CA No CWE/SGNR/TOKEN/14 OF 2022-23 REPAIRS OF POT HOLES,INTERLOCKING PATHWAY,ROAD SIDE FURNITURE AND RESURFACING OF CERTAIN ROADS AT MIL STN ABOHAR

Amount

M & L for repair to pot holes any depth n.exc 1.00 sqm each, sweeping free from dust and mud or water, scoring sunken surfaces in road, path etc. cutting around edges to at least 25mm in depth, making good by applying a tack coat @ 05 Kg per ten sqm putting in premixed bituminous macadam well rammed and sealed with binder 9.8 kg per ten sqm, blended with 0.09cum of chippings, 63mm size and again well rammed, depth of pot holes exc. 30mm complete all as specified and directed by Engineer-in-Charge.

Preparing existing black top surfaces by brushing with wire brushes for removing caked mud etc, sweeping with brooms and finally fanning the cleaned surfaces with gunny bags to remove all loose dirt etc complete all as specified and directed by Engineer-in-Charge.

M & L 30mm thick (consolidated thickness) bituminous premixed semi dence asphaltic concrete with 5.5% binder content by weight of total mix laid with self propelling mechanical paver, rolled and compacted to required camber and gradient with power roller using paving bitumen over and including a tack coat of bitumen primer @ 5 kg/10 sqm to existing black top surfaces complete all as specified and directed by Engineer-in-Charge.

M & L for Painting of lines, dashes, arrows, letters etc. on road / pavement and the like using thermoplastic paint for a dry 2.5 mm thick @ 5 Kg per Sqm ,Binder contents 18.0% min, glass 30-40% ,Titanium dioxide 10.0% min. , CaCos and inert fillers 42.0 max , including preparation of old / new surface complete all as directed by Engineer-in-Charge. Make : Shivalic/Relaince /Swastic.

Demolition of un-reinforced cement concrete in ground floor and paving not exceeding 15 cm thick (below or above ground level) complete all as directed by Engineer-in-Charge.

M&L for 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed by Engineer-in-Charge.

M & L for providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line,level and curvature ,jointed with cement mortar 1:3(1 cement:3 Coarse sand) including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5mm)including making drainage opening wherever required complete all as specified & directed by Eng-in-charge.

M & L for PCC 1:2:4 type B1 (using 20mm graded stone aggregate )as in kerbs or mud stops ,rounded or chamfered on edges and similar work all as specified and directed by Eng-in-Charge.

M&L fro preparation of new concrete surfaces of any description not otherwise described over 10cm width or grith and applying two coat of synthetic enamel paint over a coat of primer complete all as directed by Engineer-in-Charge.

S & F in replacement of convex mirror 1000mm made of PC material provided with suitable MS pipe post,duly powder coated, meant for road turning,intersections, curves,T junctions,hospitals,parking lots etc with clear and definite mirror image having 130 degree of viewing angles,unbreakable and stronger than glass,spring post(710x80x210mm) body of spring is made of special flexible material(polyurethane) without it can be quickly resorted to its originalstate without doing any damage to spring post as well as vehicle in case of high speed collisionfix the spring post with road surface the bond is so strong that post will not be deviated by strong impact after installation of spring post 710mm upper dia 80mm & bottom dia is 210 mm complete all as specifed and directed by engr-in-charge. MAKE:- Cat No OS-791 of OSCAR safely solution or techno equivalent in grrenlite/TATA BP/ SinorInfrastructre. ---------------------------------------------------------------------------------------------------- Note : A sum of Rs. 600.00 will be deducted on account of credit for taken down material. Please refer details on Srl Page No.17 (Schedule of Credit) of Tender documents.

M/s Amit Construction Company

POOJA CONSTRUCTION COMPANY