REPAIR/ IMPROVEMENT TO LT UG CABLE NETWORKS AND ELECTRICAL DISTRIBUTION SYSTEM AND ALLIED WORKS UNDER GE (EAST) MATHURA

Supply,installing,commissioning and testing of LT panel board outdoor type,cubical type made out CRCA sheet 3.15 mm thick dust and vermin proof and angle iron of suitable size, pedestal flame grouted in PCC (1:2:4) type B-1 20 mm graded stone aggregated thimble and cable entry boxes with cable glands. Panel should covered from all sides with front and back lockable door and hinges complete with aluminum bus bar of of suitable size,(in separate chamber) including painting with two coats synthetic enameled paint over a coat of red oxide primer and consisting of the following:- (a) MCCB 400 Amp , 4 pole,36 kA-01 Each (b) MCCB 250 Amp , 4 pole,16 kA -02 Each (c) MCCB 100 Amp , 4 pole,16 kA -01 Each (d) Digital Amp meter (0-250)-01 Each (e) Digital Volt meter (0-500) -01 Each (f) RYB Indicator-01 Set Note:- The Drawing of Panel to be submitted for approval by makers given in schedule before installing at site.

Excavating in trenches not exceeding 1.5 mtr in depth and not exceeding 1.5 mtr wide for foundation of poles, laying of cables etc. and getting out in soft/loose soil complete all as specified and as directed.

M&L for sand cushioning to under ground cable in trenches in layers of 8 cm deep before laying the cable and 15 cm deep after laying and stretching the cable and punned the sand for protection of cable complete all as specified and as directed. Note:- For payment punned depth shall be measured.

Supply and laying reinforced precast concrete cable cover class LV type 1 flat size 250mm x 150mm x 40mm complete all as specified and as directed.

Returning, filling in including spreading, levelling, watering and well ramming excavated soil in layers not exceeding 25 cm thick each , filling back in trenches after cables have been laid and tested complete all as specified and as directed

Removal of excavated surplus soil to a distance not exceeding 50 mtr and depositing where directed at a level not exceeding 1.5 metre above the starting point complete all as specified and as directed.

16 Sqmm 4.0 core.

25 Sqmm 3.5 core.

35 Sqmm 3.5 core.

50 Sqmm 3.5 core.

70 Sqmm 3.5 core.

95 Sqmm 3.5 core.

120 Sqmm 3.5 core.

150 Sqmm 3.5 core.

185 Sqmm 3.5 core.

240 Sqmm 3.5 core.

Supply and fixing in replacement of MCCB 630Amp rating,4-pole 415V, Electronic release with overload and short circuit adjustable type breaking capacity 36 KA.

Supply and fixing in replacement of MCCB 400Amp rating,4-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 36 KA.

Supply and fixing in replacement of MCCB 315 Amp rating,4-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 36 KA.

Supply and fixing in replacement of MCCB 250 Amp rating,4-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 36KA.

Supply and fixing in replacement of MCCB 200 Amp rating,4-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 36KA.

Supply and fixing in replacement of MCCB 160 Amp rating,4-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 16KA.

Supply and fixing in replacement of MCCB 100 Amp rating,4-pole 415V, adjustable thermal adjustable megnetic type adjustable thermal adjustable megnetic type breaking capacity 16KA.

Supply and fixing in replacement of MCCB 63 Amp rating,4-pole 415V, adjustable thermal adjustable megnetic type adjustable thermal fixed megnetic type breaking capacity 16KA.

Supply and fixing in replacement of MCCB 250Amp rating,3-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 35KA.

Supply and fixing in replacement of MCCB 200Amp rating,3-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 35KA.

Supply and fixing in replacement of MCCB 160Amp rating,3-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 25KA.

Supply and fixing in replacement of MCCB 125Amp rating,3-pole 415V, adjustable thermal adjustable megnetic type breaking capacity 25KA.

Supply and fixing in replacement of MCCB 100Amp rating,3-pole 415V, fixed thermal fixed megnetic type breaking capacity 16KA.

Supply and fixing in replacement of MCCB 63 Amp rating,3-pole 415V, fixed thermal fixed megnetic type breaking capacity 16KA.

Supply, installation, testing and commissioning of Bus Bar Chamber outdoor type made out of 1.6 mm CRCA steel sheet 8 Nos outgoing TPN 200 Amps Bus Bar rating including fixing on Wall / Pole with suitable size of clamp, Nut & Bolt or as per site requirement for fixing of outdoor site with provision of angle iron legs 45 x 45 x 3 mm, 750mm long including PCC 1:2;4 type B-1 as in foundation of size 450 x 600 x600mm for grouting and incommer and outgoing cable connections with suitable size of lugs complete all as specified and directed .

Supply,installing,commissioning and testing of LT panel board outdoor type,cubical type made out CRCA sheet 3.15 mm thick,inner sheet 2.0 mm thick, dust and vermin proof and angle iron of suitable size, pedestal flame grouted in PCC (1:2:4) type B-1 20 mm graded stone aggregated thimble and cable entry boxes with cable glands. Panel should covered from all sides with front and back lockable door and hinges complete with aluminum bus bar 400 Amp-03 nos for phase & 01 No for neutral ,(in separate chamber) including painting with two coats synthetic enameled paint over a coat of red oxide primer and consisting of the following:-

(a) MCCB 200 Amp,4P, 25KA,Ics=100%Icu, adjustable thermal based released (I/C)- 01 No

(b) MCCB 63A, 16 KA, 3 Pole,Ics=100%Icu,fixed thermal and fixed magnetic (O/G)- 06 Nos

(c) Digital meter with Voltmeter (0-500V) - 01 No

(g) Indicationg Lamps (R,Y,B) - 01 Set

Note : Drawing of LT panel shall be got approved from GE before placing order for procurement.

M&L for providing cement concrete type C2 1:3:6 using 40 mm graded stone aggregate as in foundations,filling and mass concrete.

Supply only chain link fencing made out of mild steel galvanised wire of any size all as specified and directed.

Fixing only chain link fencing including line wires,any mesh,sizes and type to any type of strandards,rail,straining bolts etc including provision of binding wire complete all as specified and directed. Note:- (i) Supply only fencing will be measured and paid separately. (ii) Supply and fix mild steel nut bolt,line wire and flat will be measured and paid separately.

Supply and fix mild steel section fin post and struts for fencing including cutting top to shape as directed drilling hole notching for wire etc or flat iron fillet (for security wire mesh etc) including all necessary drilling bolting or riverting etc complete all as specified and directed.

Supply and fixing Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends,each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5 cm long & dia of shank 11 to 15 mm compele all as specified and as directed.

Supply and fixing in replacement tubular battery 12 volt 150 AH complete all as specified and directed.

Supply only HT insulation tape providing electrical insulation, thermal protection and mosture sealed for cables and components EPR Rubber tape of size (25mmx.76mmx9m) compele all as specified and as directed.

Supply only LT insulation tape durable, stretchable and weather rasistance PVC tape or fabric tape TAPARIA PVC Insulation Tape IT17B - Premium Electrical Tape - colour coded of size 17mm x 6m, Weather Proof, Moisture & Fire Resistant, Excellent Elasticity, Durable, Good Grip and Strong Adhesion (Pack of 20) compele all as specified and as directed.