Construction of Toilet Block for Girls at Govt. Degree College Gool (Ramban).

Amount

Earth work in excavation by Mechanical means ( Hydraulic excavatar ) over areas (Exceeding 30 cm in depth, 1.5 mtr in width as well as 10 sqm on plan ) including . disposal of excavated earth, lead upto 50 mtr.and lift upto 1.50 mtr, disposed earth to be levelled and neatly dressed. All kinds of soil

Earth work in excavation by manual means in trenches for foundations, drains, pipes, cables etc. ( Not exceeding 1.5 mtr in width ) and for shafts , wells, cesspits and the like not exceeding 10sqm on plan, depth upto1.5 mtr including disposal of excavated earth up to 1 mtr from cutting edge, disposed earth to be levelled and neatly dressed in

Providing and laying compacting stone agg. 90 mm to 40 mm N/S in bed of foundation for walls

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size) including carriage

Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering all work up to plinth level 1:3:6 with 30% boulders. ( 1 cement :3coarse sand :6 graded stone aggregate 20 mm nominal size) Crushed including carriage a) concrete 70%

b) stone 30%

Providing and laying in position specified grade of reinforced cement concrete including curing but excluding the cost of centering, shuttering, finishing and reinforcement. All works upto plinth level 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size)

Reinforced cement concrete work in walls (any thickness) including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts upto floor five level including curing but excluding cost of centering shuttering, finishing and reinforcement 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size)

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level Cold twisted bars

Brick work with common burnt clay F.P S ( non modualar) bricks of class designation 75 in foundation and plinth cement mortar 1:6 (1 cement :6 fine sand including carriage

Half brick masonry with bricks of class designation 75 in foundation and plinth in cement mortar 1:4(1 cement :4coarse sand ) including carriage

Providing and laying damp proof course 50 mm thick with cment concrete 1:2:4 (1 cement :2 coarse sand :4 graded stone aggregate 20 mm nominal size ( Crushed ) including carrige

Providingh cement plaster 15 mm thick cement of mix 1:6 ( 1 cement :6 fine sand ) including carriage

15mm Cement plaster on the rough side of single or half brick wall of 1 : 4 ( 1 cement : 4 fine sand) including carriage

Providing and fixing M.S tubular frames for doors, windows, ventilators and cupboard with rectangular /L-type sections, made of 1.60 mm thick M.S Sheet, joints mitred, welded and grinded finish, with profiles ofrequired size, including fixing of necessary butt hinges and screws and applying a priming coat of approved steel primer. 10.15.1 Fixing with 15x3 mm lugs 10cm long embedded in cementconcrete blocks 15x10x10cm of C.C. 1:3:6 (1cement : 3 coarse sand :6 graded stone aggregate 20mm nominal size) . 10.15.2 Fixing with carbon steel galvanized dash fastener of required dia and size (to be paid for separately)

Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete Welded

Providing corrugated G. S. sheet roofing including vertical/curved surface fixed with polymer coated J or L hooks, bolts and nuts 8mm diameter with bitumen and G.I limpet washers or with G.I. limpet washers filled withwhite lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (upto any pitch inhorizontal/vertical or curved surface)excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required 0.63 mm thick with zinc coating not less than 275 gram/m2

Providing ridges or hips of width 60cm overall width plain G.S. sheets fixed with polymer coated J. or L hooks, bolts and nuts 8mm dia G.I.limpet and bitumen washers complete. 0.63 mm thick with zinc coating not less than 275 gram/m2

Providing and fixing panelled or panelled and glazed shutters for doors, windows and clerestory windows fixing with butt hinges of required size with necessary screws, excluding panelling which will be paid for separately, all complete as per direction of Engineer-in-charge. (Note: -Butt hinges and necessary screws shall be paid separately)

Providing and fixing panelling or panelling and glazing in panelled or panelled and glazed shutters for doors, windows and clerestory windows (Area of opening for panel inserts excluding portion inside grooves or rebates to be measured). Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick Decorative ply wood one side decorative veneer and commercial veneer on other face (Type -I) conforming to IS 1328 BWR type

Providing and fixing wire gauze shutters using galvanized M.S. wire gauze of average width for aperture 1.4 mm in both directions with wire of dia. 0.63 mm for doors, windows and clerestory windows with ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws as per direction of Engineer-in-charge

Providing and laying Polished Granite stone flooring in required design and patterns, in linear as well as curvilinear portions of the building all complete as per the architectural drawings with 18 mm thick stone slab over 20 mm (average) thick base of cement mortar 1:4 (1 cement : 4 coarse sand) laid and jointed with cement slurry and pointing with white cement slurry admixed with pigment of matching shade including rubbing, curing and polishing etc. all complete as specified and as directed by the Engineer-in-Charge. 11.68.1 Polished Granite stone slab jet Black, Cherry Red, Elite Brown, Cat Eye or equivalent.

Providing and Fixing 1st class ceremic glased wall tiles skirting over 12 mm thick bed of cement morter 1:3 mix complete

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or withdash fasteners of required dia and length (hold fast lugs or with dash fastenersshall be paid for separately):

roviding and fixing hard board sheet ceiling of approved quality with necessary nails etc. complete (frame work to be paid for separately) Standard Quality board 4 .5 m m

Providing and fixing plain, square edged wooden beading 65x12 mm section with screws of approved quality for ceiling

Providing and applying white cement based putty of specified thickness, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete

Applying priming coats with primer of approved brand and manufacture, having low VOC (Volatile Organic Compound) content.13.93.1 With ready mixed pink or grey primer on wood work (hard and soft wood) having VOC content less than 50 grams/ liter

Applying priming coats with primer of approved brand and manufacture, having low VOC (Volatile Organic Compound) content.13.93.1With ready mixed red oxide zinc chromatic on steel / iron works having VOC content less than 250 grams/ liter

Finishing walls with 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade(Company Depot Tinted) with silicon additives.13.94.1 New work (Two or more coats applied @ 1.43 litre/10 sqm. Over& including priming coat of exterior primer applied @ 0.90 litre/10 sqm.

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade. Two or more coats on new work

Providing and fixing plained eaves boarding.250x32 mm (nominal size )

Providing and fixing glass panes 4 mm thick glass pane (weighing not less than 10 kg/sqm)

Centring and shuttering including strutting propping etc. and removal of form for Foundations, footings, bases of columns etc for mass concrete

Centring and shuttering including strutting propping etc. and removal of form for Walls ( any thickness ) including attached pilasters , butteresses , plinth and string course

Centring and shuttering including strutting propping etc. and removal of form forColumns, Pillars, piers, abutments, posts and struts

Centring and shuttering including strutting propping etc. and removal of form forSuspended floors, roofs, landings, balconies and access platforms.

Centring and shuttering including strutting propping etc. and removal of form forEdges of slabs and breaks in floors and walls under 20cm wide

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead upto 50 m and lift upto 1.5 m

Providing and fixing of white vitreous china ped- type water closet Europeon type complete )

Providing and fixing wash basin with C. I./M.S. brackets, 15mm C.P. brass pillar taps, 32 mm C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever required white vitrous Wash basin size 630x450 mm with a pair of 15 mm C.P. brass pillar tap

Providing and fixing mirror of superior glass(of approved quality) and of required shape and size with plastic .moulded frame of approved make and shade with 6 mm thick hard board backing Rectangular shape 453x357 mm

Providing and fixing PTMT towel rail complete withbrackets fixed to wooden cleats with CP brass screws with concealed fitting arrangement of approved quality and colour: 450 mm long towel rail with total lengthof 495 mm, 78 mm wide and effective height of 88 mm, weighing not less than 170 gms

Providing and fixing 600 x 120 x 5 mm glass shelf with edges round off supported on anodized aluminum angle frame with CP brass brackets and guard rail complete fixed with 40 mm long screws, rawl plugs etc complete

Providing and fixing 8 mm dia CP /S.Sjet with flexible tube up to 1 mtr long with S.S tringular plate to Europen type W.C of quality and make as approved by Engineer in charge.

Providing and fixing 3 layer PP-R (Poly propylene Random copolymer) pipes conforming to IS: 15801, UV stabilized and anti-microbial fusion welded, having thermal stability for hot and cold water supply including all PP-R plain and brass threaded Polypropylene random fittings. This includes testing of joints complete as per direction of Engineer-incharge ...PN-16 pipe, 16mm OD(SDR-7.4)

PN-25 mm dia pipe, 16mm OD(SDR-7.4)

Providing and fixing G.I. pipes complete with G.I. fittings and clamps, including cutting and making good the walls etc.: 15 mm dia. nominal bore

Poviding and fixing G.I. pipes complete with G.I. fittings and clamps, including cutting and making good the walls etc.: 20 mm dia. nominal bore

Providing and fixing rectangular high density polyethylene water storage loft tank with cover, conforming to ISI: 12701, colour of opaque white or as approved by Engineer-in-charge. The rate includes making necessary holes for inlet, outlet & over flow pipes. The base support i/c fittings & fixtures for tank shall be paid separately

Providing and fixing 15 mm nominal bore C.P. brass bib cock of approved quality conforming to IS : 8931

Providing and fixing 15 mm nominal bore C.P. brass angle valve for basin mixer and geyser points of approved make conforming to IS : 893

Providing and fixing un plasticized P.V.C. connection pipe with PTMT nuts, collars and bush of approved quality and colou

Making soak pit 2.5 m diameter 3.0 meter deep with 45x45 cm dry brick honey comb shaft with common burnt clay (non modular) bricks of class designation 7.5 bricks and S.W. drain pipe 100 mm diameter, 1.8 m long complete as per standard design

Constructing brick masonry manhole in cement mortar 1:4 ( 1 cement : 4 coarse sand ) with R.C.C. top slab with 1:1.5:3 mix (1 cement : 1.5coarse sand (zone- III) : 3 graded stone aggregate 20 mm ominalsize), foundation concrete 1:4:8 mix (1 cement : 4 coarse sand (zone- III): 8 graded stone aggregate 40 mm nominal size),inside plastering 12 mmthick with cement mortar 1:3 (1 cement : 3coarse sand) finished withfloating coat of neat cement and making channels in cement concrete1:2:4 (1 cement : 2 coarse sand : 4graded stone aggregate 20 mmnominal size) finished with a floating coat of neat cement complete asper standard design Inside size 90x80 cm and 45 cm deep including C.I. cover with frame (light duty) 455x610 mm internal dimensions, total weight ofcover and frame to be not less than 38 kg (weight of cover 23 kg andweight of frame 15 kg) :20.7.1.1 With common burnt clay F.P.S. (non modular) bricks of classdesignation 7.5

Providing and fixing aluminum tower bolts ISI marked anodized (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with necessary screws etc. complete :Tower bolt 250x10 mm

Tower bolt 100x10 mm

Handel 150 mm

Handel 10 mm

Providing and fixing of Door spring of approved quality including screws complete

Mohd Ashraf

MOHD AURIF BHAT

M/S Javed Iqbal

FEROZ DIN TRAGWAL