Restoration of various roads under Division No. III Shimla. SH Repair of drain and covering with grating chotta Shimla to Kasumpti road at Rd 0.410 to 0.10 and road from Vikas Nagar to Kasumpati road vid SDA complex at Rd 0.00 to RD0.250.

Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge. Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix)

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-in-charge

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:5:10 (1 cement : 2 coarse sand) : 4 graded stone aggregate 40 mm nominal size)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level. 1:2:4 (1 Cement : 2 coarse sand) : 4 graded stone aggregate 20 mm nominal size)

15mm cement plaster in single coat on the rough side of brick/ concrete/ stone walls for interior plastering upto floor two level including arrises, internal rounded angles, chamfers and/or rounded angles not exceeding 80mm in girth and finished even and smooth in Cement Mortar 1:6 (1Cement:6 Sand) including carriage of materials within all leads and lifts.

Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works.

Disposal of building rubbish / malba / similar unserviceable, dismantled or waste materials by mechanical means, including loading, transporting, unloading to approved municipal dumping ground or as approved by Engineer-in-charge, beyond 50 m initial lead, for all leads including all lifts involved.

Providing and fixing M.S hinges fixing with necessary screws completely of size 125x125x127x2.80mm including carriage of materials within all leads and lifts.

Providing & fixing heavy duty stone glazed pipe over sub base of concerete with 25mm thick average thicknessof cement mortar 1:4 (1cement: 4sand) laid over and jointed with cement slurry mixed complete including carriage of materials in all leads and lifts.200 mm dia.

Dismantling and refixing Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. a) In gratings, frames, guard bar, ladder,railings, brackets, gates and similar works .(Labour rate)