CERTAIN REPAIR TO FENCING DRAIN PATH ETC AT OTM ACCN UNDER AGE B R II OF GE BENGDUBI MIL STN

Amount

SCHEDULE 'A'

Dismantling posts or struts embedded in concrete, brick work, masonry, etc (Wood, steel or RCC) any section, including taking out embedded protion and making good disturbed ground complete all as specified and directed.

Dismantling posts or struts embedded in natural ground etc. (Wood, steel or RCC) any section, including taking out embedded protion and making good disturbed ground complete all as specified and directed.

Dismantling of fencing any type all as directed.

Excavating in post holes (Or similar) each n exc 0.5 Cum getting out returning fillin in and ramming earth or broken rubble mixed with earth around, in layers n exc 25 cm watering and removing surplus soil to a distance n.exc 50 m and making good complete all as specified and directed.

M&L for Cement concrete Type C2 1:3:6 (40mm graded stone aggregrate) in foundations, filling and mass concrete complete all as specified and directed.

M&L for Steel work in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

Supply and fixing chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed. (Note:- Line wire shall be measured and paid seperately "Supply only" rates)

Supply only mild steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends Fe 290 (Gde E-165) complete all as specified and directed.

M&L for two coats of synthetic enamel paint over one coat of red oxide on new steel surfaces of any description over 10cm in width or girth including preparation of surfaces complete all as specified and directed.

Mild for steel screw bolts(machine made) 10mm dia with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n exc 5cm long complete all as specified and directed.

Surface excavation n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out in soft/loose soil complete all as specified.

Excavation in trenches not exc 1.5 mtr wide and not exceeding 1.5 mtr deep for laying of cables, pipes foundation of polesstays/pipes etc. not exc 10 sqm area on plan and getting out in soft/loose soil complete all as specified and directed.

Returning, filling in excavated soil in trenches including spreading, levelling, watering and well ramming in layers n.exc 25 cm thick in complete all as specified and directed.

Removing excavated material (soil) to a distance exc 50m and depositing where directed at a level not exc. 1.5 m above the starting point complete all as specified and directed.

M&L hardcore of broken stone or boulders gauge n.exc 63 mm, deposited, spread & levelled in layers n.exc 15 cm thick, watered & rammed to a true surface complete all as specified & directed.

Demolition cement concrete (unreinforced) of any description and in any position not otherwise specifically provided for all as specified and directed.

M&L for 100mm thick PCC 1:3:6 type C-2 using 40mm graded crushed stone aggregate as in subbase of floor complete all as specified and directed.

M&L for 75mm thick cement concrete 1:3:6 type C-2 (using 40mm graded crushed stone aggregate) as in floor, subbase, plinth protection finished fair & even without using extra cement complete all as specified and directed.

M&L for 50mm thick cement concrete 1:2:4 type B-1 (using 20mm graded crushed stone aggregate) as in floor, subbase, plinth complete all as specified and directed.

Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified and directed.

Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified and directed.

Dismantling stone slabs and tiles of any description or thickness in floors, approaches, dado/partion aprons, etc. laid, bedded and pointed in any mortar complete all as specified and directed.

M&L for exterior grade, coloured glossy finish rubber pressed, cement concrete designer chequered tiles of size 30cm x 30cm x 25mm thick set, jointed and pointed in neat cement slurry with grey cement and pigment to match the shade / colour / matrix of tiles as in floor etc. complete including provision of 20mm screed in CM 1:6, complete all as specified and directed.

M&L for PCC 1:2:4 type B-1 using 20mm graded crushed stone aggregate in lintel upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, kneelers, apex stones, bed plates, water troughs, fixing of hold fast and the like including weathering, slightly rounded or chamfered angles and throating, as directed including formwork if required complete all as specified.

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5mm), including making drainage opening wherever required complete all as specified and directed.

Demolition of brick work or rubbled stone masonry including all quoins arches, pillars etc built in cement mortar and including removal from the site complete all as specified and directed.

M&L for brick work with fly ash brick, straight or curved on plan exc 6.0 mtr mean radius built in CM 1:6 etc complete all as specified and directed.

M&L for brick work with fly ash Bricks straight or curved on plan in CM 1:4 as in half brick thick walls complete all as specified and directed.

M&L for brick work with subclass 'B' Bricks, straight or curved on plan exc 6.0 mtr mean radius built in CM 1:6 etc complete all as specified and directed.

Taking down cement plaster on brick or stone walls, etc. including raking out joints, hacking for key, scrubbing down with water, etc and including removal of debris and rubbish from the site etc complete all as specified and directed.

M&L for Rendering 15 mm thick on other than fair faces of brick work or concrete surface in cement mortar (1:6) surface finished even & smooth without using extra cement complete all as specified and directed.

M&L for Rendering 15mm thick on fair faces of brick or concrete surfaces in cement mortar 1:4 with water proofing compund as per manufacurer's instructions, finished surfaces fair and smooth without using extra cement complete all as specified and directed. (Note: - WPC shall be measured and paid separately under relevent items.)

Supply only water proofing compound (Liquid) complete all as specified and as directed.

M&L for preparing newely plastered surface of wall and applying two coat of cement base paint any tnt over a coat of cement primer etc complete all as specified and directed.

Demucking of filled soil in drains of any size depth or section in any condition as per site requirement and spreading along road side berms complete all as specified and directed.

M&L for Rendering 15 mm thick on other than fair faces of brick work or concrete surface of drain in cement mortar (1:4) surface finished even & smooth without using extra cement complete all as specified and directed.

M&L for Plain cement concrete 1:3:6, type C-1 (Using 20mm graded crushed stone aggregates) as in surface channel and drain complete all as specified and directed.

M&L for providing precast cement concrete 1:2:4 type B-1 using 12.5mm graded crushed stone aggregate in louvres and jallies, 35mm thick (measured solid), including all mouldings complete all as specified and directed.

M&L for extra for forming fair finished drain or channel 30 cm inner girth of cement concrete using extra cement including forms moulds, mitred/ stopped ends etc.

Ditto all as item no. 39.00 here-in-above but Add or deduct for each 25 mm girth or part thereof over or under 30cm

(Note : The Scope of Work contained in 'Sch of Credit' amounting to Rs. 74945.00 (refer Tender Srl Page No 30). The Quoted sum shall be arrived at after deducting the amount of “Sch of Credit” from the total amount of the ‘BoQ’

MUKHERJEE ENTERPRISE

M/S P. RAI CHOUDHURY AND CO.

Amulya ky roy

M/S BOSE ENTERPRISE

Paritosh Saha

SHRI S K BHATTACHARJEE

ENGINEERING AND CONSTRUCTION CO.