Special Repair of Kaithal Quatabpur road Road ID 7090 in Kaithal Distt

Amount

Providing and applying tack coat with penetration grade bitumen VG-10 using bitumen pressure distributor at the rate of 0.30 kg per sqm on the prepared bituminous/granular surface cleaned with mechanical broom as per technical clause 503 of MORT&H specifications. (HSR 17.26.2)

Providing, laying and rolling of open-graded premix surfacing of 20 mm thickness composed of crushed stone aggregates of specified grading premixed in a continuous type of hot mix plant of appropriate capacity not less not less than 75 tonne per hour, with bituminous binder VG - 10 @ 1.46 kg per sqm, laid with Paver Finisher Mechanical and rolling with a smooth wheeled roller 8-10 tonne capacity, finished to required level and grades complete as per technical clause 510 of MORT&H specifications. (Based on HSR 17.33.1)

Providing and laying of premix sand seal coat premixed in continuous type HMP of appropriate capacity not less than 75 tonnes/ hours using specified fine aggregates and penetration grade bitumen @0.68 kg/sqm laid to specified levels, grade and cross fall complete as per technical clause 511 of MORT&H specifications. (Based on HSR 17.36.3)

Providing and laying of Hot Applied Thermoplastic Compound 2.5 mm thick including Reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35. The finished surface to be level, uniform and free from streaks and holes. Note:- Before start of work the contractor shall give brand, batch no., manufacuring date of the material to be used and get approved the same from Engineer-in-Charge before use. (HSR 34.26)

Reinforced cement concrete M25 grade village board size 1.85 x 0.90 x 0.075 of standard design, fixing in position including painting and printing etc. complete as per PWD Specifications, minimum reinforcement 16 Kg, Embedded in Ground up to 55 cm, in M-15 Concrete foundation 600 x 700 x 145 mm, as per Haryana PWD specificaiton. Village Board (HSR 34.27.5)

Construction of embankment (for berm) with approved material obtained from borrow pits, including compensation of earth, with all lifts and leads transporting to site, spreading grading to required slope and compacting to meet requirement of table 300-2, as per technical clause 305 of MORT&H specifications. (HSR 17.6) Note:- No earth work will be allowed to be taken from PWD B&R / ROW except for surplus earth after apporved from Engineer. Note:- Basic rates mentioned in BOQ are inclusive of all taxed (i/c GST), duties, cess, royalties etc. In case of any difference in the unit & nomenclature of any of the HSR Items depicted in this DNIT and that given in HSR, the unit and nomenclature given in HSR shall be applicable.

Ms Subhash Chander and Co Kaithal