Repairing Painting and shifting of Big Size Hoarding (20 X10 Display Area) of Public Relation Department Haryana under Mechanical Division PWD (BandR) Br Hisar

Amount

HSR Item 1.PM115- PM115. Crane 10 tonne capacity

HSR Item 11.73.1-Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per manufacturer`s specifications including appropriate priming coat, preparation of surface, etc. complete. 1. On steel work

HSR Item 13.30.1-Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. 1. Hot finished welded type tubes

HSR Item 13.32-Providing and fixing bolts including nuts and washers complete.

HSR Item 13.45-Welding by gas or electric plant including transportation of plant at site etc. complete.

HSR Item 15.1.1.1-Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter, dressing of sides and bottom and backfilling with approved material as per clause 304 of MORTandH specifications Ordinary soil 1.1. Manual Means Depth up to 3 m

HSR Item 2.B0979- B0979. MS plates, angles, channels etc. i/c fabrication

HSR Item 2.RM171- RM171. Anchor bolts(25 mm) and nuts for foundation and for fixing plate with truss @ 2% of pipe weight

HSR Item 6.1.6-Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level: 6. 1:4:8 (1 Cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 40 mm nominal size)

HSR Item 6.14.1-Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : 1. 1:1.5:3 (1 cement : 1.5 coarse sand (zone- III): 3 graded stone aggregate 20 mm nominal size)

HSR Item 6.34.3-Steel reinforcement for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect above plinth level. 3. Cold twisted bars

V.K.CONSTRUCTION CO.