REPAIR/IMPROVEMENT OF PATH, DRAIN, FENCING ETC ALONG CARIAPPA ROAD, HM MARG OF AGE B/R-I UNDER GE (EAST) LUCKNOW

Amount

Demolition of brick or stone/boulder masonry built in cement mortar complete all as specified and directed.

M&L for brick work with modular fly ash bricks, straight or curved on plan exc 6m mean radius in CM 1:6 complete all as specified and directed.

All as per Item No 2 above but except bricks. (Note:- Bricks re-used recd from demolition of above item No 1)

M&L for brick work with fly ash bricks, modular type, straight or curved on plan to any radius in half brick thick walls, built in complete all as specified and directed.

Taking down cement plaster or cement lime plaster on PCC/stone surface/brick surfaces including raking out joints hacking for key scrubbing down with water etc, complete all as specified and directed.

M&L for rendering 15mm thick in cement mortar 1:6 on other than fare face of brick work or concrete surfaces and finishing the surface even & smooth without using extra cement complete all as specified and directed.

M&L for rendering 15mm thick in cement mortar in 1:4 on fare face of brick work or concrete surfaces even and smoothe without using extra cement & with using integral water proofing compound complete all as specified and directed.

M&L for preparation of new plastered surfaces of walls and applying two coat of cement base paint on new surface of wall complete all as specified and directed.

M&L for PCC 1:2:4 type B-1 (using 20 mm graded stone aggeregate) as in bed block, coping etc complete all as specified and directed.

Extra for forming fair finished drain or channel 30cm inner girth in cement concrete using extra cement including form mould mitered or stopped ends complete all as specified and directed.

Excavation in trenches not exc 1.5 m wide and not exc 1.5m depth and getting out in soft/loose soil complete all as specified and directed.

Returning filling in trenches including spreading leveling, watering and well ramming in layer not exc 25 cm thick complete all as specified and directed.

Removing of excavated materials to a distance 1.5km and depositing where directed at a level not exceeding 1.5 M above the starting point complete all as specified and directed.

Excavating in post holes (or similar holes) each not exc 0.5 cum, getting out, and removing surplus soil to a distance n exc 50m and making good surface in soft/loose soil complete all as specified and directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed.

Dismantling fencing wire mesh, any type complete all as specified and directed.

S&F for mild steel work in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc., flat iron fillets (for securing wire mesh etc,.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed .

All as per item No. 17 above but except angle

S&F in repair galvanised 2 strand steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacings and straining and fixing to any type of standard rails straining bolts including securing or type at crossings with and provision of galvanised mild steel wire staples or steel pins, etc complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed.

Supply only chainlink MS galvanised chain link fencing 75x75 mm mesh size complete all as specified and directed.

M&L for cement concrete type C2, 1:3:6 (using 40 mm graded stone aggregate) as in embedding of fencing post etc, complete all as specified and directed.

M&L for preparation of new surface of steel and applying two coat of synthetic enamel paint over one coat of red oxide area over 10cm width or girth complete all as specified and directed.

Demolition of cement concrete (unreinforced) in ground floor and paving not exc 15cm thick above or below ground level complete all as specified and directed.

Dismantling of stone slabs and tiles of any description or thickness in floors, aprons etc complete all as specified and directed.

M&L for cement concrete 1:5:10 type E-2 (using 40 mm graded stone aggregate) as in foudations, filling and mass concrete complete all as specified and directed.

M&L for 100 mm thick PCC 1:2:4 type B2 using 40 mm graded crsued stone aggregate as in PCC hard standing, finish the surfaces even and smooth without using extra cement (in panel necessary form work included) complete all as specified and directed.

Forming contraction (Dummy) joints 65 mm deep x 10 mm wide, filled with sealing compound Grade 'A' complete all as specified and directed.

M&L for 60mm thick machine pressed precast concrete interlocking paver blocks any tiles any size and shape factory casted with grey cement and pigment and conforming to IS 15658-2006 of M-35 Grade and joints filled inclding dismantling of tile complete etc complete all as specified and directed.

M&L for PCC 1:4:8, type D-2 (40mm graded aggregate) as in foundation, sub base under interlocking tiles/chequred tile, etc complete all as specified and directed.

M&L sand filling under floors or in foundations including watering and consolidation complete all as specified and directed.

S&F factory made machine made precast cement concrete curb stone blocks using cement concrete 1:2:4 type B-1 (using 20mm graded stone aggregate) complete all as specified and directed.

M&L chequred cement concrete tiles 20 cm x 20 cm x 25 mm thick set and jointed and pointed in neat cement slurry with grey cement and pigment in floors including 20 mm screed bed in CM 1:6 complete all as specified and directed.

Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided complete all as specified and directed

M&L for TMT bars 10mm dia and over cut to length, bent to shape required including cranking and binding with Mild steel wire (annealed) not less than 0.9mm dia complete all as specified and directed.

All as per Item No 35 above but 6mm to 8mm dia

M&L for precast RCC 1:2:4 type B-1 using 20mm graded stone aggregate as in cover slab, shelves and similar articles set in CM 1:4 complete all as specified and directed. (Note:- Reinforcement shall be measured & paid separately only)

M&L for RCC 1:1.5:3 (Nominal Mix) using 20 mm graded stone agg as in slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and directed

M&L for formwork to soffits of suspended slabs as roof slabs, floor slabs & similar work not exc. 250mm thick on rough finished surface of concrete complete all as specified and directed.

S&F joist channel, angle, or tee sections fixed independely, without connecting plates etc (Cut to ordinary lengths i.e. within 20 mm of length indicated) for cattle trap etc Fe 410 W (Gde- E-250) quality A complete all as specified and directed.

S&F colored Polycarbonate Sheets 6mm thick (multi wall) as in roof covering/ cladding to wall, fixed with self tapping screws including taking down old sheets complete all as specified and directed.

M&L preparation of old /new stone,concrete surfaces of any description not otherwise described over 10cm in width or girth and applying two coat of antifungal paint 100% Acrylic emulsion paint(weather coat) over a coat of wall Putty complete all as specified and directed.

M&L for precast cement concrete louvers and jallies, in PCC 1:2:4 type B0 (12.5 mm graded aggregate) 40 mm thick (measured solid) including all mouldings nut excluding frame and set in CM 1:4 complete all as specified and directed.

S&F concertina coil of reinforced punched (chrome rajor or blade wire) with barbed tap of 0.5 mm thick galvanised steel sheet and core wire of dia 2. 5 mm high tensile steel wire including taking down old concertina coil wire complete all as specified and directed.

S&F pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50 mm thick of an colour having tensile strength of 550 Mpa as in roof covering /cladding to wall, fixed with self tapping screws including taking down old galvalume sheet complete all as specified and directed.

S&F in repair road safety convex mirror made up of polycarbonate reflective and body made of ABS / Fiber / Plastic of size 100 cm dia fixed over & including 40 mm bore MS pipe of 2.4 Metre length duly powder coated embedded in PCC 1:2:4 of size 45 cm x 45 cm x 45 cm and excavation earth work complete all as specified and directed. Make : Road Star Cat No: RSCM-100 / Tata / 3M / Simens / Dark Eye

S&F in repair Modular type speed braker / Rumbler made of sturdy plastic (ABS) material of size 250 x 350 x 50mm fixed in position as per manufacturer instruction complete all as specified and directed. Make Road Star Cat No GP1005 / Tata / 3M / Simens / Dark Eye

Exavating in post holes (or similar holes) soft/loose soil each not exc 0.5 cum getting out, returning filling in and ramming earth in layers not exc 25 cm watering and removing surplus spoil to a distance not exc 50 m and making good surface complete all as specified and directed.

M&L cement concrete (1:3:6) type C-2 (using 40 mm graded stone aggregate) as in foudation filling and moss concrete complete all as specified and directed.

S&F Stainless steel pipe any dia GRDE304 framed work such as of pipes angles tees, flat incl gusset plates etc and welding and or riverting and similar work complete all as specified and directed.

S&F for 3 mm thick ACP sheet of any colour/shade as approved and one side covered with 3 M retro-reflective sheet & pasting computerized size of letter of retro reflective sheet not exc 30 cm in height including stop commas, short line dashes, hypens brackets etc as directed and pasted with approved adhesive as in sign bound cut to size and fixed to stainless steel frame including all necessary fitting arrangement complete all as specified and directed. ( Note:- Nothing extra paid for writing.)

S&F metal tubular dealineator made out of ABS round body fitted with 2 Nos 65 mm dia highly reflective reflectors made out of PMMA and mounted on 45/50 mm dia mild steel pipe of 600 mm height duly powder coated and thermoplastic elastomer 3 bands of green, red and yellow reflector raduim tape of 25 mm wide strips with anti theft steel net for reflector protection including embedding in PCC 1:2:4 (150 x150x300 mm) type B1 complete all as specifed and directed.

S&F solar cat eye aluminum alloy shall (100% water proofing design according to 65) of size 125 mm x125mmx25 mm (shank 65 mm ) of high efficieny Mono rystafie solar panel 2.4V/0.3 watt one NI-ed rechargebatyery (1.2V/1600 MA) consisting as per manufacturer's instruction etc. all as spefied and directed.

M/S SWATI CONSTRUCTION

QUALITY CONSTRUCTIONS CO

M/S S S A ASSOCIATES

ANIL CONSTRUCTION

M/s Bhadoria Associates

Gaurav Enterprises

M/s Rathore Traders

KUMAR ENTERPRISES

abhinish traders

M/S Reliance Construction

Yadav Builders

M/s Arora Trading Co

Abode Artisan Enterprises