SITC of MRL Lift___Storied Barrack

Amount

SITC of Automatic Lift (as per manufacturer design & as per detailed specifications below conforming to IS) and putting into operation after final testing in the existing lift shaft complete with all accessories and repairing the damaged wall / floor if any etc. to complete as required.

Make: OTIS / KONE / SCHINDLER.

Type: Passanger Lift.

Load : 16 Passenger / 1088 Kg

Control: Microprocessor Based

Drive VF Regenerative (Closed Loop)

Machine: Energy efficient machine, Gearless, without Machine Room

Position of Machine Room: N. A.

Speed: 1.00 Mtrs./ Sec

Floor served: G + 4

Landing: 5 Stops & 5 openings, all on same side

Total Rise: 13.2 Mtr ( approx )

Operation : Full collective operation

Signals: Monochrome LCD Display for car and Hall button unit

Leveling accuracy: ± 5 mm (Micro levelling arrangement )

Car Dimensions: 1600 mm ( W ) x 1600 mm ( D ) x 2200 mm (H) or equivalent size.

Car Entrance: Clear Opening 1000 mm (W) x 2000 mm (H) protected with car door.

Car Enclosure: Stainless Steel sheet (20 SWG) with Hairline finish with hand rail.

Car Ceiling & Lighting: Stainless Steel with hairline finish with LED lighting and Fan

Car Ventilation: Pressure fan with anodised aluminium grill Or Cross flow fan

Car Flooring : Decorative granite flooring (As per direcion of EIC and according to this Department's Order).

Car Door: Stainless Steel centre opening automatic landing door.

Door Opening: Automatic power oprated door with full length light curtain sensor.

Car finish: Rear mid panel / Rear corner panel / side mid panel / side corner panels / Front panel- Stainless steel #4 (Hairline),

False ceiling type: False ceiling with LED Lighting

PROTECTIVE DEVICES & OTHER ACESSORIES

ARD: Automatic rescue device complete with dry maintenance free batteries as required for automatic evacuation to the nearest floor in case of power failure / single phasing/others.

Overload Protection: Fully loaded with overload protection.On overloading the lift car will not start with door remaining open and give audio display indication

Emergency lighting in car: Battery operated emergency lighting in the lift car.

Intercom system: Battery operated intercom system in Lift Car, Machine Room & Control Room

Emergency Alarm: Battery operated alarm bell system in lift car and control room

Fireman switch: Fireman switch at main landing terminal.

Voice Synthesizer: Voice announcement system (Voice Synthesizer) in the car to announce the position of the elevator in the hoist way as the car passes or stops at a floor served by the elevator.

Call Registration LEDs, OSG Electronic Switch, Full Length Infra Red Light Curtain Door Safety, Load Weight Device, Handrail inside the Car.

Main rope - As per manufacturer's standard conforming to IS

DIMENSION OF SHAFT & POWER SUPPLY

Available Shaft Dimension : 2550 mm (W) x 2100 mm (D)

Pit Depth : 1600 mm

Overhead : 4300 mm

Electric power supply: AC 415 Volt 3phase, 50 Hz,

Main rope / belt - As per manufacturer's standard conforming to IS

Standard features- Anti-nuisance car call protection Independent Service (For Duplex only) Infrared curtain door protection Door time protection Extra door time of lobby & Parking Door open/close button Belt inspection Drive Auto fan Cut Off fire rating 120 mins

Terms & Conditions (i) Rates should be quoted with minor civil works, wall cutting and mending good the damages to the original finish. (ii) Rate should be quoted inclusive of all applicable taxes and Duty etc. (iii) All materials, equipments & accessories must conform to relavent IS / IEC specifications. (iv) The Lifts must be warranted atleast for 12 months from the date of Commissioning.

Otis Elevator Company(India)Limited (BID ID -6837320)