Upgradation of SHC into HWC way of Special Repair of 7 Nos. Sub Health Centers under Provincial Sub Division, Ladwa in Distt. Kuruskhetra (Under Health Wellness Scheeme) (Villages Bhagwanpur, Bir Mathana, Brot, Chhapra, Gadli, Mehra And Sirsama)

Amount

Scraping cement plaster (HSR-8.32 (C)

White wash and colour wash (HSR-8.32(a)

Distempering with washable oil bound distemper (of approved manufacture) two coats on old distempered work.(HSR-16.60)

Providing two coats of exterior acrylic emulsion paint.(b) 1st Quality (HSR-16.79) (b)

Painting two coats excluding primary coat with synthetic enamel paint in all shades on new wood work in metallic of plaster or concrete surfaces as give on even shades (1st quality paint) qty. (HSR 16.3)

12m thick cement plaster 1:4. (HSR 15.5)

Providing and fixing 1st quality ceramic glazed wall tiles confirming to I.S 15622 (thickness to be specified by the manufacture) of approved make in all colors, shades except burgundy, bottle green black of any size as approved by Engineer-in-charge in skirting, risers of steps and dados over 12mm thic bed of cement mortar 1:3 coarse and jointed with grey cement slurry, including pointing in white cement mixed with pigment of matching shades complete.b) Size of ceramic glazed tiles 300mm X 450mm (HSR 14.92 b)

Providing and fixing ceramic tiles/ anti skid tiles of size of size 400mm x 400mm or above size of approved make in floors, laid in any pattern as specified over base of 20mm thic cement coarse sand mortar 1:3 and jointed with white cement slurry mixed with pigment to match the shade of tiles. NOTE:- Tile shall be of premium quality(first qualit) of reputed manufacturer like NITCO, KAJARIA & RAK. . (HSR 14.91)

Providing and fixing Vitrified tiles of size 600x600mm of approved make in skirting /dado laid in any pattern as specified over base of 12mm thick cement coarse sand mortar 1:3 and jointed with white cement slurry mixed with pigment to matyh the shade to tiles. NOTE:- Tile shall be of premium quality(first qualit) of reputed manufacturer like NITCO, KAJARIA & RAK. . (HSR 14.90)

Factory manufactured solid flush door shutters, with block board core as per I.S.No.1659-1969 bonded with water proof type phenol formaldehyde synthetic resin,hot- pressesd, conforming to I.S.2202 part I and II, fixed in position, including iron hinges, screws, chocks/cleats and stops etc.(excluding the cost of any fittings other than specified above, but including labour for fixing the same in position)- (a) commercial veneering with vertical grains or cross bands and face veneer on both sides commercial facing with laminated core and lipped edges.) (i) 25 mm thick. HSR 17.93 (a) (i)

Preparation of Ply wood Surface for Painting i/c Sand papering the surface and applying grilling with approved quality filter consisting of White lead, linsed oil, warnish and chalk mitti including finishing the surface to required finish Complete. (HSR 16.1)

Dismantling Brick Work, Tile Masonry or Tile Lining and Tile Terracing in cement HSR 8.5. (b) in cement

First class brickwork laid in cement sand mortar 1:4 in first storey upto 4 meters above plinth level. HSR-11.9

PROVIDING AND FIXING IN POSITION BEST INDIAN MAKE (to the approval of the Engineer-in-charge) EUROPEAN TYPE WATER CLOSET SUIT WITH NON- CONCEALED ‘P’ OR ‘S’ TRAP with or without vent and all other necessary fittings as fully described in item no.30.3 above. (i) White (HSR-30.4)

Providing and fixing in position 15mm i/d C.P. brass bib cocks of best quality (as required by the engineer-in -charge). HSR 30.75 ( C) Bib cock

EXTRA OVER Item nos. 30.1 to 30.4 and 30.6 FOR PROVIDING AND FIXING 15LITRES CAPACITY LOW LEVEL VITREOUS CHINA WARECISTERN complete with flush bend all other necessary fittings instead of C.I. high level cistern complete with fittings. White HSR (30.12) (i)

Providing and fixing in position 15mm i/d C.P. brass bib cocks of best quality (as required by the engineer-in-charge). Bib cock long body HSR 30.75 (a)

PROVIDING AND FIXING POSITION BEST INDIAN MAKE FLAT BACK OR ANGULAR LIPPED FRONT URINAL 465 MM HIGH CONSISTING OF : -(i) Flat back lipped or angular urinal basin of VITREOUS CHINA WARE (to the approval of the Engineer-in-charge). HSR 30.19 (i)

Dismantling cement conglomerate / terrazzo floors 25 mm to 50 mm thick including concrete base(HSR-8.25)

Pdg. and applying two coats white cement based putty over plastered surface and grinding the surface smooth with sand piper to get an even and smooth finish including cost & carriage of all material labour charges, scaffholiding sundries etc. complete (J.K/Birla make) (HSR 16.81)

Wrought iron & mild steel (using angles, flats,square bars, tees & channels) ladders, grills,gratting frames, window guards, iron doors openable or fixed stair case or parapet or any other type of railing, gates & tree guards etc., including cost of screws & welding rods or bolts & nuts complete fixed in position (HSR 18.12)

Cement concrete 1:1.1/2:3 with stone aggregate 20 mm nominal size for reinforced concrete work in slabs with inclination not exceeding 25 degree with horizontal, excluding steel reinforcement, but including centring and shuttering, laid in position complete in all respects. (HSR-10.82+10.95(a) )

Providing and laying granular sub base consisting of filter layer confirming to Table 400.1 Grading –III of MoRT&H 5th edition, mixing in a mechanical mix plant at OMC, carriage of mix material to the site of work, spreading in uniform layer with motor grader on prepared surface and compacting with vibratory power roller to achieve desired density complete as per clause No. 401 of MoRT&H specifications.

Providing and laying 80mm thick interlocking paver blocks of all shapes and colours in design mix cement M-35 over a bed of 30mm thick fine sand complete in all respect.HSR 10.159

Dismantling Brick Work, Tile Masonry or Tile Lining and Tile Terracing in mud. HSR 8.5 (d).

Terracing consisting of tiles 22.86 cm X 11.43 cm X 3.81 cm laid over 87.50 mm mud filling on a layer of 25 mm mud plaster and on other layer of mud mortar for laying the tiles, including two coasts of bitumen laid hot at 1.65 Kg per sqm on top of R.C.C. slab including grouting with cement sand mortar 1:3 and top surface to be left clean etc.(HSR 13.13).

Earth work in excavation in foundations, trenches, etc.in all kinds of soils, not exceeding 2 metres depth including dressing of bottom and sides of trenches, stacking the excavated soil, clear from the edge of excavation and subsequent filling around masonry, in 15 cm layers with compaction, including disposal of all surplus soil, as directed within a lead of 30 metres. HSR 6.6.

Fe-500 E.Q.R. TMT Steel bars for R.C.C. works, where not included in the complete rate of R.C.C. including bending, binding and placing in position complete..(HSR 18.22)

Pressed steel sheet frames (chowkats), consisting of 2 mm thick steel sheet of the specified section, including iron lugs (hold fasts), iron hinges, conforming to P.W.D. specifications, including bolts for fixing stops, lock notch, provision for receiving tower bolts, and finished with one coat of ready-mixed paint red lead non-setting primer, of approved quality, fixed in position including the cost of cement concrete 1:3:6 for filling in the frame, and cement concrete 1:3:6 for lugs complete:door and window frame size 127 mm X 50 mm with 40 mm wide double rebate -(HSR 18.34) (c)

Factory manufactured panelled door or glazed window, shutters of commercial hard wood, such as hollock, champ,chikrassy and chaplash,etc.,(non-coniferous timber other than teak,conforming to I.S.specification No.1003,kiln-seasoned),with 100 mm wide verticle styles, 150 mm wide lock rail, 200 mm wide bottom rail and 100 mm wide other rails, with panels of 15 mm thick, tongued and grooved of commercial hard wood and including cost of iron hinges,screws,chocks/cleats,stops,nails etc., complete,fixed in position (excluding the cost of any fittings,other than specified above,but including labour for fixing the same in position).HSR-17.90

Factory manufactured wire gauze door and window shutters of commercial hard wood such as hollock, champ, chikrassy and chaplash,etc.,(non-coniferous timber other teak, conforming to I.S.specification No.1003, kiln-seasoned),with 100 mm wide vertical styles, 150 mm wide lock rail, 200 mm wide bottom rail, and wire gauze of 140G or 120G designation including cost of iron hinges, screws,chocks/cleats,stops nail etc.,complete fixed in position (excluding the cost of any fitings,other than specified above,but including labour for fixing the same in position)-(style and rails of windows shutter shall be 75 mm wide).(HSR 17.92b).

Providing and fixing HDPE water storage tanks of Sintex, Diplast, O.K. make with covers/lids marked with IS: 12701 on roof top of buildings including cost of hoisting and placing in position, making connections with inlet and outlet pipes, providing overflow & scour provisions with suitable plug on scour pipe including cost of nipples, washers, flanges for connections in tanks complete in all respects to the satisfaction of Engineer-in- Charge. (except civil work). 1000 ltr. capacity HSR 30.119 (c)

Providing and fixing GI pipes complete with GI fittings and clamps, i/c cutting and making good the walls etc. (DSR 18.10) 15mm I/d

Providing & fixing G.I Pipes complete with G.I fittings and clamps, i/c making good the walls etc. concealed pipe, including painting with anti corrosive bitumastic paint, cutting and making good the wall: (DSR 18.11) (i) 15 mm internal diameter of pipeline

(ii) 20 mm internal diameter of pipeline

Recovery items: The rates quoted against recovery items will not be included in the total amount rather it will be deducted while calculating financial statement of the agency. Material obtained from dismantling of existing brick work, has been calculated taking assumption that 80% of theoretical material will be retrieved. The dismantled material can used in any of the item for the work after modification (bringing it to required specifications) after approval from employer. In case it is not possible to use this material on the work, the agency can take away this material. This material can be taken away by the agency at the price quoted by the agency but minimum price to be quoted is limited to reserve price as fixed and mentioned as under :- Good Bricks @ Rs. 4.00/- per each

Brick Bats @ Rs. 500/- per cum

Note: In case of any difference in the unit & nomenclature of any of the HSR items depicted in this DNIT and that given in HSR, the unit and nomenclature given in HSR shall be applicable.