Electrical arrangements for: 1. MS-VM- Improvement to platform and allied works at POTI, CTM, MMNK, SKL, PWU, OV, KGZ, MMK, MLMR, ACK, TZD, OLA, TMV, MTL, PEI, VVN & MYP stations under ADEN/CGL Sub-division. 2. MS-VM- ADEN/CGL Sub Division - Improvement to platform No. 3 Downline and Improvements to Approach roads at Padalam (PTM) Station).

Schedule () 01-ELECTRIFICATION WORKS (NOTE:-(1) THE UNIT RATE TO BE QUOTED SHOULD BE INCLUSIVE OF ALL TAXES AND GST APPLICABLE FROM TIME TO TIME. (2) GST RULES WILL APPLY FOR THE E-TENDER. (3) THE SUPPLY OF GOODS AND SERVICE WOULD BE SUBJECT TO GST ACT AND RULES APPLICABLE FROM TO TIME. (4) For materials of purchase value Rs.5 lakhs and above, inspection shall be done by third party i.e. M/s. RITES and all expenditure in connection with the inspection shall be borne by the tenderer/Contractor . For ISI marked products, if the order is placed on ISI certified manufacturers, the materials can be accepted on firm's WTC.6) Please 3555539.00 refer to clause number 9 in General instructions to tenderers attached in Documents Section regarding Site Engineer condition 7)All accessories and items required for successfull erection/installation ,testing,commissioning of all schedule items as per site conditions is covered under contractor's scope of work 8)All items required for all schedule items where wiring and cabling is to be terminated at both incoming ends for successful installation/erection, testing and commissioning commissioning is covered under contractors scope of work. Above/

atleast 6m away from track centre within railway land by saw cutting/breaker as per site conditions to avoid any damage to nearby site complete in a manner as directed by the Section Engineer in- charge at site. Above/

ar 02 CHENNAI DIVISION-ELECTRICAL/SOUTHERN RLY Description:- Supply and provision of mass concrete for platforms or elsewhere with 1:2:4 ratio using 20mm graded blue metal complete in a manner as directed by the Section Engineer in chargeat site. NOTE: i)Cement shall be Ordinary Portland Cement, 43 grade, conforming to IS: 456 or latest. ii)Proper compaction of cement concrete shall be ensured as per standard industrial practices. iii)The finished level should match with surface level properly Above/

threading through pipe, clamping on walls and terminating in as many ends using suitable single compression cable glands, lugs , sockets and other items required complete as per site conditions in a manner complete as directed by Section Engineer in charge at site. Note:- 4Cx16 sq.mm LTUG Aluminium Cable alone will be supplied departmentally. Above/

threading through pipe, clamping on walls and terminating in as many ends using suitable single compression cable glands, lugs , sockets and other items required complete as per site conditions in a manner complete as directed by Section Engineer in charge at site. Note:- 4Cx50 sq.mm LTUG Aluminium Cable alone will be supplied departmentally. Above/

threading through pipe, clamping on walls and terminating in as many ends using suitable single compression cable glands, lugs , sockets and other items required complete as per site conditions in a manner complete as directed by Section Engineer in charge at site. Note:- 4Cx70 sq.mm LTUG Aluminium Cable alone will be supplied departmentally. Above/

ar Description:- Laying of 50 mm dia High Density Polyethylene pipes in the excavated trench,

arrangements and couplers and other accessories required at appropriate locations as per site conditions so that cable can be easily inserted and removed wherever need arises complete in a manner as directed by Senior Section Engineer-incharge at site. Note: 50mm dia HDPE pipe alone will be supplied departmentally. Above/

ar Description:- Laying of 75 mm dia High Density Polyethylene pipes in the excavated trench,

arrangements and couplers and other accessories required at appropriate locations as per site conditions so that cable can be easily inserted and removed wherever need arises complete in a manner as directed by Senior Section Engineer-incharge at site. Note: 75 mm dia HDPE pipe alone will be supplied departmentally. Above/

ar Description:- Installation, Testing and Commissioning of the LT Earthling arrangements duly by

masonry earth pit enclosure, provision of cover etc., complete including supply / leading / laying / burying and concealing of GI strip 32 X 6 mm along with proper sleeve from earth electrode to proposed MDB / SDB or elsewhere and in a manner as directed by Senior Section Engineer in charge at site. Note: 1) Masonry earth pit enclosure and cover shall be as per drawing number EL/P/TYPE/1022. 2) LT Earthling Electrode alone will be supplied Departmentally Above/

ar 09 CHENNAI DIVISION-ELECTRICAL/SOUTHERN RLY Description:- Erection, testing and commissioning of 5 meter Double arm octagonal pole assembly onto the suitable RCC foundation and coping by using modern engineering practice including installation, testing and commissioning of LED luminaries including all wiring works from nearby junction box as per industrial standards complete in a manner as directed by Section Engineer in charge at site. Note: 1) The foundation design and drawing along with supporting IS specifications suitable for Octagonal poles supplied by Railways and as per site conditions should be submitted for approval before starting the work . 2) Five meter double arm Octagonal pole and accessories along with luminaries alone will be supplied departmentally. Above/

ar Description:- Supply and stringing of overhead mains beneath platform shelters using 5 runs of 16

onto insulators of brackets provided vide item No. 11 Below complete in a manner as directed by Section Engineer in charge at Site. Note: 1)5 runs of 16 sq.mm cable are taken as 1m for unit purpose. 2)The earth wire should be lugged at both ends and has to be terminated in each MS clamp through Nuts and Bolts Above/

supporting OH wire beneath platform shelters, mounted with 4 Nos. of porcelain vertical reel/shackle insulators and earth stud / bolt, finished with 2 coats of red primer and 1 coat of aluminium paint and complete with fixing arrangements as per drawing enclosed and in a manner as directed by Section Engineer in charges at site. Above/

ar Description:- Installation, Testing and commissioning of 1200mm sweep BLDC ceiling fan onto the

practices including supply connection from ceiling rose by using 3 core 1.5 sq. mm fire retardant Low smoke PVC insulated, PVC round sheathed copper [White / Ivory colour] conductor flexible pendant chord [conforming to IS:694/1990 or latest] complete in a manner as directed by Senior Section Engineer in charge at site. Note: 1200mm sweep BLDC Ceiling fan alone will be supplied departmentally. Above/

wall / stanchion / rail post or elsewhere using suitable clamping arrangement made of 40mm X 6mm MS flat and MS plate of size of 300mm X 300mm X 6mm complete in a manner as per standard industrial standards and in a manner as directed by Section Engineer in charge at site. Note: 600mm sweep BLDC Air circulators alone will be supplied Departmentally Above/

ar Description:- Installation, Testing and commissioning of SMC box assembly similar to Sintex

carriers onto lamp posts or elsewhere suing suitable clamping arrangements complete and in a manner as directed by Section Engineer in-charge at site Note: SMC GSJB-3020 box, strip connector, neutral link, Earth link ,Fuse bases and fuse carriers, MS clamping arrangements alone will be supplied Departmentally. Above/

ar Description:- Installation, Testing and commissioning of 100 W LED flood light fittings with supply of suitable clamps and mounting arrangements with all standard accessories and fixing of clamps

rose or elsewhere as directed by Section Engineer in charge at site by using 3 core 1.5 sq. mm Fire retardant low smoke PVC insulated, PVC round sheathed copper [White/Ivory colour] conductor flexible chord [conforming to IS:694/1990 or latest] complete in a manner as directed by Section Engineer in charge at site. Duly releasing old existing light fittings and handing over to Senior Section Engineer in charge at site if any. Note: 100 W LED flood light fitting alone will be supplied departmentally. Above/

ar CHENNAI DIVISION-ELECTRICAL/SOUTHERN RLY Description:- Installation, Testing and commissioning of time switch assembly comprising of: - a)1 No. timer switch with daily setting similar to L&T catalogue reference J648B1 [FM1 Quartz]. b)1 No. 3 pole 25A power contactor conforming to IS: 13947/P4/1993 or latest, c)1 No. 40A DP [MCB type]

Suitable rated control fuses all duly pre-wired and mounted on an appropriate sized well-seasoned wooden plank of thickness not less than 12 mm and duly housed into and powder coat finished enclosure of size not less than 300mm X 450mm X 300mm and made of 2mm thick Sheet Steel complete and provision of the same onto the wall or elsewhere using suitable fixing arrangements complete and in a manner as directed by Section Engineer in charge at site. Note: Timer switch, Power contactor, MCB, Neutral Link, Earth link, fuses, wooden box, Enclosures alone will be supplied Departmentally. Above/

ar Description:- Installation, Testing and commissioning of SMC box assembly similar to Sintex

carriers onto lamp posts or elsewhere suing suitable clamping arrangements complete and in a manner as directed by Section Engineer in-charge at site Note: SMC GSJB-1414 box, strip connector, neutral link, Earth link ,Fuse bases and fuse carriers, MS clamping arrangements alone will be supplied Departmentally. Above/

ar Description:- Installation, Testing and Commissioning including concealing work along with metal

per industrial practices with 1 No. 20 A, SP, MCB onto the walls including cutting/chipping and replastering and bringing back walls to original condition including painting in a manner as directed by section engineer in charge at site. Note: Metal clad plug and socket with Enclosure and MCB alone will be supplied Departmentally. Above/

ar Description:- Installation, Testing and Commissioning including concealing work along with metal

per industrial practices with 1 No. 20 A, FP, RCBO onto the walls including cutting/chipping and replastering and bringing back walls to original condition including painting in a manner as directed by section engineer in charge at site. Note: Metal clad plug and socket with Enclosure and RCBO alone will be supplied Departmentally. Above/

ar Description:- Installation, Testing and commissioning of 4 feet 36W LED light fitting Batten type suitable to work on 240V single phase 50 Hz AC with lamp and all standard accessories using

from ceiling rose by using 3 core 1.5 sq. mm Fire Retardant Low Smoke PVC insulated, PVC round sheathed copper [White/Ivory colour] conductor flexible pendant chord conforming to IS:694/1990 or latest complete as per industrial standards and in a manner as directed by Senior Section Engineer in charge at site. Note: 4 feet LED 36W light fitting Batten Type with lamp alone will be supplied Departmentally Above/

ar Description:- Installation, Testing and commissioning of 45 W LED street fittings using suitable GI

supply connection from ceiling rose/junction box or elsewhere by using 3 core 1.5 sq. mm Fire retardant low smoke PVC insulated, PVC round sheathed copper [White/Ivory colour] conductor flexible chord conforming to IS:694/1990 or latest as per industrial standards in a manner as directed by Section Engineer in charge at site. Note: 45W LED street light fittings alone will be supplied departmentally. Above/

ar 22 CHENNAI DIVISION-ELECTRICAL/SOUTHERN RLY Description:- Supply and Drawing of inside mains using 3 runs of 1.5 sq. mm [from MCB DB to switch boards and from switch boards to switch boards / modular furniture or elsewhere] fire retardant Low smoke PVC insulated unsheathed multi-stranded copper conductor cables conforming to IS:694/1990 or latest duly inside the PVC conduit concealed / laid vide item No. 23 below complete as per the specification enclosed and in a manner as directed by Senior Section Engineer in charge at site. Note: - 3 runs of 1.5 sq. mm copper conductor are taken as 1m for quantity purpose Above/

ar Description:- Supply and Concealing of 20mm dia rigid PVC conduits [IVORY colour] along with all

elsewhere and making good the same including replastering and painting wall to original condition/cIamped at regular intervals, not exceeding 500 mm in a manner as directed by Section Engineer in charge at site and as per specification for wiring/ rewiring enclosed. [Approximate length of PVC conduit] Above/

ar Description:- Erection, Testing, testing and commissioning of 300mm width X 50mm height made of 2.00mm thick hot dip galvanized Sheet steel complete with all accessories including coupler plate,

flats for the cross members duly supported from walls/ ceiling/roof purloins/structural steel works or elsewhere using intermediate supports by 40x6 mm MS flats complete in a manner as directed by Section Engineer-in-charge at site. Note:- 1)The cable tray supports shall be applied with two coats of red oxide primer and painted with two coats of bright aluminium paint. 2)Cable tray alone will be supplied Departmentally Above/

125A,36 kA, FP, MCCB's as Incomer along with (3 No's 63A,30 kA, FP, MCCB+3 Nos 32A, 30kA, FP MCCB) as outgoing including all cable termination at both Incoming and Outgoing sides complete and as per industrial practices complete in a manner as directed by Senior Section Engineer in charge at site. Note: MCCB DB, MCCB alone will be supplied Departmentally Above/

ar Description:- Erection, Testing and commissioning of 2 HP energy efficient five star submersible

three phase AC supply along with all accessories including fixing and mounting arrangements and other items required for successful commissioning of pump complete as per site conditions and as per industrial standards in a manner as directed by Section engineer in charge at site. Note: 2 HP BORE WELL Submersible pump with Control panel assembly alone will be supplied Departmentally Above/

ar 27 Description:- Providing of saw cutting in concrete pavement 200mm to 250mm depth including all men and materials under contractors scope of work .Cutting the concrete side by side and sufficiently removing the concrete is to be done by contractor using his own men and materials. Above/

wall or elsewhere using suitable angle iron frame work and mounting and fixing arrangements as per industrial standards including all wiring and cable termination works at both Incoming and outgoing sides complete in a manner as directed by Section Engineer in charge at site. Note: 63A, 30kA, FP, MCCB with Enclosure alone will be supplied Departmentally. Above/

ar Description:- Installation, Testing and commissioning of 125A, 30kA, FP, MCCB with Enclosure onto

industrial standards including all wiring and cable termination works at both Incoming and outgoing sides complete in a manner as directed by Section Engineer in charge at site. Note: 125A, 30kA FP, MCCB with Enclosure alone will be supplied Departmentally. CHENNAI DIVISION-ELECTRICAL/SOUTHERN RLY Above/

ar D e s c r i p t i o n : - Installation, Testing and commissioning of TPN MCB DB's with 40A/63A/100A,FP,MCB/RCBO/MCCB/ RCCB as Incomer along with combination of SP/DP/FP,MCB's as

including cutting/chipping and re-plastering and bringing back walls to original condition including painting the walls to original condition complete including all wiring and termination works at both incoming and outgoing ends complete and as per industrial practices in a manner as directed by Senior Section Engineer in charge at site. Note: MCB DB, MCB, Cable adaptor box etc alone will be supplied Departmentally