PROVN OF STATIC WATER TANK CAPACITY 10 KL FOR KSP WATER STORAGE TANK FOR WP AMN NEAR BLDG NO T-10 T-11 AND 02X LIGHTNING CONDUCTOR NEAR BLDG NO T-6 T-7 AT JAT HILL AT CHAKABAMA MILITARY STN UNDER AGE I ZAKHAMA STATION

Amount

Excavation over area, n. exc 1.5m in depth and getting out in hard/dense soil complete all as specified and as directed.

All as per item serial No 01 here-in-before but depth exceeding 1.5 m and not exceeding 3.0m complete all as specified and as directed.

Excavation in trenches not exc 1.50 m wide and not exc 1.50 m deep for foundation or for shafts, wells cesspits,man holes, laying of cable etc not exc 10 Sqm on plan and n exc 1.5m in depth and getting out in hard/dense soil complete all as specified and as directed. hard/dense soil

Returning, filling, in soil including spreading, levelling, watering and well ramming in layers n.exc. 25cm thick complete all as specified and as directed.

Removing excavated soil to distance not exc. 50 m and depositing where directed at a level not exc. 1.5 m above the starting point etc complete all as specified and as directed.

M&L for hardcore with broken stone or boulder of gauge not exc 63 mm, deposited , spread and levelled in layers n. exc 15 cm thick, watered and rammed to a true surfaces complete all as specified and as directed.

M&L for PCC 1:4:8, type D2 (using 40mm graded stone aggregate) as in foundation, filling and mass concrete etc. complete all as specified and as directed.

M & L for 75mm thick PCC 1:3:6, type C2 (using 40mm graded stone aggregate) as in plinth protection, etc finished the surface even and smooth without using extra cement including provision of joint of size 10 mm wide & 10 mm deep and filling with bitumen mastic joint filling at every 3m length and at corners complete all as specified and as directed.

M&L for RCC M-30 design Mix (using 20mm graded stone aggregate) as in foundations, including rafts, footings, foundation beams, plinth beams, bases for columns, etc. basement slabs, under-reamed piles and mass concrete etc. complete all as specified and as directed.

M&L for RCC M-30 design Mix (using 20mm graded stone aggregate) as in walls, retaining walls,basement walls, ballast walls and the like; any thickness; above top of footings; including attached pilasters and buttresses foundations etc. complete all as specified and as directed.

M&L for RCC M-30 design Mix (using 20mm graded stone aggregate) as in slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and as directed.

Use and waste formwork to sides of concrete foundations, footing, bases of columns, plinth beams for rough finished surfaces of concrete complete all as specified and as directed.

Use and waste formwork to faces of walls,retaining walls and similar work including attached pillasters, buttresses, etc.; vertical or to batter complete all as specified and as directed.

Use and waste formwork to soffits of suspended slab such as roof slabs floor slabs, landings and similar work not exceeding 200mm thick (Horizontal or sloping) in rough finished flat surfaces of concrete complete all as specified and as directed.

M&L for mild steel TMT bars 10 mm dia and over cut to length, bent to shape as required including cutting, bending cranking, hooking end and binding with mild steel wire(annealed) not less than 0.9mm dia as in reinforcement bar complete all as specified and as directed

M&L for 10mm thick rendering in cement mortar (1:3), to fair faces of brick or concrete wall surfaces, mixed with water proofing compound (@ 3% by weight of cement or as per manufacture's instructions), finished the surface even and smooth without using extra cement complete all as specified and as directed. Note : Water proofing compound will be measured and paid separately as "Supply only".

M&L for 10mm thick rendering in cement mortar (1:4), to fair faces of brick or concrete wall surfaces, mixed with water proofing compound (@ 3% by weight of cement or as per manufacture's instructions), finished the surface even and smooth without using extra cement complete all as specified and as directed. Note : Water proofing compound will be measured and paid separately as "Supply only".

Supply only integral water proofing compound of approved make complete all as specified and as directed.

M & L for preparation of newly plastered surface of walls and applying three coats of white wash complete all as specified and as directed.

S&F cast iron work grade FG 150, unmatched in brackets, gully traps, grating, railing, frames, manhole covers, fire and soot doors, dampers, stop valve boxes, gate stops, pants of ranges and similar articles complete all as specified and as directed.

M&L for preparation of new steel or iron surfaces of any description over 10cm width or girth and applying two coats of synthetic enamel paints over a coat of red oxide, zinc chrome primer complete all as specified and as directed.

S & F GI tubing 25 mm bore, medium grade with all fittings, laid in walls or ceiling / trenches complete all as specified and as directed. Note : Excavation & earth work if any required shall be included in the quoted rate.

S & F GI tubing 20mm bore, medium grade with all fittings and fixed complete to walls and ceilings or laid in floors complete all as specified and as directed.

S&F stop valves/ angular stop valve, 20mm dia, cast copper alloy, fancy type, chromium plated, screwed down, high pressure with crutch or butterfly handle screwed both ends for iron pipe or unions complete all as specified and as directe.

S & F 20mm bore, gun metal, globe or gate valves, with iron wheel head, screwed both ends for iron pipe or for union complete all as specified and directed.

Supply, install, test and commission booster water mono block pump set of capacity 1.0 HP, 220/240 volts, 25x25 mm suction and delivery size, Head 6 to 39 miters, discharge 300 to 750 liter per hrs complete all as specified and directed. Make : Cromptorm Greves/Texmo/Kirloskar

S&F Fully automatic star delta starter single phase 220 volts induction motors including over load protection, under voltage relay, time delay relay, push botton for start/stop, including making connection with motor using single core unarmoured PVC sheathed 1100 volts grade copper conductor cable of suitable size as recommended by manufacturer for 1 HP motor complete all as specified and directed.

S&F 1100 volts grade heavy duty flat cable of size 4 Sqmm 2 core, PVC insulated aluminium solid conductor, served with inner sheathing of PVC tape and overall PVC sheathed in service connections suspended by insulating hangers not more than 1 m apart including replacing 4mm suspension wire complete all as specified and as directed.

M & L for Lighting conductor of Air terminal , single pointed ,copper rod 12mm dia and 300 mm long completed all as specified and as directed.

M & L for test point teminal block made of gun metal or phosphorus bronze size 75x75x25 mm ,drilled and screwed including 3 nos 8 mm 25 mm long hexgonal Head screw completed all as specified and as directed.

M & L for Copper strip 23 x 3.15mm to be fix on top of "V" type porcelain insulator or DMC insulator of suitable size and fixing screws etc. for roof conductors and down conductors above ground complete all as specified and as directed.

M&L for earthing complete with copper earth plate electrode 60cm x 60cm x 3.15 mm buried directly in ground vertically to a depth not less than 2.25 mtr below ground level with the top edge not less than 1.5 mtr below ground level connected to copper strip 32 X 6 mm as earth lead by means of bolts, nuts, check nuts and washers of steel and other end connected to earthing test point including funnel, watering pipe of 40 mm bore, light grade GI pipe, wire mesh, charcoal or coke and common salt in alternate layers all around the earth electrode compacted thickness 15 cm, earthing pit in PCC (1:3:6) type C1, 50 mm thick pre-cast RCC cover slab (1:2:4) type B1 set in CM (1:4), reinforced with 8 mm dia TMT bars @ 10 cm c/c and suitable handle of 10 mm dia MS round bars including earth work in excavation in hard and dense soil, disposal of soil not exc. 50 meter complete and testing on completion all as shown in electrical plate No-3 of MES schedule, part-I complete all as specified and as directed. NOTES 1). The unit rate include copper strip from top of earth plate upto 7.5 meter above ground level.

M/S ORIENTAL MOTORS COMPANY