MTPS I CA CWS II Cleaning and Painting of cooling water pumps discharge pipe lines and Supporting Structures of Unit III and IV

Amount

Charges for cleaning, removing of all the rust and old paint at the outer surface of cooling water pump discharge water line and its pipe supports, Cooling water pump discharge elbow body and cooling water pump gland cooling water tank & its inlet and outlet water lines etc.

Charges for cleaning and painting of two coats of enamel paint over the cooling water pumps discharge elbow body (outer surface – Grey), Discharge pipe lines ( sea Green), Butter fly valve and pipe supports (P.O. red) one over the other.

Charges for complete cleaning rust with wire brush, applying one coat of rust remover, again cleaning the rust, applying one coat of epoxy red oxide primer and one coat of epoxy high built coal tar one over the other for the cooling water pump ring guard on both sides, Element – III (0.4 m height), inner side of discharge elbow body, gland cooling water tank & its inlet, outer water lines, cooling water pump safety floor grills, Re- circulating water valves and Air release valve etc.

Cost of Paint Rust Convertor for SL.No. 3

Cost of Paint Epoxy red oxide primer for SL.No.3

Cost of Paint Epoxy High built coal tar for SL.No.3

Cost of Paint Epoxy Thinner for SL.No. 3

Cost of Paint Enamel Sea Green paint for SL.No. 2

Cost of Paint Enamel Post P.O Red paint for SL.No. 2

Cost of Enamel Grey paint for SL.No. 3

Cost of Enamel Black paint for SL.No. 3

Cost of Enamel Dark Mint Green Paint forSL.No. 3

Cost of Enamel Paint Thinner for SL.No. 2 & 3

Consumable and T&P Cost for SL.No. 1,2 & 3.

LENIN ENGINEERING WORKS (BID ID -1088822)

P.K.ENGINEERING (BID ID -1089220)