REPAIR TO HARDSTANDING COMPOUND WALL FENCING GATE DRAIN FOOT PATHS AND OTHER MISC WORK OF INSP ORGN AT AUNDH UNDER GE MH AND RH KIRKEE

Amount

Dismantling stone slabs and tiles of any description or thickness in floors, aprons etc laid bedded and pointed in any mortar

Demolition of cement concrete un reinforced in ground floors and pavings n.exc 15 cm thick below or above ground level.

Demolition of reinforced cement concrete (reinforcement cut as required to facilitate demolition) in any position below or above ground floors, not exceeding 15 cm in depth and removing the material of the premises complete all as specified and as directed.

Dismantling wrought iron or mild steel work of any description all as specified

Dismantling fencing wire mesh any type

Dismantling of plain or corrugated steel sheeting, any gauge, thickness, including Nainital or similar pattern roof coverings

Demolition of brick work, PCC block mansonry or stone boulder masonary built in cement mortar including all quoins arches pillars etc. but excluding ashlar facing dressed stone work and precast concrete articles.

M&L for 75mm thick Cement concrete M-7.5 grade (nominal mix) using 40mm graded stone aggregate as in sub base floor and paving etc all as specified

M&L for 75mm thick Cement concrete M-15 grade (nominal mix) using 20mm graded stone aggregate as in floor and paving etc all as specified

M&L Cement concrete M-7.5 grade (nominal mix) using 40mm graded stone aggregate as in foundation filling and mass concrete all as specified and directed.

Excavating in trenches not exc 1.5m wide and not exc 1.5m in depth and getting out in hard / dense soil complete all as specified and directed.

Returing, filling, in including spreading, leveling, watering well ramming in layers n;exc 25cm thick with soil obtained from excavation complete all as specified.

Removing excavated material to distance exc 250m but not exc 500m and depositing where as directed at a level not exc 1.5m above the starting point.

M&L for RCC M-25 (design mix) in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete all as specified

M&L for RCC M-25 (design mix) in columns, pillars, piers, posts and struts all as specified

M & L for steel formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter for rough finished flat surfaces of concrete complete all as specified and as directed.

M & L for steel formwork to sides of pillars, posts, struts, piers, columns and stanchions for rough finished flat surfaces of concrete complete all as specified and as directed.

S&F of TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips Fe-410-W (Gde.E-250)

All as per item No 18 above, but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders

M&L Coloured Glazed ceramic tiles in vertical surface 350x 250x 7 mm/ 450X 300X 7mm thick set and jointed in neat cement slurry and pointed in white or colour cement to match over & including 10 mm thick rendering as in backing coat in CM 1:4 all as specified.

M&L for 20mm thick Granite (of any type) tiles machine cut, in skirting/ dado laid over cement screed and jointed with grey cement slurry, and pointed with white cement with admixture of pigment to match the shade of granite stone including grinding and polishing complete fixed over and including backing coat of 10mm thick in CM 1:4 all as specified

M & L for 80mm thick M-40 grade coloured glossy finished interlocking tiles / blocks any shape and size, jointed & pointed in neat cement slurry with pigment to match the shade of tile etc complete all as specified and as directed.

M&L Cement concrete M-10 grade (nominal mix) 40mm graded stone aggregate in surface channels and drains all as specified

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mi- tred/stopped ends etc

M&L for Pre-cast cement concrete block masonry of PCC 1:3:6 Type C1 using 20mm graded stone aggregate with solid blocks straight or curved on plan , exc 6m mean radius and exc. 10 cm in width and setting in cement mortar 1:6 complete all as specified and directed by Engr-in-Charge.

M&L for providing cement concrete type M-15 grade (Nominal mix) using 20 mm graded aggregate as in copings kneelers, apex stones, pier caps, columns, posts, boundary pillars, bed plates, pintle blocks, ancho-rage blocks, bonders (for stone wallin). corbels, brackets, etc. (of any section indicated), with plain fair faces, including chamfers, weatherings, throat- ing etc. and setting in mortar complete with joints to match including necessary form work.

M&L for PCC M-15 grade (nominal mix) using 12.50mm graded stone aggregrate as in coping, hold fast, block bed block filling pressed steel door frame etc complete all as specified.

M & L for rendering 15 mm thick on fair faces of block masonry surfaces in cement plaster 1:4 complete all as specified and directed

Supply only galvanized steel chain link fence fabric of mesh 50 x 50 mm, made out of 2.50 mm nominal dia of mesh wire complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed.

S & F MS angle iron in fencing posts & struts including cutting tops to shape as directed, drilling holes, notching for wire etc, flat iron fillets ( for securing wire mesh etc) including all necessary, drilling, bolting or riveting etc and similar work conforming to Fe-410-0 or Fe-310-0.

S&F Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, Doors etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive or steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete Fe-410-W(Gde E-250) quality-B.

M & L for PCC M-15 grade (nominal mix) 40 mm graded stone agggrgates as in foundation of rails post etc.all as specified

S & F 10 mm dia MS round bars for tightening of chain link fencing woven through chain link & fitted completely.

M&L for walling of random rubble, uncoursed, well bounded,bedded and solidly hearted, built in CM 1:6 all as specified and directed

Extra over stone walling for hammer dressing to face stones and dressing of face beds and jointse held against the dressed surface n exc.40mm, as specified, of random rubble walling, uncoursed or brought upto courses

M&L for Keyed pointing to random or polygonal rubble, uncoursed or brought upto course in CM 1:4 all as specified and directed

M&L Chequred Cement concrete coloured tiles 30 cm x 30 cm x 20 mm thick, glossy finished set jointed and pointed in neat cement slurry in floors, and cut and polished with grey cement and pigments laid over & including 15mm thick screed bed or bedding layer in CM 1:4 complete all as specified and as directed.

S&F vitrified body tiles 10mm thick (square/ rectangular) area of each tiles 300X300mm in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match with the tiles laid over and including 15mm thick screed bed or bedding in layers in cement mortar 1:4 all as directed

M&L for sand/ stone dust filling under floors including consolidation for laying paver block all as specified

M&L for welding in repairs exc 2.5 cm but n.exc 5.0 cm in length of thickness of metal n.exc 6mm

M&L for running welding in repairs of metal thickness to be welded n.exc 6mm

S & F galvanized steel barbed wire with two strands of line wire of dia 2.24 mm and barbed with point wire of dia 2 mm at 75 mm spacing straining and fixing to any type of standards, rails, straining bolts including securing or tying at crossings with and provision of galvanised iron binding wire, GI staples or steel pins, etc. complete all as specified and as directed . Note : Two strand of line wire will be measured as one unit length.

Restraining & rescuring including making good staples etc. galvanized steel barbed wire with two strands of line wire of dia 2.24 mm and barbed with point wire of dia 2 mm at 75 mm spacing straining and fixing to any type of standards, rails, straining bolts including securing or tying at crossings with and provision of galvanised iron binding wire, GI staples or steel pins, etc. complete all as specified and as directed. Note : Two strand of line wire will be measured as one unit length.

S&F Pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as per IS 15965: 2012 in roof covering fixed with self tapping screws including dismantling old roof sheet of CGI/PGI complete all as specified.

S&F of Rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates of Gde Fe-410-W(Gde-E250) quality-A

M&L for providing precast cement concrete M-10 grade (nominal mix) using 12.5mm graded aggregate louvres and jallies, 25mm thick (mea sured solid), including all mould- ings but excluding frame set in cement mortar 1:4 all as specified.

M&L for preparation of untreated new steel surfaces of any description over 10cm width or girth and applying two coats of synthetic enamel paint ( 1st grade quality ) over a coat of red oxide primer complete all as specified and as directed.

M&L for preparation of newly plastered surfaces of wall and applying two coats of cement base paint including scaffolding, trestles, ladders, cradles and necessary safety measures complete all as specified and as directed.

V.R.PRAJAPATI AND CO.

s.k.engineers

Vastushilpa Contrustion

M/S JAYCONSTRUCTION CO

MANIYA CONSTRUCTION CO

MAHESH DADAJI BACHHAV

S.R.M.K Enterprises

A S Shingote

JP ENTERPRISES