REPAIR/MAINT/PAINTING TO SECURITY BOUNDARY WALL, FENCING, CONCERTINA COIL and GRILL, CULVERT, PATHWAY AND OTHER CONNECTED WORKS AT 24 ED

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion of concrete above GL or below GL complete all as specified and directed

Excavating in post holes or similar holes in dismantled posts or struts each n.exc 0.5 Cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering and removing surplus soil to a distance n exc 50m and making good surface in soft/loose soil/cement concrete

M&L Plain cement concrete (pcc)1:3:6 type C-2 (using 40mm graded crushed stone aggregate) as in foundations, filling and mass concrete,or plinth etc. complete all as specified.

Demolition of cement conc.,reinforced cement concrete,RCC Jalli of any description and in any position not otherwise specifically provided for complete all as specified and directed.

M&L for pre-cast RCC 1:2:4 type B1 using 20mm graded stone aggregrate in cover slab for manhole or similar works set in CM 1:6 complete all as specified and directed by Engineer-in-charge.(Note :- reinforcement shall be measured and paid separately)

M&L for PCC1:2:4 type B-0 using 12.5mm graded stone aggregate as in copping,plinth course,bed plates and the like including necessary use and waste of formwork complete all as specified and directed by Engr-in-charge.

M&L Providing reinforced cement concrete, 1:2:4 type B-l (using 20 mm graded aggregate) in precast posts, fencing posts, straining or terminal posts, struts etc. for fencing, average sectional area n exc 100 sq. cm, with or without chamfered angles and flat, splayed, rounded or mitred tops as directed and fixed.

M & L Providing precast cement concrete louvres and jallies type B-0, 1:2:4 (12.5 mm graded aggregate) 25mm thick (measured solid),set in CM 1:4. including all mouldings complete all as specified and directed.

M&L TMT Bars 6mm to 8mm dia cut to length, bent to shape required, including cranking, bending spirally for hoopng for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complte all as specified and directed.

M&L for mild steel TMT bar 10 mm dia and over cut to length bent to shape required including cranking bending for hooking ends and binding with and including mild steel wire ( annealed) not less than 0.9mm dia or securing with clips complete all as specified .