ELECTRICAL WORK

Amount

fo|qr uxjh; forj.k e.My&f}rh;] xkft;kckn ds vUrxZr fo|qr uxjh; forj.k [k.M&X;kjg] xkft;kckn ds dk;Z{ks= esa vfrfjDr fctusl Iyku en esa 02 ux 250 ds0oh0,0 ifjorZd LFkkfir djuk] dsfcy Mkyuk o dsfedy vfFkZax vkfn dk dk;Z okg~; ,tsUlh ds ek/;e ls djkus gsrqA

Construction of plinth of size 2MX2MX1.5M above ground level and one ft. below the ground level of 9”. After excavation of 4” earth, brick ballast shall be provided and rammering will be done properly after that a retaining wall of 9” width by first class brick in ratio 1:4 of cement and sand shall be made. The earth shall be filled upto one ft. below the top of the plinth. After this brick ballast shall be provided upto 6” from the earth level and froper rammering shall be done. One no. jaal of 12mm MS Tor shall be fixed in the hollow of the plinth and one ft. thick RCC in 1:2:4 ratio of cement , sand and stone ballast shall be laid on the top of the plinth. The 12mm thick plastering shall be done all around the plinth in ratio 1:4 ratio of cement and sand. The contractor shall be responsible to complete the work as per direction of supervising Engineer. It includes the cost of labour, T&P, carrier etc. required for proper completion of the work (This material will be provided by the Contactor).

Fabrication of wire mesh fencing frames of different size fabricate out of MS angle iron of size 3x3x2M. Each frame duly welded and fixing with wire mesh of size 25x25x10 SWG hot dipped galvanized within the frame pressed under MS flats of size 40x5mm inside the angle on all four side with help of approx. 20No. Bolts & Nuts of 10mm diameter 45cm legs of frame will be grouted in 1:2:4 cement coarse sand and 20mm gauge stone blast in the size of 0.22x0.22x0.45meter. Each will be painted with one coat of red oxide and two coat of Alluminium paint of approved mark after proper cleaning. Fixing of wire mess fencing around on plinth of T/F with wire gauge 25x25mm, MS Angle 35x35x5mm with gate.

Safe Carriage of LT ABC (3x120+1x70+1x16) SQ MM from Store Centre Sahibabad/ Ghaziabad/Noida to site of work including loading and unloading at both ends.

Safe Carriage of LT AL. Cable (3x185 SQ MM) from Store Centre Sahibabad/ Ghaziabad/Noida to site of work including loading and unloading at both ends.

Safe Cartage of 250 KVA Transformer from Store Centre, Sahibabad/Ghaziabad/Noida to site of work including loading & unloading at both side and Installation with Complete work as per requirement of site including all the accessories.

Carriage of ST Pole 11 Mtrs. Long from Store Center Sahibabad/ Ghaziabad/Noida to site of work including loading & unloading at both side and Installation with Complete work as per requirement of site including all the accessories.

Carriage of PCC pole 8.5 Mtrs. Long from Store Center Sahibabad/ Ghaziabad/Noida to site of work including loading & unloading at both side and Installation with Complete work as per requirement of site including all the accessories.

Earthing of Pole by M.S. Earthing Rod size 20x2500 mm & 6 SWG Earthing wire & GI wire/earth wire etc. (All the required material shall be provided by the contractor). Complete work as per requirement of site and as per RESPO norms.

Laying of LT AB Cable (3x120+1x70+1x16 SQ.MM) as per RESPO norms.

Laying of LT AL. Cable (3x185 SQ MM) as per RESPO norms.

Work of Chemical Earthing of 250 KVA TF 02 Body & 02 Neutral with all material provided by the contractor. Complete work as per RESPO norms.

Carriage of 11KV Cable Jointing kit of size 3x185 Sq.mm Outdoor from Store Center Sahibabad/ Ghaziabad/Noida to site of work & Fixing the same as per RESPO norms.

Providing & Fixing Stone Pad as per RESPO Norms.

Providing & Fixing Pole Clamps with Nut & Bolts as per RESPO Drawing.

Providing & Fixing Suspension Clamp with I-Hook as per RESPO Drawing.

Providing & Fixing Dead End Clamp with I-Hook as per RESPO Drawing.

Providing & Fixing 3 Phase Distribution Box as per RESPO norms.

Providing & Fixing PRC Clamp as per RESPO Drawing.

Providing & Fixing M.S. Angle 50x50x6 mm as per RESPO Drawing.

Providing & Fixing M.S. Channel 100x50 mm as per RESPO Drawing.

Providing & Fixing GI Stay Wire 4mm 7/8 SWG as per RESPO Drawing.

Yash Contractor