) and jointed with cement slurry, finishing with flush pointed in white cement including entire carriage of material in all leads and lifts and other incidentals. The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gms/litre (fifty gram per liter) , of approved manufacturer, of required shade and colour complete, as per manufacturer’s specification and as per the direction of Engineer-in-Charge including entire carriage of material in all leads and lifts . The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and applying Birla white cement based putty of average thickness 1 mm, (one millimetre) of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete including entire carriage of material in all leads and lifts . The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Finishing with Deluxe Multi surface paint system for interiors and exteriors using Primer as per manufacturers specifications for Painting wood work with Deluxe Multi Surface Paint to give an even shade two or more coat applied @ 0.90 ltr/ 10 sqm (zero point nine zero liter/ ten square metre) over an under coat of primer applied @ 0.75 ltr/ 10 sqm(zero point seven five liter / ten square metre) of approved brand and manufacture including entire carriage of material in all leads and lifts . The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing water closet squatting pan (Indian type W.C. pan CERA, HINDWARE, PARRYWARE, mak ) with 100 mm (One hundrd millimeter) sand cast Iron P or S trap, 10 (ten) litre low level white P.V.C. (poly vinyl choloride) flushing cistern, including flush pipe, with manually controlled device (handle lever) conforming to IS : 7231 (Indian standard seven thousand two hundrd thirty one), with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required: White Vitreous china Orissa pattern W.C. (water closet) pan of size type foot rests 580x440 mm (Five hundred eighty into four hundred forty millimter) with integral complete at all floor including entire carriage of materials in all leads and lifts and as per drawings and technical specifications as per the direction of Engineer-in-Charge including all incidentals.The rates are inclusive octori, royality, Malkana, toll tax, GST or other taxes imposed by the Government.

Providing and fixing wash basin with C.I. brackets, 15 mm (fifteen millimetre ) C.P. brass pillar taps, 32 mm (thirty two millimetre) C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever require white Vitreous China Wash basin size 550x400 mm (five hundred fifty into four hundred millimetre) with a pair of 15 mm (fifteen millimetre) C.P. brass pillar taps as per the direction of Engineer in Charge including entire carriage of materials in all leads and lifts and as per drawings and technical specifications as per the direction of Engineer-in-Charge including all incidentals.The rates are inclusive octori, royality, Malkana, toll tax, GST or other taxes imposed by the Government.

Providing and fixing white vitreus china pedestal for wash basin completely recessed at the back for the reception of pipes and fittings of Jaguar Hindware / Cera make as approved by Engineer-in-Charge including entire carriage of material in all leads and lifts and other incidentals. The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing 32mm (thirty two millimetre) dia P.V.C waste pipe for sink or wash basin including P.V.C waste fitting complete and Cera, Hindware make as approved by Engineer-in-Charge including entire carriage of material in all leads and lifts and other incidentals. The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing 600x450 mm (six hundred into four hundred fifty millimetre) beveled edge mirror of superior glass (of approved quality) complete with 6 mm (six millimetre) thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete including entire carriage of material in all leads and lifts and other incidentals. The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing 110mm (One Hundred ten milimetre) dia ISI marked high pressure PVC spigot and socket waste and ventilating pipes including fixing with approved adhesive etc. including entire carriage of material in all leads and lifts . The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing G.I. Pipes complete with G.I. fittings including trenching and refilling etc. External work. 15 mm (fifteen millimetre) dia nominal bore including entire carriage of material in all leads and lifts and other incidentals. The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government

Providing and fixing C.P. brass bib cock of approved quality conforming to IS:8931 15 mm (fifteen millimetre) nominal bore Jal, Hindware or Cera .including entire carriage of material in all leads and lifts and other incidentals. The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing 1.5 mm (One point five milimetre) C.P. brass long body bib cock of approved quality conforming to IS standards and weighing not less than 690 gms. including entire carriage of material in all leads and lifts . The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.

Providing and fixing 15 mm (Fifteen milimetre) C.P. brass stop cock (concealed) of standard design and of approved make conforming to IS:8931 including entire carriage of material in all leads and lifts . The rates are inclusive of octroi, royality malkana ,toll tax, GST or other taxes imposed by the Government.