Resurfacing of existing BT road from Sasti RC office to SOCM workshop gate and from Gouri Colony junction to Gouri diversion road under Sasti Sub Area.

Providing and applying tack coat with low viscosity bitumen of VG 10 grade using bitumen pressure sprayer on the prepared bituminous/granular surface cleaned with mechanical broom and as per relevant clauses of section-503 of specifications (ii) @0.30 kg per sqm (dry & hungry bituminous surfaces /granular surfaces treated with primer)

Providing and laying bituminous macadam using crushed aggregates of specified grading premixed with bituminous binder, transported to site, laid over a previously prepared surface with paver finisher to the required grade, level and alignment and rolled as per clauses 501.6 and 501.7 to achieve the desired compaction and as per clause 504 of specifications. a) Using Batch Mix Plnt of appropriate capacity and Paver finisher Hydraustatic with Sensor.(ii) for GradingII(19 mm nominal size) bitumen content 3.5%

Providing and applying tack coat with low viscosity bitumen of VG 10 grade using bitumen pressure sprayer on the prepared bituminous/granular surface cleaned with mechanical broom and as per relevant clauses of section-503 of specifications. (i) @ 0.25 kg per sqm (normal bituminous surfaces)

Dense Graded Bituminous Macadam Providing and laying dense bituminous macadam using crushed aggregates of specified grading, premixed with bituminous binder @ 4.0 to 4.5% by weight of total mix of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per clause 505 of specification complete in all respects. a) Using Batch Mix Plnt of appropriate capacity and Paver finisher Hydraustatic with Sensor. (ii) for GradingII(19 mm nominal size)

Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type A and B seal coats all complete as per clause 511 of specification.(ii) Case - II : Type B (Providing and laying of premix sand seal coat with HMP of appropriate capacity not less than 75 tonnes/ hours using crushed stone chipping (aggregate shall pass 2.36mm seal and retained to 180 micron sieve) and penetration bitumen of suitable grade all complete as per clause 511 of specification.

Cleaning of jungle including uprooting of rank vegetation, grass, brush wood, trees and sampling of girth upto 30cm measured at a height of 1m & above ground level and removial of rubbish upto a distrance of 50m outside the periphery of the area cleared. a) RC office to Gouri Junction b) Gouri junction to Workshop gate c)Gouri junction towards Gouri diversion

Construction of Shoulders with approved material/selected soili/c excavation all lifts & leads i/c grading to required slope & camber of 4% and compacting using vibratory roller of 80 to 100 kN static weight to meet requirement as per relevant clause of 400. ( Earthen Shoulders (CBR value >7 )

Total impact of GST for the purpose of CTC