Loading
Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | 1₹1.1 LAccepted-Finance 36 137 THANGAMAPURIPATTINAM METTUR DAM 636 401 | METTUR DAM | SALEM | TAMIL NADU | 636401 | 1 | Accepted-Finance SATISFIED |
Tender Value
Refer Docs
EMD Value
₹1,600
Closing Date
28 Dec 2020, 2:00 pmClosed
SE/M-II/MTPS-I
Superintending Engineer Mechanical-II Mettur Thermal Power Station-I Mettur Dam- 636406 Salem District
MTPS I CHP I Replacement of existing 418KW 6.6 KV HT induction motor in the conveyor 7A location Sl No 3860102 2 by spare motor SI No 3860102 1
2020_EB_187298_1
SE M II MTPS I CHP I OT 123 2020 2021
Open Tender
Miscellaneous Works
Works
15 days
MTPS-I
As per Tender Specification
6 documents required · 6 mandatory
₹0
₹1,600
Yes
4 Jan 2021
9 Dec 2020
29 Dec 2020
9 Dec 2020
28 Dec 2020
9 Dec 2020
Amount
Replacement of existing 418KW HT induction motor by spare motor Charges for removing conveyor 7A motor bed bolts and nuts. Releasing the motor with fluid coupling from gearbox by using electrical hoist. Removing fluid coupling from the motor shaft using puller.
Charges for decoupling gearbox pulley flexible coupling. Removing brake assembly for alignment Checking. Normalizing the above after completion of the work.
Charges for assembling the fluid coupling in the new motor shaft, lifting, positioning the motor with gear box. Motor bed bolt tightening. Filling fluid coupling oil to the required level and conducting trial run of conveyor 7A.
Charges for alignment of motor with gear box and checking the trial run.
Charges for disconnection of 6.6 KV power cable of existing motor and reconnection of 6.6 KV power cable in new spare motor.
Complete overhauling of 418 KW HT induction motor released in conveyor 7A location Releasing the fan & end cover, threading out the rotor for inspection, complete cleaning of stator and rotor.
Checking the tightening of all the loose wedges, replacement of damaged toxolite strip and wedges, drying out stator and pre-heating, spraying one coat of Dr.Beck protective enamel and packing the same. Replacement of all wornout rubber gaskets.
Cleaning the cooler, cooler tubes with compressed air and pull through and arresting the vibration in cooler, checking of bearings and replacing the bearing and provision of greasing copper tube. (Bearing will be supplied by Board at free of cost)
Assembling of the motor and threading in the rotor, assembling of bearings, cooler fan, cooler and end cover after overhauling. Painting the HT motor and cooler with two coats of D.A Grey enamel paint including labour and material.
stage.html
html • 0.03 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .