GE/BAS-20/2025-26 Repair to boundary wall, fencing, drain, path, culvert, gate, facia, chajjas, plaster and misc works etc at Madhopur Mil station under GE Basoli

Amount

Demolition of brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars etc but excluding ashlar facing, dressed stone work and precast concrete article complete all as specified and directed.

M & L brick work with subclass 'B' bricks straight or curved on plan exc 6.0 mean radius built in CM (1:4) complete all as specified and directed.

All as serl item No 02 here-in-before but except brick

M & L brick work with subclass 'B' bricks straight or curved on plan in any radius in half brick thick built in CM (1:4) complete all as specified and directed.

All as serl item No 04 here-in-before but except brick

M&L Plain Cement Concrete Type C-2 1:3:6 (using 40 mm graded crushed stone aggregate) in surface channels and drains including Demolition of un-reinforced cement concrete in ground floors and pavings n exc. 15 cm thickness (below or above ground level) complete all as specified and directed .

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement including forms moulds mitered/stopped ends etc complete all as specified and direceted

M&L for preparation of old steel and iron surfaces exceeding 10 cms width or girth and applying one coat of synthetic enamel paint complete all as Specified and directed.

M&L for preparation of old steel and iron surfaces exceeding 10 cms width or girth and applying two coat of synthetic enamel paint complete all as Specified and directed.

Taking down cement or cement plaster on bricks or stone wall etc including racking out joints,hacking for keys,scruubing down with water etc complete all as specified and directed.

M&L for rendering 15 mm thick plastering 1:4 CM, using WPC @ 0.20ml per bag of cement ,finished even and smooth without using extra cement etc complete all as specified and directed. Note: WPC Shall be measured and paid sepertaly.

M&L preparation of newly plastered surfaces of walls and applying two coats of cement base paint complete all as specified and as directed.

M&L for 10 to 12 mm dia round bars, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specifed and directed .

Supply only mild steel galvanised chain link fencing including line wires any mesh size 50x50x3 mm and any type of standards , nails, straining bolts, etc including provision of binding wire and nut-bolts, flats etc complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specifed and directed.

Dismantling expanded metal, any thckness or mesh, any type of weightnot exc 4.00 Kg/Sqm, fixed with steel or wood fillets complete all as specifed and directed.

M&L Applying two coats of synthetic enamel paint over & including a coat of red oxide zinc chrome primer over new steel & iron surfaces of any description, not otherwise described, over 10 cm in width or girth, including preparation of surfaces complete all as specified and directed.

S & F in repair galvanised 2 strand steel barbed wire 2-24 mm dia barded with 2mm dia bar at 75 mm spacing and straining and fixing to any type of standard rail, standard bolts incl securing or tying at crossing with and provn of galcanized mild steel wire staple or steel pins (Each line of wire to be measured) complete all as specified and directed.

Restraining and resecuring of steel barbed wire fencing including making good staples etc complete all as specified & directed (each line of wire to be measured separately) complete all as specified and directed.

M&L 18-20mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window cills, cooking platforms including chamfering,rounding,moulding,hole for gas pipe and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite complete all as specified and directed.

M&L 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc.,of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand including 75 mm thick cement concrete type C-2 1:3:6 (40mm graded crushed stone aggregate) as in sub base complete all as specified and directed.

M&L 80mm thick factory made chamfered edge cement concrete paver block of M-40 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc.,of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand including 100 mm thick cement concrete type C-2 1:3:6(40mm graded crushed stone aggregate) as in sub base,including demolition of existing complete all as specified and directed.

75mm thick PCC 1:3:6, type C-2 using 40mm graded stone aggregates as in sub bases of floors and pavings complete all as specified and directed.

M & L colour chequrred cement tiles with grey cement and pigment 30cmx30cmx25mm thick set, jointed in neat cement slurry including 15mm thick screed in CM1:4 complete all as specified and directed.

M & L for Endura heavy duty virtified tiles of size 300mmX300mmX10mm thick set jointed and pointed in neat cement slurry in floors with grey cement and pointed in white cement with pigment over 15 mm thick screed bed of 1:4 cement mortar complete all as specified and directed.

M&L Preparing old plastered or unplastered surfaces of walls and applying two coat of cement based paint complete all as specified and directed..

Material and labour for plain cement concrete type B-1 1:2:4 (20mm graded stone aggregate) as in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses,lacing courses, parapets and railings upto 60 cm in height,copings, kneelers, apex stones, bed plates, kerbs ,water troughs and the like including weathering, slightly rounded or chamfered angles and throating, including necessary form work complete all as specified and directed.

S&F MS framed work conforming to Gde Fe 410-W as in doors or gates of angle or other section with gussetplates ,rails ,braces .etc complete drilled for fixing of steel sheeting or other covering .Doors etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fitting (exclusive steel sheeting) complete all as specified and directed.

M&L Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc. and similar work conforming to Fe-290 Gde E-165

S&F Pre-painted galvatume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws including Dismantling of asbestos cement (corrugated, semi corrugated etc) sheets in roof coverings complete all as specified and directed.

Dismantling posts or struts Precast R.C.C.) any section, including taking out embedded portion of concrete and making good disturbed ground complete all as specified and directed

M&L Cement concrete M-10 (Nominal mix),type C-2, 1:3:6, (using 40 mm graded crushed stone aggregates) in foundation filling and mass concrete, post holes etc complete all as specified and directed

M&L for Rendering 10mm thick on brick work or concrete surface in cement mortar 1:6 finished even and smooth without using extra cemen tincluding complete all as specified and directed.

M&L for Rendering 5mm thick on brick or concrete surface as in ceiling in cement mortar 1:3 finished even and smooth without using extra cement including Taking down cement plaster, any description on brick or stone or cement concrete walls including raking out joints, hacking for key, scrubbing down with water complete all as specified and directed.

Extra over rendering or plastering for work in isolated widths or in widths not forming part of general plastering such as in bands, sunk panels, cornices, skirtings, drip moulds and similar work exceeding 15 cm but n.exc 30 cm.complete all as specified and directed

M&L in repair to old broken chajjas and facia by removing loose portion of concrete/plaster and making the surfaces in line, level and plumb by applying cement plaster in cement mortar 1:3 of thickness not less than 10 mm thick including dubbing out in the same mortar or in cement concrete 1:1.5:3 as per site requirement upto height 8 mtrs and in any position,(including apex paint ) complete all as specified and directed. Note : Rate quoted shall be deemed incl for scaffolding/formwork for single/double storey building of height upto 8 mtrs and making good the disturbed services

S&Fin repair galvanised mild steel wire cloth, 0.56mm nominal dia wire and average width of aperture 1.18mm and fixed with tinned tacks or galvanised wire staple complete all as specified and directed .

S&F in repair 4 mm thick sheet glass ordinary quality and glazing with oil putty or wooden beads in squares not exceeding 0.50 Sqm in each pane complete all as specified and directed

S&F in repair Aluminium anodised barrel tower bolts of extruded section with 150 mm long bolt, complete all as specified and directed.

S&F in repair Aluminium alloy, anodised, sliding door bolt 250 mm with hasp, staple (bolt type) and fixing clips of sheet, cast or extruded sections and fixing bolts and sliding bolts of extruded sections or cast aluminium alloy and fixed complete all as specified and directed

S&F in repair mild steel cold rolled butt hinges medium weight 100 mm long complete all as specified and directed

S&F in repair mild steel cold rolled butt hinges medium weight 75 mm long complete all as specified and directed

S&F in repair Extruded aluminium alloy handles fabricated type anodised and fixed, 150 mm size complete all as specified and directed

S&F 100mm size hasp and staple safety type aluminum anodized with mild steel hinges pin including bolt to hinge plate and fixed with screw complete all as specified and directed

S&F in repair floor door stopper of Aluminium alloy body and tongue, anodised with hard drawn steel spring fixed in floor overall length 150 mm including valcanised rubber piece complete all as specified and directed

S&F in repair Aluminium (extruded section body)Door closer hydraulically regulated, designation No 3, universal type, suitable for door shutters of 851 to 1000 mm in width and of weight between 61 to 80kg complete all as specified and directed

S&F 300 mm ordinary rat tail rod pattern spring incl roller and roller plate (mild steel) complete all as specified and directed

S&F in repair 20mm dia Harrison rails, mild steel, chromium plated with fixing brackets, stops, rollers etc. complete all as specified and directed

M&L for applying three coats of white wash on ceiling including preparation of newly plastered surfaces complete all as specified and directed.

M&L for applying Two coats of oil bound distemper on walls including preparation of newly plastered surfaces complete all as specified and directed.

M&L 1mm thick wall care putty on wall surfaces complete all as specified and directed

M&L for complete removal of existing treatment and applying Two coats of oil bound distemper on walls surfaces complete all as specified and directed.

M&L for complete removal of existing treatment and applying Two coats of cement base paint on walls surfaces complete all as specified and directed.

M&L Preparing new surfaces, plastered or unplastered of walll and applying two coats of weather proof exterior emulsion paint over a coat of primer on walls.complete all as specified and directed

M&L for cement concrete work in pavement/Hard Standing of flexural strength 40Kg/ Square centimetre in field using 400 Kg of cement per cubic metre, thickness of concrete 25cm or less,including demolition of cement concrete(unreinforced) complete all as specified and directed. Note: (a) Rate shall include for formwork of side form for laying pavement concrete/hard-standing in bays between joints & contraction expansion joints/or between the two contraction joints for thickness of pavement upto and including 25cm. (b)concrete shall be designed properly as per specification and flexural strength.

M&L for forming 12mm thick Expansion Joints for 150mm thick hardstanding filled with pre-formed bituminious filler and top 30mm primed and sealed with compound,Grade-A, complete all as specified and directed.

M&L for forming longitudinal Joints for 150mm thick hardstanding filled with sealing compound complete all as specified and directed.

Supply only Liquid water proofing compound complete all as specified and directed.

Renewing tiles in patches,area n exc 5 Sqm including removing and cleaning old Glazed tiles,preparing beds and laying or setting, jointed and pointing new or old tiles complete all as specified and directed.

Renewing tiles in patches,area n exc 5 Sqm including removing and cleaning old cement concrete tiles,preparing beds and laying or setting, jointed and pointing new or old tiles complete all as specified and directed.

Taking down eaves and rainwater pipes (any size or pattern), including all fittings, heads, shoes, bends swan necks, etc, including cleaning or refixing or removal to store (measured overall as fixed along the centre line over fitting and accessories ) complete all as specified and directed

S&F PVC (SWR) pipes single socketed in any length with rubber ring joints fixed to walls of bore 110mm.complete all as specified and directed

S&F PVC(SWR) bends any radius of bore 110 mm.complete all as specified and directed

M&L for Preparing old wall surface including making surface clean, dry and free from any loose paint film, dirt, chalk, grease, fungus and algae and applying two coats of acrylic, antifungal emulsion exterior weather proof paint on external surfaces, complete all as specified and directed.

Ashoka Engineers (BID ID -3338120)

Standard engineers (BID ID -3337884)

Ms Narinder Kumar Sehgal (BID ID -3327502)

M/S SURINDER KUMAR MAHAJAN (BID ID -3329004)

R K Builders (BID ID -3328840)

M/s GIrdhari Lal Rakesh Kumar (BID ID -3328415)