Lifting and Re-lowering of submersible pump motor set with allied works at various MI scheme under Memari (A-I) Sub-Division

Charges for repairing continuity test, insulation test by Megger, no load test as per directioin of Engineer-in-Charge

Withdrawal of electro motor submersible pumping set of following capacities from within the tubewell housing pipe of the following length by using all necessary requisites tools and plants and carefully as per direction of Engineer-in-Charge and stacking the same properly at site within the tubewell premises complete. (a)100/150/200 cubic metre per hour capacity electro motor pumping set. (ii) Length of pump assembly of any length exceeding 18 metre length.

Installation of submersible electro motor pumping set of following capacities by using necessary requisite, tools and plants by lowering the same within the tubewell housing pipe upto the following depth as per direction by fitting, fixing column pipes and other accessories, fixtures with necessary nuts, bolts and washers and suspending the entire assembly of pump set vertically by fixing the same supported by M.S. clamps over the top of housing pipe, binding the motor cable with each column pipes and drawing cable upto pump controller/starter point including opening out of the top cap of housing pipe of the tubewell and testing of motor both in loading as well as in unloaded condition before and after installation of the same. (The rate is inclusive of hiring charges of tools & plants.) (a) 100/150/200 cubic metre per hour capacity electro motor pumping set. (ii) Length of pump assembly of any length exceeding 18 metre length.

Jointing water proof cable with the leads of the motor including soldering with requisite water proof insulation and proper jointing compound/Valcanized rubber tape so that prope water proof insulation is assured.

Carriage of Departmental materials from the Deparmental Store to the work site and return back the damaged/replaced and unused materials to store including loading & unloading complete at both sides by Tempo /Van Rikshaw/Mini Truck etc. upto 25 Km distance in one way. Pump-Motor Set (this item is applicable only for burnt/damaged Pump-Motor Set)

Supply of MS Hexagonal head Bolts & Nuts bearing IS-1363(Part-1)/1992 of product grade C with latest amendments for Bolts and IS 1363 (Part-3)/1992 of product grade C with latest amendments for Nuts properties/class for Bolt 4,6 for Nut 4,5 both Bolts & Nuts of various sizes ( M 10 to M24) incuding cost of carriage, loading & unloading of materials

Supply & transport of Rubber Insertion 5 mm Thick with proper reinforcement 2 (Two) ply conforming to IS 638/79 with ISI mark with latest ammendments suitable for MS Flange as per IS 6392/71 with standard drilled holes (Table-,17) 150 m Dia

Transportation of Submersible Electro Motor Pumping Set along with all other accessories and equipments including bend, sluice valve, coloumn pipes etc. from Sub-Divisional store to worksite including loadng at the lifting point and unloading at the delivery point and unloading at delivery point including necessary head load up to 100 meter at both ends. (A) Cariiage by road (a) Distance upto 50 Km. (i) 100/150/200 cubic metre per hour (m3/Hr) capacity electro motor pumping set with coloumn pipes set with coloumn pipes and accessories etc. ( full set)

Add GST @ 18%

Add Cess @ 1%

Please Enable Macros to View BoQ information