OT24

Amount

Overhauling & gasket renewal of Stator water cooler and CCW inlet and outlet valves of stator water coolers. a)Dismantling of stator water coolers, CCW boxes covers in both sides of stator water coolers, water boxes, cleaning of tubes, plugging of tubes if necessary, painting the inner side of cooling water boxes by anti-corrosive black paint, replacing the 12 x12mm HR rubber cord with new one and reassembling of the water boxes including the cost of materials.

b)Hydraulic test of stator water coolers to ensure the healthiness of the cooler.

c)Assembling the stator water coolers CCW boxes covers, replacing 5mm thickness HR Rubber Gasket with new one and satisfactory commissioning including the cost of materials

d)Overhauling of CCW Inlet & Outlet Butterfly valve (DN200mm) in Stator water system

Overhauling & Gasket renewal of CCW Inlet & Outlet Hand operated Gate valve (DN 150mm) in H2 cooler a)Overhauling of 150mm hand operated Gate valves in H2 coolers.

b)Gasket renewing for 150 mm hand operated gate valve in H2 coolers, this work involves Removing the valve from line, Cleaning The flange surface on both sides, Preparation of gaskets for both ends, positioning the valve in the Line with gaskets and tightening the flange bolts & nuts.

Complete overhauling of Generator Stator water pump

Plant compressor Inter cooler, After Cooler and oil cooler cleaning work. a)Dismantling /Assembling the Inter cooler /After Cooler bunch then checking for leakage & plugging the leak tubes. Inclusive of Hydro test

b)Dismantling the oil cooler after isolation of cooling water line. Cleaning of tubes Reassembly of the tube bundle with renewal of ‘O’ ring /gasket. Normalization of the cooling water lines .cleaning oil spillage in the compressor completely.

Repair and reconditioning of 150mm butterfly valve in Instrument air dryer complete dismantling of valve internals and renewal of wornout spares and painting of valves including all required consumables.

Instrument Air Compressor-B Crank Case shaft seal replacement work. a)Disconnection of power cable , De-coupling the motor from compressor and checking (alignment)

b)Removal of foundation bolts, lifting the motor to a convenient location in the compressor room

c)Dismantling of motor pulley,end covers and threading out of the motor

d)Charges for dismantling and removal of worn out gear case shaft sleeve and oil seal and renewal of new shaft seal and oil seal in gear case.

e)Lifting of motor, placing at bed and tightening of foundation bolts, bed bolts etc. after completion of works.

f)Termination of power cable, coupling the motor with pump , checking the alignment and trial run

Overhauling and Changing of contaminated lubricating oil by new Servo frisz 68 oil and complete filling of R134a Refrigerant Gas of Generator H2 Dryer – A a)H2 dryer expansion valve replacement work with R134a gas filling.

b)H2 dryer compressor overhauling work.

JS ENGINEERING WORKS