S.62 NCTPSII ES MRT Division UII Painting of DC EOP panels and lubrication of actuator during Annual Overhauling Works under Open tender System.

Amount

Painting of DC EOP panels

Complete external cleaning of DC EOP panels with emery sheet/wire brush and and apply two coats of Epoxy painting with Gray in colour (including consumable like cotton/banyan waste, cleaning brush, rust removal spray,brush etc. and required T&P) (including Epoxy paint)( dimension in Annexure-A)

Lubrication of High Torque, Medium & Low Torque actuators

Critical checks on the gear mechanism of the High Torque Motorized actuators (range 2000Nm to 16000Nm). The critical checks are such as Limit Switch, Torque Switch, Examination and lubricating of all the Moving parts and toping up the Lubrication if required, Mechanical & Electrical Open/Close operation and sealing the all cable gland holes to avoid moisture entry. (including consumable like cotton/banyan waste, cleaning brush, rust removal spray,brush etc. and required T&P) (Including Servo Gem EP-0 or Equivalent Grease)

Inspection and top up of lubricants in Main Gear Case & Geared Limit Switch, renew grease if fully contaminated, checking of gear mechanism & Limit switches, Torque switches and checking of Mechanical & Electrical operation of Medium Torque range on 100.00 Limitorque & Auma make actuators. (including consumable like cotton/banyan waste, cleaning brush, rust removal spray,brush etc. and required T&P) (Including Servo Gem EP-0 or Equivalent Grease).

Inspection and top up of lubricants in Main Gear Case & Geared Limit Switch, renew grease if fully contaminated, checking of gear mechanism & Limit switches, Torque switches and checking of Mechanical & Electrical operation of Low Torque range on Antrieb make actuators. (including consumable like cotton/banyan waste, cleaning brush, rust removal spray,brush etc. and required T&P)| (Including Amocam 100 or Equivalent oil).

Painting of Acutators

Complete external cleaning of Motorized actuators with emery sheet/wire brush and apply two coats of painting (Spray painting) with DA Gray IS 5 in colour. Painting with yellow colour on the actuator at the appropriate location as per the direction of engineer incharge and Writing the name of the Actuator/Source of supply etc., with black paint (including consumable like cotton/banyan waste, cleaning brush, rust removal spray, brush etc. and required T&P) (including DA Gray IS 5 Ipaint) dimension in Annexure-A)

A.R.C.ENGINEERING