Shifting of 62.5 KVA DG set from Garacharma TE to Telephone Bhawan, Port Blair, including minor repairing works.

Servicing of 62.5 KVA M/s Kirloskar make Engine (4R810TA G1) thoroughly by replacing B-Check Kit such as oil filter-1 no, fuel filter (Pri & Sec)-1 set, supplying and filling 15W40 lub oil-13 Ltr, Coolant, after dismantling & flushing the sump, checking of alignment and adjustment of different components like valve, tappet, fuel line system, hose clips wherever required, including S/F of missing hardware such as nuts & bolts, washers, spring washers etc, including replacing the stop solenoid coil, testing with exchange load and commissioning complete as reqd. (K-Oil/Castrol or similar superior make)

Dismantling the 62.5 KVA at Garacharma and 125 KVA at Telephone Bhawan by disconnecting the electrtical connections, earthing leads, exhaust pipe, etc and manually shifting of 62.5 KVA from foundation to the main gate, as per the direction of EIC, complete as reqd.

Shifting the 62.5 KVA DG set from Garacharma TE to Telephone Bhawan, including placing the same on the existing foundation, making electrical connection, earthing arrangements, heating arrangements for the alternator, testing on load, and shifting of 125 KVA faulty DG from foundation to the designated location as per the direction of EIC, complete as reqd.

Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete:

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge)0.50 mm + 0.05 %, total coated thickness with zinc coating 120 gsm as per IS: 277 in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches while transportation and should be supplied in single length upto 12metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.