PROVN OF CHAIN LINK FENCING ALONG WITH REAR SIDE KIRBY PLACE CULVERT OPEN DRAIN AND SHED ENTRANCE AREA OF OFFRS MD ACCN BLDG NO P29 AND P30 OTHER CONNECTED ITEMS IN BLDG NO P07 AND P10 OTHER CONNECTED ITEMS IN BLDG NO P33 AT KIRBY PLACE UNDER GE NORT

Demolition of cement concrete (un-reinforced) in ground floors and pavings n. exc. 15cm thickness (below or above ground level) all as specified and directed.

M&L for 75mm thick PCC 1:3:6 type C-2 using 40mm graded stone aggregate as in subase of floor, complete all as specified and directed.

M&L for providing and laying 60mm thick factory made chamfered edge cement concrete paver block of with pigment M-35 grade with approved colour,design & pattern as in footparth, parks,lawns, drive ways or light traffic parking etc.,of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer throughvibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all specified and directed.

M&L for 300mm x 300mm/200 x 200mm & 10 mm thick anti skid pavement tile Endura vitrified tile of "H & R Johnson India" or equivalent in pavit or NITCO as approved by the GE in approved color & Shade and in anti skid finish set and jointed in neat cement slurry and pointed in white cement & pigment to match over and including 20mm thick cement screed bed using cement mortar (1:6) laid complete all as specified and as directed.

S&F for factory made kerb stone of M-25 grade precast cement concrete/stone laid in position to the required line, level and curvature, jointed with cement mortor 1:3 including making the joint with or without grooves including making drainage opening where ever required complete as per direction. Note (i) Length of finished kerb edging shall be measured for payment (ii) precast CC kerb shall be approved by the Engineer-in-Charge).

S&F 0.50mm plain, Pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet galvanised,mild steel sheeting, in ridges, hips, valley gutter, drip and straight flashings (length and girth as fixed) with grade of zinc coating 275 and welded or soldered joints are provided as requried complete all as specified and directed.

S&F Structural steel work for rolled sections as in main and cross beams,hips,jacks, rafters, purlins,runnings , rails and guides for sliding doors fixed with angles, cleats or other conneccting plates grade FE-410-W at working height 15m complete all as specified and directed.

M&L for preparation of new of previously untreated steel and Iron surface of any description, not otherwise described over 10 cm width or girth and applying two coats of Synthetic enamel paint over one coat of red oxide primer complete all as specified and as directed.

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in and ramming earthor broken rubble mixed with earth around, in layers notexceeding 25 cm,

M&L for PCC 1:5:10 ,type E-2 using 40mm graded crushed stone aggregate as in sub base and mass conc, complete all as specified and as directed.