Fabrication work

Supply, Fabrication and installation of shade of existing DG The shade is fabricate 40mm X 40mm X 5mm hallo Squre bar, 25mm X 25mm X 5mm hallo Squre bar, 8 ft Long X 3.5 ft wide G.I. Carrougated tin, G.I. Strip 3/4" dia nut bolt washer for fixing Carrugated tin, 4" Long G.I. nut bolt washer for fixing the Corrugated tin to the reqd. Squre bar, and Galvanized D iron clamp. The total Streutre Painting by 1 coat of RO Primar at 1 Cote of Synthatic enamel Paint. (Make- TATA/SAIL/Jindal for structural steel) Approx Size of Shade:- L-25', W-13', H-12' (2' grounding) (TOP-25' x 13', DROP-25' X 3' = 2 side 13' X 3' = 2side, Cutchi - 8' X 2' )

Supply & Fixing 6Nos 75mm X 75mm X 5mm hollow Squre bar 10' (include. 2' Grounding) including 2" Grounding the bar by sand, cement stone etc. (Make- TATA/SAIL/Jindal for structural steel)

Supply & errection of special type net guard of giving deep fabrication to suitable M.S. angle, flats and the Section 1.4"x1.4" 10 SWG welded mech I.R.C. netting suitable for fixing on covering the existing Ductable Ac Remote Set should be sterdely and electri- cally welded in a measurement of front side of the board should be covered by 2 Nos. door palla made of 19mm X 5mm flat (column & vertical) and net guard structure should be made of 25X25X5mm angle left & right side of the vacant place will be covered by 1.4"x1.4", 10SWG I.R.C. Net & also raised on same combination be covered by 10 SWG I.R.C. Net with help of reqd. angle & flat to cover up fabrication will be complete in a compact position finally the protection should be painted with moisture proof red oxide primer & approved paint. (Make- TATA/SAIL/Jindal for structural steel) Approx Size:- i) 20' x 7' = 2 side ii) 10' x 7' = 2 side

Defect Liabibility Period 1 (One) years

Make & model of each and every material to be approved by EIC

Please Enable Macros to View BoQ information