REPAIR/ REPLACEMENT OF DRAINAGE SYSTEM FENCING FOOTPATH HARDSTANDING BOUNDARY WALL PARAPETS CULVERTS AND GATES UNDER AOR OF AGE B/R I AT AFS CHAKERI KANPUR

Amount

Demolition of brick work built in cement or cement lime mortar including all quoins, achies, pillars complete all as specified as directed.

Taking down cement plaster on brick or stone walls etc including raking out joints, hacking for key scrubbing down with water etc complete all as specified and as directed

Dismantling floor, hearth or wall tiling incl cement mortar bedding ( but not backing) and rubbish off the premises complete all as specified and directed.

M & L Brick work with fly ash bricks, Straight or curved on plan exc. 6 m mean radius built in CM 1:6, complete all as specified and directed.

-ditto- as per item No 4 here in before above except bricks Note:- Old bricks obtained from item No 1 shall be reused after cleaning.

M&L for rendering 15 mm thick in CM ( 1:6 ) on other than fair face of brick/concrete surfaces finish even and smooth without using extra cement complete all as specified and directed.

M&L for rendering 15 mm thick in CM ( 1:4 ) on other than fair face of brick/concrete surfaces finish even and smooth without using extra cement complete all as specified and directed. Note : Bidder shall be considered height of bldgs upto 2nd storey while quoting unit rates by them and wherever scaffolding is necessary is deemed to be included in quoted rates.

M&L10 mm thick plaster in cement mortar (1:4) on ceiling finished even and smooth without using extra cement complete all as specified and directed .

M & L preparation of new surfaces and applying three coats of white wash on ceiling with chicken wire if necessary where ever required complete all as specified and directed.

M & L for preparation of new undecorated surfaces of walls and applying two coat of Oil Bound Distemper over and including a coat of primer and 2 mm thick wall care putty approved quality , all as specified and directed.

M&L preparing new plastered surface of wall and applying two coat of cement base paint over coat cement primer complete all as specified and directed.

Demolition of cement concrete in ground floor and paving not exceeding 15cm thick (below or above ground level) including removing the debries out side the MD Land complete all as directed by Engineer-in-Charge.

M&L 25mm thick cement concrete type B0, 1:2:4, (using 12.5 mm graded stone aggregate) as in sub base for floor complete all as specified and directed.

M&L for PCC (1:2:4) type B-1 as in flooring 40 mm thick using 20 mm graded stone aggregate cement concrete finish even and smooth with using extra cement complete all as specified and directed.

S&F 3 mm thick Glass dividing strips of width 38mm for laying in floor complete all as specified and directed

M&L 75mm thick PCC (1:3:6) type C2 using 40mm graded stone aggregate as in plinth protection /path and paving and finished even and smooth without using extra cement complete all as specified and directed

M&L for Vitrified Ceramic dark shade tiles 10 mm thick (square/ rectangular) polished , area of each tiles not exceeding 0.36 sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match and laid using spacers over and including 15 mm thick screed bed in CM 1:6 set & jointed in neat cement slurry complete all as specified and directed

M & L for Vitrified Ceramic dark shade tiles 10 mm thick (square/ rectangular) polished , area of each tiles not exceeding 0.36 sqm, in dado/ skirting etc set over and including 10mm thick cement plaster 1:3 as backing coat , jointed in neat cement slurry & pointed with colour cement to match complete all as specified and directed.

M & L for Kota stone slabs, machine cut 20 to 25mm thick, set and jointed in neat cement slurry and pointed in cement slurry to match including rubbing and polishing complete, as in floors, laid over and including 20mm thick screed bed in cement mortar 1:6 including demolition of old stone slabs complete all as specified and as directed.

M & L for Kota stone slabs, machine cut 20 to 25mm thick, in riser of steps, skirting, dado and pillar, laid over and including 10mm thick backing coat in cement mortar 1:4 including taking down cement plaster complete all as specified and directed.

Dismantling for stone slabs and tiles of any description or thickness in floors, apron etc all as specified and directed by Engr-in-Charge

M&L for 75mm thick cement concrete type D-2 (1:4:8) using 40mm graded aggregate as in sub base floor complete all as specified and directed

Providing and laying 60 mm thick factory made chamfered edge cement concrete coloured interlocking paver block of M-35 grade with approved colour, design & pattern as in footpath, parks, lawn, drive ways or light traffic parking etc, of required laid over and including 50 mm thick compacted bed of fine sand, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed.

M&L for coloured chequered cement concrete tiles 30cm x 30cm x 25mm thick with grey cement and pigment over and including 15 mm screed bed in CM 1:6 set & jointed in neat cement slurry all as specified and directed.

Demolition of reinforced cement concrete of any description and in any position complete all as specified and directed

M&L for precast cement concrete 1:2:4, type B-1 using 20 mm graded stone aggregate as in cover slabs and the like, set in cement mortar 1:6 with plain fair faces complete with joints to match all as specified and as directed.

M&L Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with the including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified and directed.

Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed

S&F mild steel in framed work as in gates of angle or other section for portions framed and hung as gates, including pintle hinges, stops, hand-made sliding bolts etc. to be prepared for hanging or sliding complete steel conforming to Fe-410-0 or Fe-310-0 etc complete all as specified and directed

S&F 1.00 mm thick plain, galvanised mild steel sheeting, in steel gates, ridges, hips, valley gutters, drip and straight flashings (length and girth as fixed) with grade of zinc coating 275 complete all as specified and directed.

Excavation in post holes (or similar holes) each n exc 0.5 cum in soft/loose soil getting out complete all as specified and directed.

Dismantling of RCC fencing post or struts of any description/section including taking out embedded , in concrete or natural ground and making good disturbed all as directed.

Dismantling fencing wire mesh, any type complete all as specified and directed

M&L for cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in filling foundations for drain and post holes etc and mass concrete complete all as specified and as directed .

M&L for MS work as in fencing posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc.and similar work complete all as specified and directed

S&F 4mm dia galvanised steel wire 50 x50 mm mesh n.ex 4 Kg per Sqm , made up into mattresses or cages, lapped wired and laid in position including closing after filling complete all as specified and directed.

M&L mild steel bolts machine made 10mm dia of neck hexagonal or square head at one end and screwed the other or screwed both ends each screwed end to be fitted with washers and one hexagonal or square exceeding 5cm but n.exc 10 cm long complete all as specified and directed.

M & L preparation of new steel surfaces of any description over 10 cm in width or girth not otherwise described applying two coat of synthetic enamel paint over one coat of red oxide primer.

Taking down/removing of existing water proofing treatment on roof surfaces and wall surfaces complete, including screed bed, mud phuska etc racking out joints, hacking for key scrubbing down with water etc., and removing rubbish out of MD land all as specified and as directed.

M & L for spreading / brushing neat cement slurry with 3.00 Kg/ Sqm on old concrete surface complete all as specified and directed

M & L PCC type B0 (1:2:4) (using 12.5 mm graded stone aggregate) for padding concrete as on roof, mixed with water proofing compound @ 200 ml per bag of cement complete all as specified and directed. (Note :- Water proofing compound shall be measured and paid separately under relevant items of Sch 'A' given here-in -after)

M&L for screed bed 15 mm thick (average) plaster on concrete surfaces in CM 1:4 on roof, mixed with water proofing compound @ 200 ml/per bag of cement) and finishing the surface even and smooth without using extra cement complete and directed.(Note :- Water proofing compound shall be measured and paid separately under relevant items of Sch 'A' given here-in -after)

M&L water proofing treatment on horizontal or vertical surfaces with provision of oil bound bitumen primer @ 0.50 Kg/ Sqm and providing 3 mm thick, APP modified water proofing membrane weighing not less than 3.50 Kg/Sqm reinforced with non-oven polyester fabric weighing not less than 160 gm /Sqm all as per detailed specifications, sealed with overlaps shall be with torch application complete all as specified and as directed.

Supply only liquid water proofing compound all as specified and directed.

S & F in repairs 18 mm thick 100% Lead free one side plain laminated PVC/WPC sheet of any colour with using sunmica of choice colour on both side for kitchen cabinet shutters, shelves and shutters for cup board or similar use and required bracket etc. The panels shall be fabricated using adhesive and screws where ever required. All edges shall be covered with 2 mm thick edge bending tape or 90 degree edge bent finish as per manufacterer’s instruction and make approved by GE complete all as specified and directed. Note : All fittings and fixtures such as Soft closer, handles, piano hinges etc for shutter shall be included in quoted rated by the contractor.

M& L repair to chajja area n.exc 2 Sqm including dismantling of upward facia,cutting of reinforcement , plaster in CM(1:3) or PCC type B 0(1:2:4) (using 12.5 mm stone aggregate) on top with WPC, benching/haunching,repair to broken plaster with dubbing coat complete all as specified and directed. Note : Bidder shall be considered height of bldgs upto 2nd floor while quoting unit rates by them and wherever scaffolding is necessary shall deemed to be included in quoted rates.

M& L repair to chajja area exc 2 Sqm and n. exc 4 sqm each including dismantling of upward facia,cutting of reinforcement , plaster in CM(1:3) or PCC type B 0(1:2:4) (using 12.5 mm stone aggregate) on top with WPC, benching/haunching,repair to broken plaster with dubbing coat complete all as specified and directed. Note : Bidder shall be considered height of bldgs upto 6 the storey while quoting unit rates by them and wherever scaffolding is necessary shall deemed to be included in quoted rates.

M&L for repairing of damaged portion of mouth at terrace / roof surface of rain water pipe by cleaning and repairing to mouth of RWP by using CM (1:3) with mix with liquid WPC & sealed with 85/25 hot blown grade bitumen complete to make joint of rain water pipe and roof surface fully leak proof complete all as specified and directed Note : Bidder shall be considered height of bldgs upto second floor while quoting unit rates by them and wherever scaffolding is necessary shall deemed to be included in quoted rates.

S&F in repairs Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured)

Restraining & resecuring including making good of Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured)

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out, complete all as specified and directed

Demolition or breaking up drain pipes 600mm internal dia of bore (salt glazed ware AC or reinforced concrete) set in cement mortar including breaking and removal of bedding and haunching complete all as specified and directed

S&F 600 mm internal dia Reinforced concrete pipes, class NP-3, laid and jointed complete with collars complete all as specified and directed

M&L for Concrete bed for 600mm dia Hume/RCC Pipe 1:3:6 Type C-2 using 40mm graded stone aggregate as in drain pipes including packing under, and haunching against the sides of pipes after they are laid and tested; in complete all as specified and directed

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm complete all as specified and directed

Removing excavated material n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point complete all as specified and directed

SHASHI CONTRACTORS

classic contriction co.

kumar Constructions

DHARM ENTERPRISES

M/S SDS Construction Co.