Construction of CC and U Drain in abadi bhag of katghar kudwal road ODR and PC in remaining part under Special Repair

Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405. (A)By Manual Means.(Excluding GST)

Providing and applying tack coat with Bitumen VG-10 using bitumen distributor at the rate of 0.30 to 0.40 kg per sqm on the prepared granular surfaces treated with primer & cleaned with Hydraulic broom as per Technical Specification Clause 503. (Excluding GST,Bitumen & machinery)

Providing, laying & rolling of open graded premix carpet of 20 mm thickness composed of 13.2 mm stone grit @1.8 cum/100 sqm and 11.2 mm stone grit @0.90 cum/100 sqm stone aggregates using V.G.-10 bitumen to required line, grade over freshly laid tack coat of bitumen VG-10 with bitumen boiler and sprayer at the rate of 35 Kg. per 100 Sqm including mixing in a deptt. H.M.P. located in Km-208 (Chanda) of Bahraich-Banda Road (SH-13) in Distt. Raebareli, laying and rolling with a three wheeled 80-100 KN static roller capacity finished to required line, level and grades, including cleaning of granular surface, cost of labour & grit but excluding cost of bitumen, hire charges and fuel of HMP and allied machinery required for the proper completion of the work. As per MORD Technical Specification Clause-508. (Excluding GST,Bitumen & machinery)

Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C, excluding cost of bitumen, hire charges and fuel of all machinery required for the proper completion of the work. As per MORD Technical Specification Clause-510. (Excluding GST,Bitumen & machinery)

Cement Concrete Pavement Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, using curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 (Excluding GST)

Construction of Subgrade and Earthen Shoulders Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.2 with lead upto 1000 m as per Technical Specification Clause 303.1. (Excluding GST)

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross-sections, and transporting to the embankment location with a lift upto 1.5 m and lead upto 1000 m as per Technical Specification Clause 302.3 (Excluding GST)

P.C.C grade M 10 (i)Nominal mix 1:3:6 Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 (Excluding GST)

P.C.C. grade M 20 (i)Nominal mix (1:2:4) Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 (Excluding GST)

Brick masonry work in cement mortar in foundation complete excluding pointing and plastering as per drawing and technical specifications Clauses 600, 1 202 & 1 203 II. Brick masonry in 1:4 cement mortar (Excluding GST)

PIastering with cement mortar (1:4), 15 mm thick on brickwork in substructure as per technical specification Clauses 613.4 & 1 204 (Excluding GST)

Please Enable Macros to View BoQ information