PROVISION OF WAITING SHED CUM BUS SHELTER NEAR TCP-02 AND PROVISION OF VIEW CUTTER AT MIL STN ABOHAR

Amount

Surface excavation n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out on soft or loose soil

M&L Hardcore of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface with broken bricks

M&L for PCC 1:3:6 Type C-2 (40 mm graded aggregate ) 75 mm thick as in sub base all as specified.

Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc.,of required strength, thickness & size/ shape, made by table vibratory method in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand and complete all as specified and directed by Engineer-in-Charge.

Excavation in post holes each n. exc. 0.50Cum, getting out in soft/loose soil, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers n. exc. 25cm, watering and removing surplus soil to a distance n. exc. 50m and making good surface.

M&L for PCC 1:2:4 type B-2 using 40mm graded stone aggregate as in foundation of cols, bdy pillars, posts, struts, etc. filling and mass concrete complete all as specified and shown on drawing.

S&F Structural steel work in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes grade St-240 complete all as specified and as shown on drawing.

S&F mild steel purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc.

S&F MS Plates (plain or chequered) channels, square cut or notched (ordinary and ounter sunk) forming holes, without any attachment

S & F exc 12mm dia & n. exc 20mm dia exc 30mm long MS screw bolt machine made with hexagonal or Square head at one end and screwed the other,screwed end fixed with washer complete

S & F Pre- painted galvalume Cladding aluminum zinc coating GI based corrugated steel sheet 0.55mm thick of an colour having tensile strength of 550 Mpa as in roof covering / cladding to wall, fixed with self tapping screws as specified

M&L for preparation of steel surfaces of any description over 10cm in width or girth not otherwise described and applying 2 coats of Synthetic enamel paint over a coat of red oxide primer, all as specified and directed by Engr-in-Charge.

M&L for Brick work using fly ash bricks, straight or curved on plan exc 6m mean radius built in cement mortar (1:6) complete all as specified and directed by Engineer-in-Charge.

M & L for rendering 15 mm thick on brick work or concrete surface in CM 1:6 finishing even and smooth without using extra cement, all as specified and directed by Engr- in- charge.

M&L for three coat white wash to the wall surfaces after preparation to the new plastered surfaces

Dismantling fencing wire mesh, any type complete all as specified

Dismantling posts or struts (wood, steel or R.C.C.) embedded in concrete ,bricks work, masonary,eyc any section, including taking out embedded portion and making good disturbed ground

S&F angle iron post and struts in fencing incl cutting tops to shape as directed drilling holes, notching for wire, etc flat iron fillets (for securing wire mesh etc incl all necessary drilling, bolting or riveting, etc and similar work conforming to FE-290 Gde E-165

Supply only chain link 4mm dia MS galvanisd fencing, of 100x100mm mesh size or type complete all as spd and diercted.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed.

M&L Mild steel round bars bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

S&F Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as specifiednand directed.

S&F Garden bench of size 1500mmx450mmx600mm (Seat ht-330 mm) of cast iron leg/side support and powder coated mild steel seat and back , minimum weight 70 KG,colour all as specified and directed.

S&F Rolled sections/Squre Pipes as in framing for cladding, glazing and the like fixed with angle cleats and connecting plates, etc.

S&F Fibre glass reinforced translucent corrugated sheeting with two corrugations side lap fixed with and including coach screw, bolt and washer in roof, wall etc.

M&L for Point wiring complete with ISI marked 2.5 sqmm single core PVC insulated unsheathed cable 1100V grade FRLS with multistranded copper conductor drawn through concealed in wall/ceiling surface and its accessories including PVC rigid concealed conduit heavy duty suitable size with all accessories such as bend, reducers, MS hooks, MS junction boxes, 2mm thick galvanised steel pressed sunken terminal boxes of suitable sizes for mounting of modular switchs, sockets, fan regulator etc covered with Modular sheet and covers sheet of required size fixed with brass screws and cup washers painting terminal boxes inside and outside with one coat red oxide primer including fixing and 2.5 sqmm copper conductor as earth continuity to connect common earth dolly completed, cost of modular sheet and cover are included in the item rate complete following all as specified

One light point/Fan point/Exhaust controlled by one way switch

One 5 pin socket out let 5 amps on the same board with other switches

One 5 pin, 5A socket outlet point on independent board with other switches.

All as per item no. 26 here-in-before but with 4.0 sqmm cable for 1No 16 amps socket outlet point on independent board including 4.0 sqmm PVC insulated unsheathed cable multistranded with copper conductor green in colour as earth continuity conductor all as specified

S&F Modular switch 1 way 6 Amps, 1 module 230 volt AC supply complete all as specified

S&F Modular Socket, 6A - 2/3 pin combined 2 module, 230 volt AC supply complete all as specified.

S&F Modular switch 1 way 16A, 1 module 230 volt AC supply complete all as specified

S&F Modular Socket 6A/16A - 2/3 pin combined, 2 module, 230 volt AC supply complete all as specified.

S&F Ceiling rose surface type, 65mm x 50mm three terminals, 3 phase / PVC / polycarbonate isolated body all as specified.

Supply and fixing LED lights fitting 20 W, 220V, AC decorative box type with driver, holder including LED tube light connecting up with three core flexible copper conductor cable of suitable size from ceiling rose complete.

S&F sheet metal enclosure for DB's SPN 230 volts 12 way with 200 amps rated bus bar neautral link, earth bar double door complete all as specified

Supply and fixing amp rating 240V, 10KA 'C' curve miniature circuit breaker (MCB) of 6-32 Amps Capacity double poles in the MCB DB complete with connection testing and commissioning complete all as specified

Supply and fixing 240V, 10 KA 'B' curve miniature circuit breaker (MCB) of single poles and current carrying capacity 6 to 32 AMP, in the MCB DB Complete with connection testing and commissioning complete all as specified

Supply and fixing ceiling fans copper winding, complete with blades, down rods, electronic regulator and accessories, 230 V, 1200 mm sweep. Min air delivery 210 CFM with service value 6.00 BEE Five star rated with brushless direct current motor (BLDC) complete including hanging provision all as specified and directed.

Supply, laying and testing cable XLPE Insulated ,screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 10 sq mm 2 core complete.

M&L for Excavation in trenches any type of soil , n exc 1.5m wide and n exc 1.5m in depth , for foundation , etc or for shaft, well, cesspits , manholes , pier hole etc n exc 1.5 m in depth and getting out for laying of cable complete all as specified and directed.

M&L for Returning , filling in including, spreading , leveling , watering and well reaming in layers not exc. 25 cm within the 1 mtr stretch complete all as specified and directed.

M&L for Removal of excavated material to a distance not exc 50 mtr and depositing where directed at level not exc 1.5 mtr above the starting point complete all as specified and directed.by Engr-in-charge

Supply and laying Double wall corrugated (DWC) Duct pipe-IS 16205 (electric Cable use) for cable protection laid length wise of size 50 mm outer and inner dia complete all as specified and directed by Engr-in-charge.

M/s G.V.T. Constructions (BID ID -3485108)

SHRI SHYAM CONSTRUCTION CO. (BID ID -3488373)