SPL REPAIR TO LT UG CABLE AT 5682 ASC BN (MT) OFFICE AREA AND PROVN OF 120 HP CENTRIFUGAL PUMP WITH ALLIED WORKS AT MIL STN KALKA UNDER GE JUTOGH

Amount

Excavation in trenches in soft/loose soil n.exc 1.5 Mtr deep and n.exc 1.5 mtr wide for laying of cable and getting out including dressing/trimming of sides and leveling, grading and ramming of bottom of excavation complete all as specified and directed.

Returning, filling, including leveling , watering and well ramming excavated soil in layers n.exc 25cm thick in trenches after laying of cable have been laid complete all as specified and directed.

Removing of excavated surplus soil obtained from excavation to a distance n.exc 50 mtr and depositing where directed at a level n.exc 1.5 mtr of the starting point complete all as specified and directed .

M&L for PCC 1:3:6, type C-2, using 40 mm graded crushed stone aggregate as in foundation filling and mass concrete, complete all as specified and directed.

Dismantling of old unserviceable ACSR conductor any size complete and deposit to MES Store Yard complete all as specified and directed.

Dismantling cross-arms of M.S. channel or angle sections etc complete and deposit to MES Store Yard complete all as specified and directed.

Dismantling insulators any type, any size complete and deposit to MES Store Yard complete all as specified and directed.

S&F or passing through pipe, XLPE insulated, Armoured, Electric power under ground cable (Heavy duty) with aluminium conductor, 1100 volts grade, nominal cross sectional area 120 sqmm 3.5 core including Brass compression cable gland, terminal lug etc and testing complete all as specified and directed.

S&F or passing through pipe, XLPE insulated, Armoured, Electric power UG cable (Heavy duty) with aluminium conductor, 1100 volts grade, nominal cross sectional area 95 sqmm 3.5 core including Brass compression cable gland, terminal lug etc and testing complete all as specified and directed.

S&F or passing through pipe, XLPE insulated, Armoured, Electric power UG cable (Heavy duty) with aluminium conductor, 1100 volts grade, nominal cross sectional area 70 sqmm 3.5 core including Brass compression cable gland, terminal lug etc and testing complete all as specified and directed.

S&F or passing through pipe, XLPE insulated, Armoured, Electric power UG cable (Heavy duty) with aluminium conductor, 1100 volts grade, nominal cross sectional area 10 sqmm 2 core including brass compression cable gland, terminal lug etc and testing complete all as specified and directed.

M&L for duct pipe double wall , corrugated HDPE 80mm outer dia conforming to IS:14930 (Part- II) of approved colour with fittings for cable protection complete all as specified and directed.

M&L for duct pipe double wall , corrugated HDPE 50mm outer dia conforming to IS:14930 (Part- II) of approved colour with fittings for cable protection complete all as specified and directed.

M&L for GI pipe light grade of size 50mm dia laying in trenches/ under floor/on walls for protection of under ground cables complete all as specified and directed

S&F KIOSK box weather proof made out of PVC including made out of one piece mounted SMC base and door pole mounted hinged door size 333 x 233 x 200mm out side and 300 x 200 x 105mm inside dimension comprising of aluminum bus bar 4 strips for 3 phase and neutral suitable up 100 amp and 10 Amp MCB SP for controlling the street light fitting including FI clamps with necessary MS nuts bolts and washer complete all as specified and directed. Make: SINTEX cat pat no GS JB 3020 or equivalent in FINOLEX/ UNIVERSAL/ SWITCH GEAR/ HENSEL

S&F of busbar box of capacity of outdoor type made of CRCA sheet duly powder coated and suitable size angle iron frame having aluminium bus bar 200Amp for three phases and one neutral, duly covered with PVC colour coded sleeves, mounted on porcelain insulators, 415 Volts, 50 Hz, AC supply with including MCCB 160 Amps 4 pole, 25 KA as incommer complete with necessary foundation with PCC etc complete all as specified and directed.

Supplying, fabricating, installing, testing and commissioning of outdoor type LT feeder pillar box of suitable size, factory fabricated, cubical panel, floor mounted, double door, dust and vermin proof, made out of 3.15 mm thick CRCA sheet, mounting angle iron frame incl suitable PCC to be fixed above 60cm from GL, 150 mm thick PCC (1:3:6) type C-2 with 100 mm offset on all sides, with front and back opening and locking arrangement, finishing with two coats of powder coated paint of approved shade over one coat of red oxide zinc chrome primer incl aluminium bus bar of rating 400Amp for three phases and one neutral, duly covered with PVC colour coded sleeves, mounted on porcelain insulators, 4 wire, 415 Volts, 50 Hz, AC supply incl suitable size of copper cable for control wiring, necessary cable glands, lugs etc, proper arrangement for ventilation and providing the following accessories:

MAIN INCOMMER

MCCB 4 pole, 250 Amps 25 KA -01 No

LED Indicating lamp on incoming side- Set of 3- 01 no

Supplying, fabricating, installing, testing and commissioning of outdoor type LT feeder pillar box of suitable size, factory fabricated, cubical panel, floor mounted, double door, dust and vermin proof, made out of 3.15 mm thick CRCA sheet, mounting angle iron frame incl suitable PCC to be fixed above 60cm from GL, 150 mm thick PCC (1:3:6) type C-2 with 100 mm offset on all sides, with front and back opening and locking arrangement, finishing with two coats of powder coated paint of approved shade over one coat of red oxide zinc chrome primer incl copper bus bar of rating 400Amp for three phases and one neutral, duly covered with PVC colour coded sleeves, mounted on porcelain insulators, 4 wire, 415 Volts, 50 Hz, AC supply incl suitable size of copper cable for control wiring, necessary cable glands, lugs etc, proper arrangement for ventilation and providing the following accessories:

MAIN INCOMMER

MCCB 4 pole, 100 Amps 16 KA -01 No

LED Indicating lamp on incoming

M&L for earthing complete with galvanized steel plate earth electrode 60cmx60cmx6mm thick surrounded by char coal and salt buried directly in ground vertically in pit of depth not less then 2.25 mtr below ground level with top edge of the earth plate at depth of not less then 1.5 mtr below ground level surrounded from all sides by char coal dust and common salt in alternate layers of 15 cm depth and earth plate electrode connected to galvanised earth means of GI Strip 25X4 mm at two points by means of GI nuts bolts, check nuts and washers and connected to earthling test point drawn through 40mm dia GI pipe for protection of earth lead wire , GI pipe 20 mm dia for watering incl PCC earth pit (1:3:6) type C-2 with CI frame and RCC cover all as shown in electrical Plate No 3 on SSR Part-I including testing earthing all as directed. Note: (i) Rate of Earth work, Earthing electrode, all connections, nut-bolts, washers, complete labour, testing, Earth lead upto 7.5 mtr, char coal dust, common salt, porcelain insulator, PCC earth Pit, CI frame ,RCC cover, funnel with wire mesh are incl in quoted rate and watering pipe, earth lead protection pipe, test poit, earth lead up to 7.5 mt .

Supply & installation and testing of 120 HP Horizontal Multistage Pump , Seven Stages of Head 210 Mtrs and Min dischage 90 m³/hrs including allignment with existing Motor of Kirloskar 120 Hp ,2960 rpm , 415 V complete all as specified and directed. The following items are deemed to be included in the quoted rate for smooth functioning of pump set complete :-

Tyre coupling of size TC/M/017 with hub and Flange complete and making hole in the Hub matching with existing motor shaft with key way hole in shaft complete.

Nut and Bolt required for fixing of pump set with existing foundation etc .

Necessary cutting/welding required for fixing of pump set with existing pipe incl necessary bend, tapper with flange, nuts , bolts & washers etc complete as per site condition.

25 mm dia Gate valve with fixing arrangement in existing pipe line - 01 No for air release at delivery side.

PCC 1:2:4 for foundation as per site requirement.

Any minor parts if required for smooth functioning of pump set shall be provided by the contractor without any extra cost.

Make of Pump: KIRLOSKAR Model No: RKB 65/19L/ BEACON/ KSB/ MATHER & PLATT/ GRANDFOS/ WASP/ ITT/ CRI

M/S Sonu Traders

R D Bansal

Dharm Singh Contractor

KATWAL TECHNOCRATS