Miscellaneous works at Pandu and Dibrugarh terminal locations along NW2

Amount

High Must Light:-Repair & maintenance of High must light 1 no at Pandu port including supply, fitting /fixing / replacement & commissioning complete in alrespect as per direction of EIC

Crompton or equivalent LED flood light 250 w

Timer

Contactor

TPN 4 pole 63 AMP Standard Model

Pannel board including necessary connection

Motor 5 HP

GI angle 40 mm

Cable 5 core with P.V.C insulated 10/6 MM (MTR) including necessary connection

Signal Light Set

Cable 3 Core with P.V.C insulated 4/2.5 mm (coil) including necessary connection

Steel wire 8/6 mm

Gear oil

Repair and maintenance of damaged plaster in Office building at Pandu

12 mm cement plaster of mix 1 : 6 (1 cement: 6 fine sand)

Applying priming coats with primer of approved brand and manufacture, having low VOC (Volatile Organic Compound ) content With water thinnable cement primer on wall surface With water thinnable cement primer on wall surface

Wall painting with acrylic emulsion paint, having VOC (Volatile OrganicCompound ) content less than 50 grams/ litre, of approved brand andmanufacture, including applying additional coats wherever required,to achieve even shade and colour.Two coats

Wall painting with acrylic emulsion paint, having VOC (Volatile OrganicCompound ) content less than 50 grams/ litre, of approved brand andmanufacture, including applying additional coats wherever required,to achieve even shade and colour.Two coats

Providing and fixing PVC low level flushing cistern with manually controlled device (handle lever) conforming to IS : 7231, with all fittings and fixtures complete. 10 litre capacity - White as per direction of EIC at Pandu Port Terminal including removing of old damaged Cistern (Old office building Ground Floor-2 no., 2nd Floor-1 no. & weigh Brige-1 No)

Removing old damaged European WC Pan and providing & fixing white vitreous china WC pan including cost of mterial, labour etc complete in all respect as per direction of EIC ( Director room -1 no. & Old office 1 no.)

Supplying & fittings of electrical items like LED tube light -6 nos, switch, wire, wall fan - 2 nos in old office building on 2nd floor & stair side complete incuding materials & labours etc as per direction of EIC or his reresentative

Supplying of Euro Ladder Systems Pro Telescopic Ladder 5.6 Meter- Stores at 3.6 ft- Zero Flex technology (Rock Solid)- Red Que Safe Step- Stabilizer, Anti Skid feet & Wheel Kit at Pandu Port Terminal

Kitchen slab, sink etc in Pandu Office

Supply and fitting granite/marble plate (size 3.6m x 0.60m) to be used as kitchen slab including cost of standy of masonry carrigae etc all comple (one hole is also to be made for gas pipe). Including cost of cement/brick etc as needed and mason/labour cost all included.

Steel sink of 24x18x9 inch of good quality including fitting with accessories.

Plumbing work with one and half inch pipe (about 12 m pipe) including cost of material labour etc.

Plumbing work with one and half inch pipe (about 12 m pipe) including cost of material labour etc.

Miscelenious works at Dibrugarh office

Earth work in excavation by mechanical means (Hydraulic excavator)/ manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-incharge. All kind of soil

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:3:6 (1 Cement : 3 coarse sand (zone-III) derived from natural sources : 6 graded stone aggregate 20 mm nominal size derived from natural sources)

Centering and shuttering including strutting, propping etc. and removal of form work for : Foundations, footings, bases for columns

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size de rived from natural sources) in foundation.

Reinforced cement concrete work in walls (any thickness), including attached pilasters, buttresses, plinth and string courses, fillets, columns,pillars, piers, abutments, posts and struts etc. above plinth level up to floor five level, excluding cost of centering, shuttering, finishing and reinforcement : 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources) Tie beam & column

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. Mild steel and Medium Tensile steel bars

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in : Cement mortar 1:4 (1 cement : 4 coarse sand)

12 mm cement plaster of mix : 1:6 (1 cement: 6 fine sand)

Applying priming coats with primer of approved brand andmanufacture, having low VOC (Volatile Organic Compound ) content With water thinnable cement primer on wall surface With water thinnable cement primer on wall surface

Finishing walls with water proofing cement paint of required shade : New work (Two or more coats applied @ 3.84 kg/10 sqm)

Ranu Nandi