Renovation of Dining Hall and Hut no 4 of Tourist Huts at Ranjit Sagar Dam

Amount

Dismantling Cement concrete Plain 1:3:6 mix walls (Hollow Blocks

Dismantling Cement concrete plain1:2:4 mix floors

Earth work excavation in ordinary soil, exclusive of compensation of earth

Cement concrete 1:3:6 with stone ballast or shingle mixing by manual means for foundation of walls.

First class burnt brick laid in cement sand mortar 1:6 in foundation and plinth.

First class burnt brick work laid in cement sand mortar 1:6 in first storey up to 4 meters above plinth level.

Damp proof course 4cm thick of cement concrete 1:2:4 with 2 coats of bitumen 20/30 penetration at 1.65 Kg per sqm laid hot and sanded

20mm thick cement plaster 1:6 in two coats work on new walls

Preparation of plastered surfaces for distempering including surface, applying filling with approved quality filler consisting of plaster of paris and chalk mitti including finishing the surface to the required finish complete

Cement concrete 1:2:4 with stone ballast or shingle mixing by manual means for foundation of walls

Cold twisted deformed (Ribbed/ Tor steel) Bars (Fe 415 grade as per IS 1786-2008) , for R.C.C works, where not including in the complete rate of RCC including binding & bending and placing in position complete

Providing and fixing toughened glass 12mm thick with framework and silicone solution including cutting of sand/dhaulpur stone with framing at dam site as per requirement of department.

Providing and fixing face work with wire cut bricks of size (9”x3”x3/4”) with cement sand mortar 1:3 with ½” deep joint complete in all respects as per requirement of department at dam site.

Providing and laying vitrified floor tiles in different sizes in light colour shades made using Full Body Technology (thickness to be specified by the manufacturer) with water absorption’s less than 0.08% and conforming to IS : 15622 of approved make in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement: 4 fine sand), complete , (size 600 x 600mm )

Providing and fixing 1st quality ceramic glazed wall tiles Matt/Semi Matt/Glosy/Highly Gloss finish/Highlighter/emboss conforming to IS : 15622 (thickness to be specified by the manufacture of approved make in all colours, shades except burgundy, bottle green, black of size 450 x 310 mm as approved by Engineer-in- Charge in skirting, risers of steps and dados over 12 mm thick bed of cement Mortar 1:4 (1 cement: 4 fine sand) and jointing with grey cement slurry@ 3.3kg per sqm including pointing in white cement mixed with pigment of matching shade complete.

Providing and fixing of Skirting in lobby for floor tile with cement mortar 1:3 and adhesive, wherever required complete as per the requirement of the department

Providing and fixing of interior blinds zebra with all fittings

Providing 1.5 Ton All-Weather Air Conditioner complete with all fittings (Stabilizer, Cooling Pipe etc.)

Providing and Fixing of Main door frame with door shutter with fixed glass window at main entrance according to its Design including Anti termite Treatment with all its joinery, floor machine, joinery .hinges, locks, tower bolt etc with anti termite treatment and required colored laminates according to requirement of department

Providing and Fixing ceiling consisting of 12.5mm thick Gypsum Board of any size G.I. Cradling hanged from the ceiling by means of G.I. hanger complete as per drawings, specifications and to the entire satisfaction of engineer-in- charge.

Preparation of plastered or concrete surface for painting (including sand papering the surface) using ready mixed cement-based wall putty by applying two or more coats to get required finish

Applying priming coat with cement primer in all shade on newly plastered or concrete exterior surface.

Distempering with Acrylic washable oil bound distemper (of approved manufacture) two or more coats over one priming coat to give an even shade.

Providing and fixing in position Chinaware wall mounted E.W.C without cistern including seat cover with P trap or S trap of approved make (to the approval of the Engineer-in-charge) complete in all respect and to the entire satisfaction of Engineer-in-charge.( Make -jaguar, cera, kohler )

Providing and fixing in position vitreous chinaware white lavatory suites of approved make (to the approval of Engineer-in-charge) including Rack Bolt Screw Pair 115mm long without CP fittings complete in all respect.Table Top (size 49 x 40 x 15 cm) ( Make -jaguar, cera, kohler )

Providing and fixing in position C.P. brass soap dish of approved make (to the approval of Engineer-in-charge) fixed into wall with rawl plugs and C.P brass screws complete in all respect.

Providing & fixing in position C.P. Brass Hexa Nipple 15mm of approved make (to the approval of Engineer-in-charge) complete in all respect.

Providing & fixing in position PVC flexible tube connection of size 15mm x 450mm with C.P. Brass nut of approved make (to the approval of Engineer-in-charge) complete in all respect.

Providing & fixing in position C.P. Brass flange Dome of approved make (to the approval of Engineer-in-charge) under various fixtures complete in all respect.

Providing and fixing in position C.P. brass towel rack 600mm long with lower hangers of approved make (to the approval of Engineer-incharge) complete in all respect.

Providing and Fixing Vanity of washbasin of 46” height using bWR board, wood and lamination all over (inside and outside) of required colour, 3” thick board on top of the vanity covered with 12mm lacor toughened glass of size 23” x 36” as per design of Hut No. 1 and directions of Engineer-in-Charge.

Providing and fixing Stainless steel health faucet complete in all respect.

CONCEALED IN WALL: Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) SDR 11 pipes & fittings 25mm o/d as per IS 15778 (ISI marked with the prior approval of Engineer-in- Charge), having thermal stability for hot & cold water supply, including all CPVC plain & brass threaded fittings i/c fixing the pipe with clamps at 1.00 m spacing including jointing of pipes & fittings, with one step CPVC solvent cement and testing of pipes complete as per direction of Engineer-in-Charge.

Single lever concealed divertor of bath and shower system (with body and upper part)

Providing and fixing C.P. brass 32mm short bend complete

C.P. brass 15mm Angle valve without flange.

C.P. brass toilet roll holder with flap.

Providing and fixing jet spray with 2'-6" long PVC pipe with C.P. Brass Nut.

Providing and fixing in position C.P. brass towel rack 600mm long with lower hangers of approved make (to the approval of Engineer-incharge) complete in all respect.

1.All Electrical works relating to Dining Hall Renovation including lights, switches, wires and other accessories. 2. All Electrical works relating to Hut No.4 Renovation including lights, switches, wires and other accessories (As per departmental specification)

Providing and fixing in position concealed cistern including flushing plate of approved make (to the approval of the Engineer-in-charge) complete in all respect

Providing and fixing P.V.C Waste Pipe Collapsible 32mm complete in all respect.

Providing and fixing in position CP Brass single lever surgical mixer with swinging spout approved make (to the approval of Engineer in charge) complete in all respect.

Providing and fixing in position premium range C.P. Brass Wall mixer with Non - Telephonic shower arrangement of approved make (to the approval of Engineer-in-charge) complete in all respect.

Providing and fixing in position premium range C.P. Brass 15mm Concealed stop cock with adjustable wall flange with seal. (Outer + Inner Body) of approved make (to the approval of Engineer-in-charge) complete in all respect.

Providing and fixing in position premium range C.P. Brass fitting and accessory approved make (to the approval of Engineer-in-charge) complete in all respect. (B) C.P. Brass Accessories: CP Glass shelf 600mm long.

Dismantling cement conglomerate floors 25mm to 50mm thick including concrete base

Dismantling aluminium/ Gypsum partitions, doors, windows, fixed glazing and false ceiling including disposal of unserviceable material and stacking of serviceable material within 50 meters lead as directed by Engineer-in-charge

Dismantling aluminium/ Gypsum partitions, doors, windows, fixed glazing and false ceiling including disposal of unserviceable material and stacking of serviceable material within 50 meters lead as directed by Engineer-in-charge

Finishing walls with acrylic smooth exterior paint of required shade with two or more coats applied @ 1.67 litre/10Sqm over and including base coat of water proofing Cement Paint applied @ 2.20 Kg/10 Sqm

Providing & fixing in position 5mm thick bevelled edge mirror of superior glass (of approved make) complete with 4mm thick hard board backing fixed in with rawl plugs 50mm, C.P. brass screws and washers and S/S Studs on top complete in all respect (as required by the Engineer-in- Charge) of size 600mmx450mm.

Providing & fixing in position 5mm thick bevelled edge mirror of superior glass (of approved make) complete with 4mm thick hard board backing fixed in with rawl plugs 50mm, C.P. brass screws and washers and S/S Studs on top complete in all respect (as required by the Engineer-in- Charge) of size 1500mmx600mm or any other size

Providing and fixing of Door frame of 5” x 2.5” with door shutter 40mm thick, lamination on both sides of required colour with all its joinery and anti-termite treatment including hinges, door closer, door lock, towerbolt etc with Putty, Primer and Paint on door frame of required colour complete in all respects and design as per Hut No. 1 or directions of Engineer-in-Charge

Providing and Fixing Double Rebate window frame of size 5” x 2.5” for two window shutters, (one shutter is of glass and other shutter is of wire gauze) with Anti termite Treatment including all its joinery hinges towerbolt, handles with primer and paint complete in all respects as per Hut No. 1 or direction of Engineer-in-charge.

Providing and Fixing of ventilators Frame and Ventilator shutter (double Rebate) both sides of size 1’6” x 2’ including Anti-termite treatment with primer and paint of required colour (One Fix Glass and opening for Exhaust fan) and design as per Hut No. 1 and directions of Engineer-in-Charge.

Providing and installation of Sony make LED TV108cm (43 inch)

Providing and fixing in position storage type automatic electric water heater pressure type thermostatically controlled, single phase wall mounted of approved make (to the approval of Engineer-in-charge) with thermostats, inner container of stainless steel, Inner glass lining with B-Rating minimum 3 stars complete with 1 Mtr. three core flexible cord with plug, non-return valve and pressure release valve complete including fixing and testing complete in all respect.Horizontal Type with 40 litres capacity.

Providing and fixing in position C.P. brass overhead shower arm 18” length chrome square with 15mm i/d inlet of approved make (to the approval of Engineer-in-charge) complete in all respect.

K.P. INFRASTRUCTURE AND DEVELOPERS (BID ID -591044)

M/S VARNA ASSOCIATES (BID ID -590900)