Restoration of rain damages to various JJM schemes under Jal Shakti Sub Division Kumarsain in Tehsil Kumarsain Distt. Shimla HP SH CO RCC wall PCC wall wire create to protect the source prov. and installation of additional pump in LWSS Pharal Khad to

Amount

Cutting in earth work and disposal of excavated earth upto a lead of 20 mtrs. In pick and jumper work

Excavation in foundation and trenches etc in earthwork lift upto 1.5 m, stacking the excavated soil not more than 3 m clear from the edge of the excavation and then returning the stacked soil in 15 cm layers when required into plinth sides of foundation etc., consolidating each deposited layer by ramming and watering and then disposing off all surplus excavated earth as directed within a lead of 20 m in pick and jumper work and soring/strutting timbering and dewatering where ever required to the entire satisafaction of the Engineer-in-Charge.

Providing and laying CC 1:6:12(1 cement 6 sand 12 graded stone aggregate 40 mm nominal size) and curing complete excluding cost of form work in foundation and plinth.

Providing and laying cement concrete 1:2:4 ( 1cement 2 sand 4graded staggregate 20 mm nominal size )and curing complete excluding cost of form work and reinforcement in-

Foundations, footings base of column and the like and mass concrete plinth.

Wall (any thickness but not less than 0.1 m thickness) attached pillasters, buttresses, plinth and string courses etc from top of foundation level upto floor two level

Providing and laying cement concrete 1:5:10(1cement:5sand: 10 graded stone agg. 40mm nominal size) with 15% plum concrete and curing complete excluding cost of form work in retaining wall/ breast wall, the size of plums shall usually be 150mm to 300mm as per HPPWD/JSV specifications within all leads and as per the direction of the Engineer-in-charge.

Providing form work with steel plates 3.15 mm thick welded with angle iron in frames 30 x30 x 5 mm so as to give a fair finish i/c centring, shuttering, strutting & propping etc. with wooden battens & ballies, height of propping & centring below supporting floor to ceiling not exceeding 4 mts. & removal of the same for in situ-reinforced concrete & plain concrete work in Vertical surfaces such as walls (any thick.) partitions & the like i/c attached pillasters, buttresses. plinth & string courses & the like

Vertical surface such as walls (any thickness) partitions and the like including attached pillasters butteresses, plinth and string courses and the like

Providing tor steel reinforcement for RCC work including bending. binding and placing in position complete up to floor two level.

Wire crates made of G.I. wire filled with boulders with square cut faces against the wire (Boulder filling to be measuredand paid for separately) Gl wire 5mm thick corresponding to SWG-6(15cm.x 15cm. Mesh) within all leads and lifts andas directed by the Engineer-in-charge.

Wire crate of G.I. wire filles with boulders with square cut faces against the wire (Wire crates to be measured and paid for separately) within all leads and lifts and as directed by the Engineer-in-charge.

Provd. & fixing of Three Phase Fully Automatic ATS Star Delta Starter for 125 bHP Motor, current 415 Volts, Frequency 50Hz, Load 250 Amp,in sheet- steel enclosure as specified in IS: 8544. of reputed Make either L&T or equilent and to the entire satisfaction of Engineer-in-Charge.

Prov. & fixing of Pump Gland Cup of reputed Make and to the entire satisfaction of Engineer-in-Charge.

Providing and fixing double flanged 80mm dia Cast steel NRV (Leader make) as per ISI mark (ASA- 600) complete in all respect as per direction of Engineer in charge.

Providing and fixing double flanged 80mm dia Cast steel Sluice valve (Leader make) as per ISI mark (ASA-600) complete in all respect as per direction of Engineer in charge.

Providing and fixing Cast Iron Sluice Valve 100 mm dia PN-1.0

Providing and fixing Cast Iron Sluice Valve 150 mm dia PN-1.0

Excavation in earth work and disposal of all excavated earth upto a lead of 20 mtrs. (twenty metres) and lift upto 1.50 mtrs. (one point fifty metres) disposing earth to be leveled and neatly dressed pick jumper work within all leads and lifts as directed by the Engineer-in-charge.

Providing horizontal spindle horizontal split casing end suction (back full out arrengements) single double/multistage centrifugal pump combination of pump in series of recommended make such as Mather and Platt/KSB/Kirlosker as per BIS 1520-1980 with upn do date ammendements, read with IS 9137-1978 or latest eddition suitable for lifting clear water for under mentioned characteristics with bronze impelers/priming funnels, casing ring and shaft sleeves of bronzes, shaft of steeln grade EN-8 withy cast iron casing coupled directly through a flexible coupling on a MS/ Cast steel base plate. (1 set of 150 HP) total head 606 mtrs Dia of Rising Main 125 mm Length of Rising Main\ 2330 rmt Discharge 30.64 m3/h Speed 2970 RPM

Laying and Jointing in trenches galvanised mild steel tube (light Grade) (Earth work to be measured and paid foe seperatly).

15 mm dia

20 mm dia

25 mm dia

32 mm dia

40 mm dia

50 mm dia

Providing and Fixing brass full way valve with wheel.

32 mm dia

40 mm dia

50 mm dia

Kuldeep Kumar Thakur

P B Thapa

Surjeet Singh Thakur

M/S THAKUR ELECTRICAL & HARDWARE STORE

Raman Thakur Govt. Cont.