Repair Servicing And Allied works of Departmental I FC Department Jammu Vehicle Ambassador Bearing Registration Number JK02AS9495 for smooth running of vehicle.

Repair/Replacement of old clutch set (clutch plate and pressure plate) by way of taking out of clutch unit after removal of gear box assembly and other allied parts. The clutch section to be dismantled. Clutch plate, Pressure plate, clutch cable and Clutch bearing are to be replaced by new spares. Entire clutch unit to be reassembled, clutch assembly to be checked accordingly for proper functioning. After that, entire clutch unit to be refitted to the proper position in the vehicle. Finally the gear box to be refitted to its position with clutch and propeller shaft after replacement of Gear oil by way of draining the old oil through drain plug and providing/filling of fresh gear oil (2 litres).The job includes replacement of wiper blades, accelerator cable by new spares ,replacement of engine oil by way of removing the drain plug ,draining the old oil and providing/filling of fresh engine oil (4.5 litres). The job also includes replacement of engine oil filter, oil separator and all the four spark plugs by new spares, replacement of timing belt, timing cover by new spares which involve disconnecting and keeping away of the negative battery cable, removing of the alternator belt, removing of timing cover, cooling fan, power steering, removing of belt off the crankshaft sprocket, removing of the crankshaft pulley and then removing the timing belt from the vehicle. Thereafter reinstalling all parts in a right way and reinstalling the new timing cover and connecting the negative battery cable to the battery. The job further includes repair of engine by way of repair to the cylinder head after disassembling of the same from engine block and then removal of old head gasket and cleaning of the surface of the cylinder head. Resurfacing the cylinder head with facing operation on lathe. The job includes grinding of engine valves by using proper grinding method so that the valves are effectively able to seal in the valve seat in the cylinder head to completely seal the engines combustion chamber. Before fitting the cylinder head and engine block providing/placing of new complete head gasket on the cylinder head. The job also includes replacement of coolant by using empty pan or container beneath the radiator and removing the drain plug of the radiator. Allow the old coolant to freely evacuate from the cooling system and observe the contents for dirt, floating particles. Flush the cooling system several times with water until the contents are clear. Reattach the drain plug on the radiator and fill the new coolant (4 litres) till it reaches the full mark. Start the engine and let it run briefly. Then switch it off and check the level of coolant. Observe if there are any leaks from the radiator, reserve tank or under the body. Top off the coolant to the full mark if required and close the radiator cap. Further the job includes wheels alignment, wheels balancing and bumper welding. Bumper repair should be performed by using proper welding process and good quality electrodes. The job also includes air conditioner service by way of dismantling and then cleaning all the parts of air conditioner and top up of refrigerant as per the requirement. Finally car washing/cleaning and other allied works to be performed. Checking and testing of the vehicle on road. Complete job includes Cost of spare parts, Skilled labour etc inclusive of all taxes.

Vaibhav Engineers and Technocrates (BID ID -2309447)

GEETA ENGINEERING MECH WORKS (BID ID -2309452)